REPAIRS TO FENCING, GATES INCLUDING THEIR PERIODICAL SERVICES AT CME UNDER GE (CME) KHADKI

Amount

Demolition of Brick work or stone / boulder / block masonery built in cement mortar, including coping etc complete all as specified incl coping.

M & L for pre cast PCC block mosonary Type C-1 1:3:6 exc 10 cm width and set in CM 1:4 all as specified

Demolition of cement concrete (un re-inforced) in ground floor and paving n.exc. 15 cm thick below or above ground level complete all as specified .

M&L cement concrete type D-2, 1:4:8(using 40mm graded stone aggregate) as in foundation , filling and mass concrete complete all as specified and directed.

M&L 15mm thick cement plastering on concrete surfaces in CM (1:4) finishing surfaces even and smooth without using extra cement complete all as specified and as directed.

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion/in concrete,brick work,masonary etc.and making good disturbed ground etc. Complete all as specified and as directed.

Dismantling fencing wire mesh, any type

S&F For ms angle as in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 etc. complete all as specified and as directed.

Supply onlyChain link MS galvanisd fencing, any size or type etc. Complete all as specified and as directed by Engr - in - charge

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire etc. Complete all as specified and as directed.

S & F For 5 to 10 mm dia. of neck ,mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long etc. Complete

Demolition reinforced cement Concrete of any description and in any position not otherwise specifically provided for

M&L for Reinforced cement concrete (nominal mix)Type B1 1:2:4, using 20mm graded stone aggreagate as in footing, columns etc complete

Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter for flat surface etc. Complete all as specified and directed.

S&F For mild steel TMT bars 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders , cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips etc. complete all as specified and as directed.

S&F For mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips etc. complete all as specified and as directed.

S & F For in repair galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) etc. complete all as specified and as directed.

Preparation of new or previously untreated surfaces of steel of any description over 10 cm in width or girth and applying two coats of synthetic enamel paint over and including a of red oxide primer complete all as specified and directed

Preparation of old surfaces of steel of any description over 10 cm in width or girth and applying two coats of synthetic enamel paint over and including a of red oxide primer complete all as specified and directed

Dismantling structural steel work including doors, gates but excluding framed truss etc. Complete.

S & F For framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing of grade Fe 410-W,E - 250 Quality 'A' etc. complete all as specified and as directed.

vishalconstruction (BID ID -3104669)

Mukund Engineers and Contractors (BID ID -3110262)

Priyanka Power line (BID ID -3104610)