Strengthening of base frame, realignment of crusher roller motor (160KW) with Gear box (SBN315) and platform construction near drive and LT pannel on both side of ATLAS COPCO make feeder breaker (Local Sl.No.02) installed at Tarmi siding under SDOCM

Amount

A. Base strengthening and realignment of crusher roll motor (160KW) with gear box (SBN 315).

Cutting of Seized base bolt, 24 X 150mm with nut and washer.3.14 x 1” x 6 nos. x 02 times

Cutting of old and damaged base structure of motor and gear box set. A.) 85” x 4 nos. x 02 times B.) 48” x 02 side x 02 times C.) 82” x 6 nos. x 02 times D.) 4” x 02 side x 06 Nos.

New M.S Plate (16mm/12mm) cutting for above work and Rib cutting. a.) (50” +30”) x 02 sides x 02 nos. b.) (50” + 12”) x 02 sides x 02 nos. c.) (86” +12”) x 02 sides x 02 nos. d.) 34” x 12 nos.

Motor (90KW) and gear box shifting to non-working Zone, extra scrap removal from working zone, new material shifting, grinding work for smooth marking, then fitting of all plates with proper levelling, motor and gear-box shifting to working zone, Re-alignment work. a.) 04 fitter x 04 shift b) 10 Helper x 04 Shift

Hole making for base bolt (30mm) 3.14 x 1.25” x 10 Nos.

Multilayer welding work after fixing and fitting of plates then Rib welding work. a.) (50” +30”) x 02 sides x 02 nos. x 02 layer b.) (50” + 12”) x 02 sides x 02 nos. x 02 layer c.) (86” +12”) x 02 sides x 02 nos. x 02 layer d.) 20” x 12 nos. x 2 layer.

‘V’ Cutting work near damaged and cracked portion. a.) 36” x 08 nos. x 02 times. b.) 14” x 8 nos. x 02 times.

Multilayer welding work for above damaged and cracked portion. a.) 36” x 08 nos. x 03 layer. b.) 14 x 08 nos. x 03layer.

M.S Plate (20mm) Cutting for providing Stopper of Motor and gear-box and welding work. a.) 12” x 12 Nos b.) 3” x 12 nos. x 03-layer

B. Platform making for safe working near L.T panel and Discharge end both sides.

Steel material cutting work. a.) M.S channel (100 x 50 mm), 16” x 12nos. b.) M.S Angle (75 x 75 x 6) mm, 12” x 12Nos. c.) M.S Plate (3mm), (74” + 24”) x 2 sides x 02 Nos. d.) M.S Angle (50x 50 x 6 mm), 8” x 14 nos.

Welding of above work. a.) M.S channel to post, 24” x 12nos. b.) M.S Angle to M.S channel,12” x 08 Nos. c.) M.S Angle to M.S Plate (74” + 24”) x 2 sides x 02 Nos. d.) M.S Angle (50x 50 x 6 mm) for hand railing, 8” x 14 nos.

Total impact of GST for the purpose of CTC

M. N. ELECTRICAL AND ENGINEERING WORKS

ZED ENTERPRISES