PROVN OF ANTENNA PLATFORM FOR INSTALLATION OF RF ANTENNA AT 8 FBSU AF STN AWANTIPUR

Amount

Excavation in trenches n.exc. 1.5m wide and n.exc 1.50 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n.exc. 10 Sqm on plan and n.exc 1.5 m in depth and getting out in getting out in any type of soil, complete all as specified and directed.

Removing excavated materials n.exc 50 m and depositing where directed at a level n.exc 1.5 m above the starting point, complete all as specified and directed.

M&L for PCC 1:4:8 type D2 using 40mm graded stone aggregate in foundation, filling & mass concrete, complete all as specified and directed.

Reinforced cement concrete design mix M-30 (using 20 mm graded stone aggregates) in foundations, footing, plinth beams, bases for columns and mass concrete, complete all as specified and directed. (Reinforcement to be measured separately).

Reinforced cement concrete design mix M-30 (using 20 mm graded stone aggregates) in columns, pillars, posts & struts, complete all as specified and directed. (Reinforcement to be measured separately).

M&L for reinforced cement concrete (design mix) M-30 using 20mm graded stone aggregrate in beams, cantilevers, bressummers, lintels over 1.5m span, complete all as specified and directed. Note : Reinforcement shall be measured and paid seperately.

M&L for reinforced cement concrete (design mix) M-30 using 20mm graded stone aggregrate in slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like, complete all as specified and directed. Note : Reinforcement shall be measured and paid seperately.

M&L for formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter rough finish surface of concrete flat, complete all as specified and directed.

M&L for formwork to sides of pillars, columns etc; rough finish surface of concrete square, rectangular or polygonal all as specified and directed.

S&F for TMT bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.

5mm dia and over upto and including 10mm dia in stirrups, spacers and binders, complete all as specified and directed.

M&L for PCC 100 mm thick 1:2:4 type B2 ( using 40 mm graded crushed stone aggregates)as in hardstanding finished even and smooth without using extra cement laid in altenate panels, complete all specified and directed.

M&L Brick work with sub class B bricks, straight or curved on plan exc 6m mean radius built in CM 1:6, complete all as specified and directed.

M&L for rendering 10 mm thick on fair faces of concrete/brick interior surfaces in cement mortar 1:4 as per manufacturer's instruction, finished fair and even without using extra cement, complete all as specified and directed.

Supply only Liquid water proofing compound, complete all as specified and directed.

M&L for preparation of newly plastered wall surface make the surface smooth by rubbing with sand papers and priming plastered and other surfaces with alkali resistant priming paint over a two coat of cement paint, complete all as specified and directed.

S&F stairs (framed) including stringers, treades, landing, balusters, hand rails etc. including cleats, brackets, etc. of Fe-290 (grade E-165), complete all as specified and directed.

Preparation of new or previously untreated steel surfaces of any description not otherwise described over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer, complete all as specified and directed.

M/S ABBAS M. ENTERPRISES (BID ID -3168199)

MS Ghulam Hassan and Sons (BID ID -3167715)

M/S GEE EMM MIR (BID ID -3170728)