AIC/AED/NIeT-109/26-27

Module-75 WP ( ERTL and Flash Tested) The PV module shall Mono Crystalline silicon solar cells /Mono Perc (Exide/Luminous/UTS etc. and must have a certificate of testing conforming to IEC 61215 Edition II. II. The power output of the module(s) under STC would be a minimum of 80 Wp at a load voltage* of 16.4 ± 0.2 V III. The open circuit voltage* of the PV modules under STC would be 21.0 Volts IV. The module efficiency would be 14.5% V. A bird spike shall be provided to avoid bird sitting on the solar module at the highest point of the array/module structure VI. SPV module shall be highly reliable, lightweight and shall have a service life of more than 25 years. SPV modules shall have a limited power loss of not more than 10% of nominal output at the end of 10 years and not more than 20% at the end of 25 years VII. The solar module shall be able to withstand the following environmental conditions normally encountered at site Temp. extremes ranging from -100 C to +850 C Wind load-200 km/h Maximum mean hourly rainfall of 40 mm Humidity level upto 95% Lightning arrester VIII. Strip must contain the following details a) Name of Manufacturer Such as Loome mono CS b) Model or type number c) Serial No. d) Year of make

LED Luminaries 30 W with in built Lithium Battery Technology (Lithium Phosphate) 30 AH 12.8 V with BMS Dusk-to-Dawn MPPT Charge Controller. ( ERTL and Flash Tested) I. Battery over charge cut off: 14.20V II. Battery deep discharge cut off: 10.2V III. Short circuit protection inbuilt with the System.The luminous 20 watt including water proof bracket IP 66 2800 lumen with 5 years replacement warenty.

GI Pole (Folding) with Module Mtg Structure, Luminaire bkt. 1. A corrosion resistant metallic frame structure must be fixed on the pole to hold the SPV module. II. The frame structure must have provision to adjust its angle of inclination to the horizontal between 0 and 45, so that the module can be oriented at the specified tilt angle. III. Pole height: 6 Mtr. (Dia= 76 mm X 60m) With grounding facility (Corrosion resistance) & 3mm thickness with PV module holder etc. Including Fitting fixing.

Cable2C 2.5 Sq.mm for battery charging & 2C 1.5 Sq.mm for load and others including fitting fixing with lux and tape tube and MC 4 Connector. With Fitting fixing & All

Installation

Display Board

Sub Total

GST 18%

CESS 1%