Loading…
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
Tender Value
₹9.7 L
EMD Value
₹9,800
Closing Date
8 Jan 2026, 3:00 pmClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
ZONAL OFFICER
zone 10
Proposed Construction of Food Distribution and Dining hall at Nerkundram Pathai(East) in Division-130, Unit-29, Zone-10
2026_CoC_639866_1
Z.O.X.C.No.E1/KKM/1288/2025/5
Limited
Civil Works
Works
KODAMBAKKAM
Please refer Tender documents.
3 documents required · 3 mandatory
₹0
₹9,800
8 Jan 2026
7 Jan 2026
8 Jan 2026
7 Jan 2026
8 Jan 2026
7 Jan 2026
Dismantling - Brick / Stone Masonry in cement mortar walls under 3m high
Dismantling - Doors and Windows including removal of frames, hinges and fastenings
Supplying, fabricating and placing in position Rib...t and binding wire) Above plinth / Basement level
Supplying and erecting centering for plane surface...g shall be given after the concrete is laid).BEAM
Providing and laying in position, Standardised Con...the Department for the excess usage of materials).
Providing and laying in position, standardised con...the Department for the excess usage of materials).
Dismantling Plain Cement Concrete
Brick work in following Cement Mortar using best q...Executive Engineer in charge. In Cement Morter 1:3
Plastering the surface of walls with Cement Mortar...d as directed by the departmental officers. (Wall)
Dadooing walls with following best approved qualit...in colour glazed tiles of size 150mm x 150mm x 6mm
Painting New Plastered Wall Surface with Two finis...ed by the Executive Engineer before use on works.)
Plain Cement Concrete 1:2:4 (one cement, two crush...departmental officers.-Mixing by mechanical means
Paving the floor with best quality vitrified Tile...pproved by Executive Engineer before use on works)
Painting new iron works such as steel doors...ed by the Executive Engineer before use on works.)
Supplying , fabricating and fixing in position Alu...e anodic film thickness 15 microns etc., complete.
PVC Screw Down Tap Heavy Type 20mm dia
WORKING PRESSURE: 6 kg. per cm2 PVC Pipes 160mm dia
Wiring with 2 x 1.5 sq.mm. PVC insulated SC unshe...int (for electronic regulator) (6 points per coil)
Supply and run of 2 of 4 sq.mm. PVC insulated SC ...sq.mm copper wire with painting of suitable colour
Supply and fixing of 5A / 15A 3 pin combined flush...cket with 15A flush type switch on suitable TW Box
Supply of 48" ( 1200 mm ) sweep size 5 star rating Ceiling fan with out regulator
Cost of supply of 20w 4 feet LED fitting with LED tube complete set (Patty and LED tube)
Automatic Electrical Water Heater with copper cont... 35 Litres capacity 230V / 1000W (Lower End)
PVC Water Tank
A.C Exhaust Fan 300mm (12") sweep (Light duty)
Manufacturing, supplying and fixing of Entrance st...tal officers. - Single leaf of size 1.00m x 2.40m.
Providing and Fixing of polyurethane foam as Inter...on. - 50mm thick PUF Internal Partition wall panel
Providing and Fixing of polyurethane foam for Slop...specification. - 50mm (+38mm) thick PUF roof panel
Construction of INSPECTION CHAMBER following ...per standard specification. CLEAR SIZE 0.60 X 0.60
Roofing with Galvanised corrugated iron sheet of thickness 0.8mm
Paving the floor with pre-polished concrete anti-...pproved by Executive Engineer before use on works)
GI REDUCER ELBOW - 20mm x 15mm dia
HORIZONTAL THREE PHASE DISTRIBUTIONBOARD ... incomer ELCB / RCD - 4 No. of outgoings ways - 12
Providing and laying, spreading and compacting gra...es etc., complete as per clause 406 of MORTH Rev-5
Carting away the surplus earth debris to a lead of…. Dumping into the corporation land
RO Water
Furniture set
Name Board
INSECT KILLER LIGHT
INSECT KILLER LIGHT
STAINLESS STEEL SINK
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 0.71 MB
BOQ_766095.xls
BOQ • 0.30 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .