REPAIR/MAINT TO ROAD SHOULDER AND FURNITURE AND REPAIR/MAINT TO ROAD OF ZONE A AREA AT MIL STN GAYA.

Amount

Demolition of cement concrete in drain, paving etc. not exc. 15 cm thicknes above or below ground level.

Roughening surfaces of old concrete floor by picking, sweeping clean and washing down with water to remove dust, etc

M & L 75mm thick cement concrete type C-2, PCC (1:3:6) (40mm graded stone aggregate) as in path/hardstanding as directed by Engr -in -charge

Dismantling of existing machine pressed precast concrete interlocking paver block of any shape any size and refixing the same with sand cushioning at same or other location with proper slope complete all as specified and directed.

Laying of machine pressed precast concrete interlocking paver block of any Shape any size (except tiles) with sand cushioning at same or other location with proper slope complete all as specified and directed.

M & L machine pressed precast conncrete interlocking paver block coloured rubber moulded, lacuered finish any shape any size with grey cement and pigment any shape and size conforming to IS 15658-2006 of 60 mm thickness M-35 Grade œmplete all as specified and directed.

M & L machine pressed precast concrète interlocking paver block coloured rubber moulded any shape any size with grèy œment and pigment any shape and size conforming to IS 15658-2006 of 80 mm thickness M-40 Grade complete all as specified and directed.

M & L for sand filling under floors or in foundations including wateûng and consolidation complete.

M & L Precast cement concrete kerbs stone block (M-30) of size 300x 150x 375 mm depth, including weathering, s\ightiy rounded or chamfered angles and throating incl fixing in cement mortar 1:4 complete all as specified and directed.

M & L for PCC (1:2:4) Type B1 (using 20mm graded stone aggregate) as in copings,kerbs and like including slightly rounded or chamfered angles and throating as directed

M & L for machine pressed chequered cement concrete tiles 30cm x 30cm x 30mm thick with grey cement and pigment over 20 mm thick screed bed in cement mortar 1:4 complete

M & L 25mm thick cement concrete type B-1, PCC (1:2:4) (20mm graded stone aggregate) as in levelling course as directed by Engr -in -charge

Material and labour for painting centre line arrow dashes letters etc not exc 10 cm wide on roads pavement with retro reflective thermoplastic roads marking paint not less than 2mm thick of approved make applied with machine as per manufacturers instruction including preparation of surfaces complete all as directed.

M&L for one coat of synthetic enamel paint (whitelcoloured) including prepration of old painted surfaces on brick. stone concrete, asbestos cement or plaster surface of any discription over10cm girth not otherwise described

M&L for one coat of glazed lacquer hardener paint (polyurethane and acrylic polymers based anti fungal) (Make Granotone) including prepration of old painted surfaces on brick, stone concrete, astbestos cement or plaster surface of any discription over1 Ocm girth not otherwise described.

M & L Scarifing or picking gravelled macadam or bituminous macadam surfaces in area n exc 400 sqm and deep exc 50 mm and n exc 100 mm deep complete all as specified and directed.

Preparing existing black top surfaces by brushing with wire brushes for removing caked mud etc, sweeping with brooms and finally fanning cleaned surfaces with gunny bags to remove all loose dirt etc all as specifed and directed. (Note: Rate included for removing grass,vegitation/scum on black top surfacee grass, root & vegetation/scum complete to the entire satisfaction of Eng- in - Charge. Note : Cleaning should be done through air - compressor.

Material & labour for pre-mix bituminous macadam with 4% binder content by weight of total mix laid/rolled and compacted to required gradiant and camber (consolidated thickness 75mm or less with 8 to 10 ton power roller complete all as directed by Engr-in-Charge (Mix shall be from hot mix plant and spreading shall be with mechanical paver).

M& L applying evenly with a tack coat with catonic bitumen emulsion RS-1 at @ 3.5 Kg per 10 Sqm on existing black top road all as specifed and directed.

M&L Bituminous premixed semi dense asphaltic concrete 30 mm consolidated thickness with 5.5% binder content by weightof total mix rolled and compactyed to required camber and gradient complete with vibrator roller and 8 to 10 tonne static roller all as specified and directed by Engr-in-Charge. Note : Mix shall be from hot mix plant spreading through mechinical paver all as specified and directed by Engr - in- Charge.

M/S ABHAY KUMAR AND BROTHERS

RAMRAS BUILDERS

M/s Vinay Kumar