GE/SRA/T-25/2025-26

Demolition of Cement Concrete (un-reinforced) in ground floors and pavings n exc 15 cm thickness (below or above ground level) and removal of debris outside AF land and disposed off complete all as specified and as directed.

Demolition of Cement Concrete (reinforced) of any description and in any position not otherwise specifically provided for and removal of debris outside AF land and disposed off complete all as specified and as directed. (NOTE: Old reinforcement shall be measured under Sch of Credit)

M&L for PCC 1:4:8 type D-2 using 40mm graded stone aggregate as in foundation filling and mass concrete complete all as specified and shown on drawing.

M&L for 100mm thick PCC 1:2:4 type B-1, using 20mm graded stone aggregate as in floor/paving finished even and smooth without using extra cement complete all as specified and as directed.

M&L for 75mm thick PCC 1:3:6 type C-1, using 20mm graded stone aggregate as in plinth protection finished even and smooth without using extra cement complete all as specified and as directed.

M&L for providing precast cement concrete, RCC 1:2:4 type B-1, using 20mm graded stone aggregate in landings, cover slabs (for man holes, earthing pits, etc.) chajja, water troughs, mangers, shelves and similar articles with plain face complete with joints to match including necessary formwork complete all as specified and as directed. (NOTE: MS reinforcement shall be measured and paid seperately. Quoted rate shall be deemed to inclusive of the cost of formwork)

M&L for Mild steel TMT bars 6mm to 8mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed.

Taking down cement plaster/terrazzo finish on wall of any description hacking for key scrubbing down with water including racking out joints and removal of debris outside AF land and disposed off complete all as specified and as directed..

M&L for rendering 12 mm thick in cement mortar 1:6 on fair faces of the brick work or concrete surfaces and finished even and smooth without using extra cement complete all as specified and directed.

M&L for preparing New/Undecorated Plastered Surfaces of Walls, applying a coat of suitable cement primer followed by a Coat of 2.0 mm thick Wall Putty (in two layers of 1mm thick) including rubbing down with Sand Paper to obtain a smooth finish surface and finishing with Two Coats of Acrylic/Oil Bound Distemper (as approved) as per desired shade/tint complete all as specified and as directed.