DEVELOPMENT OF OPEN SPACE NEAR LIGHT POINT AT INTERSECTION OF SECTOR 38 WEST AND 39 WEST, CHANDIGARH, UNDER LANDSCAPING

Earth work in excavation by Mechanical means ( Hydraulic excavator) manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and remming of bottoms,lift upto 1.5 m,including getting out the excavated soil and disposal of surplus excavated soil as directed, within lead of 50m. All kinds of soil (DSR 2.8.1-2.36)

Carriage of earth by mechanical transport including loading, unloading Lead of 2 km complete in all respect to the entire satisfaction of the Engineer-In-Charge.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:5:10 (1 cement : 5 coarse sand (zone-III): 10 graded stone aggregate 40 mm nominal size) DSR 4.1.10

Brick work with F.P.S. bricks of class designation 75 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand) (DSR 6.1.1)

Providing and laying position cement concrete of specified grade excluding the cost of centring and shuttering , All work plinth level: - 1:2:4 (:1 cement : 2 coarse sand : 4 graded stone agg 12.5mm nominal size Complete in all respect to the entire satisfaction of the Engineer-In-Charge.(DSR 4.1.3)

15mm cement plaster of mix: 1:4 (1 cement: 4 coarse sand) to the entire satisfaction of Engineer-in-Charge. (DSR 13.5.1)

Pointing on brick work or brick flooring with cement mortar 1:3 (1 cement : 3 fine sand) Flush/ Ruled/ Struck or weathered pointing to the entire satisfaction of Engineer-in-Charge. (DSR 13.31.1)

Finishing walls with acrylic Smooth exterior paint of required shade:- New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 Kg/ 10 sqm. (DSR 13.46.1)

Providing and fixing M.S. flat railing having flat size 50x12mm,(2"x1/2") 4'-0" high(3' high above ground level) welded with 2no's M.S. flat 38x10mm horizontally at distancwe 9.5" upper and 9.5” from bottom and 1no's M.S. flat 25x10mm on the lower side of top M.S. flat including 8mm M.S. square bars of 45 degree angle at 6" center to center between the 2no's horizontally M.S. flat iron. The rates also includes the cost of 2 No. 12mm dia nut and bolts with 2no's M.S. pipe of 19mm dia and 3" long imbeded in ceme sleeve piece embedded in cement concrete 1:2:4 block of size 1'-0"x0'-9"x1'-0" and painted with three coats of approved quality paint over one coat of primer complete in all respect to the entire satisfaction of Engineer-in-Charge.

Steel work welded in built up sections/ framed work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. as required. (DSR 10.25.2)