Supply,delivery and Fixing of Table Chair, Aluminium Panel Partition and Lighting Arrangements at Revenue section in Municipal office in Tiruchengode Municipality.

Towards the charges for supply and fixing of Glass 4.0mm thick for existing PLB Sheet at Engg Section etc complete.,(Excluding GST)

Supply and fixing of Plastic chair Dimension H 32.67X W 22.04 X D 22.83 inch , Seating Ht 16.92 inch to Engg section etc complete.,(Excluding GST)

Supply and fixing of Medium Back S Type Chair,18 Inches 1 year warranty,Size: 52.5w X 61d X 80.5h X 44 Sh Cm ; Armrest, Without Arm ; Size, 52.5W x 61D x 80.5H x 44 SH cm ; Back Type, Fabric ; Usage/ ...Chair Type: VisitorSize: 52.5W x 61D x 80.5H x 44 SH cm Back Brown, to Engg section etc complete.,(Excluding GST)

Medium Back S Type Chair

Supply and fixing of Wooden Fusion Executive Office Table Set With Storage 1.20mx0.60mx0.75m, Good quality and Easy to use etc complete.(Excluding GST)

Supplying, fabricating and fixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections.

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962.

add GST 18%

Please Enable Macros to View BoQ information