REPAIR/ MAINT OF E/M INSTALLATION INCL CIVIL / E/M WORKS AT JAK LI RC UNDER GE 970 EWS

Demolition of cement concrete in ground floors and pavings n.exc 15cm thickness (below or above ground level) omplete all as specified and as directed.

M&L 75 mm thick PCC (1:4:8 ) type D-2 as in sub base finished even and rough complete all as specified and as directed.

M & L Chequered cement concrete Tiles 20cm x 20cm x 25mm Thick with Glossy Finish ,Set ,joined & Pointed in neat cement slurry in Floor With Grey cement & Pigment over 15mm thick Screed Bed in CM(1:4) including Dismantling of tiles omplete all as specified and as directed..

M&L Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade conforming to IS-15658-2006 with approved colour, design & pattern (glossy finish) as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including dismentling of tile & 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified and as directed.

M&L for PCC 1:2:4 type B-0 using 12.5 mm graded agregate as in copings omplete all as specified and as directed.

M&L for PCC 1:4:8 type D-2 (using 40mm graded stone agg) as in foundation filling and mass concreteomplete all as specified and as directed..

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for (reinforcement cut as required to facilitate demolition) omplete all as specified and as directed.

Formwork to soffits of suspended slabs such as roof slab, floor slabs landings and sgh finished surfaces of concrete flat omplete all as specified and as directed.

M&L for RCC 1:2:4 type B-1, Slab supported on walls,beams and columns in floors,roof, landing, balconies,in type B1(20mm graded aggregate).

M & L for mild steel TMT bars ,10mm dia and over , cut to length , bent to shspe required incl cranking , bending spirally for hooping for coloumns , hooking ends andbionding with (annealed) not less than 0.90 mm dia all a specified and directed