RE-CARPETING OF V-5 ROAD FOR APPROACH TO COMMUNITY CENTRE JANJ GHAR AND SHOPPING CENTRE AT MALOYA CHANDIGARH.

Providing and laying tack coat with bitumen VG-10 @ 3.0 kg/10 sqm using sprayer pump on prepared surface heating bitumen in boiler and spraying bitumen with spray set fitted on bitumen boiler including cleaning of road surface with complete in all respect as per MORT&H specification and to the entire satisfaction of the Engineer-in-charge. (NS)

Providing and laying 30 mm thick bituminous concrete as per clause 507 of MORT&H specification with mechanical paver after mixing aggregate and bitumen as per design mix in Hot mix plant using minimum 5.40% bitumen of grade VG-30 and using both coarse and fine aggregate filler stone dust @2% by weight of aggregate confirming to relevant specification laid in MORT&H specification clause 507.2.2 and 507.2.3 with grading confirming to table 500.17 gradation –II of MORT&H specification and density of bituminous concrete as laid 2.35 gm/cc complete in all respect as per MORT&H specification and to entire satisfaction of Engineer-in-charge. (NS)

Providing and applying of hot thermoplastic compound 2.5mm thick for edge lines, centre lines, stop lines, zebra crossings, letters, numerals, diagonals and chembrons etc. including reflectorising glass beads @250gms. Per Sqm. Area, thickness of 2.5mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to level, uniform and free from streks and holes. The thermoplastic compound shall be screeded/extruded on the surface in moltan state by suitable machine capable of controlled preparation and laying of surface application of glass beads at a specific rate. The marking should be capable of resisting deformation by traffic, it should not be slippery when wet and marking shall not deteriorate by contact with sodium chloride, Calcium chloride or oil dropping from traffic. The material shall be free from all skin, dirt and foreign objects and shall comply as per table 800-9 and 800-10 complete in all respect as per Clause 803.4.1 of MORT&H specification (5th revision) and to the entire satisfaction of Engineer-in-Charge. (NS)