REPAIR CLEANING OF OLD AND NEW DRAIN STONE PITCHING GLASS COPING COPING AROUND THE RUNWAY DE SILTING OF COVERED DRAIN WITH REPAIR OF BOTTOM OF DRAIN AND ALLIED BR WORKS AT TECH AREA AT ICGAS DAMAN

Amount

Demolition of brick / stone masonry works /concrete work built in cement mortar and removal of the same outside MD land at any distance etc complete all as specified as directed .

Demolition of Plain cement concrete n exc 15cm thick above or below ground level etc complete all as specified and directed.

Demolition of reinforcement cement concerete as band etc complete all as specified and directed.

Taking down cement plaster on brick masonry walls built in cement mortor /concrete surface including taking out joints hacking for key scrubbing down with water in any position etc complete all as specified and as direted.

Taking down glass coping from top of boundary wall and removing rubbish outside of MD land complete all as specified and as direted.

Dsimantling of posts or struts (wood, steel or RCC) any section,posts embedded in concrete, brick work, masonary etc complete all as specified and directed by Engr-in-Charge.

M&L for Cement concrete type D-2 1:4:8 (using 40mm graded stone aggregate) as in foundation filling and mass concrete.

M&L for Cement concrete type C-1 , 1:3:6 (using 20mm graded stone aggregate) as in surface channels, drains and angle iron post etc, complete all as specified.

M&L for burnt brick using old sized sub class 'B' bricks straight or curved on plan exceeding 6m mean radius and built in CM (1:4) etc complete, all as specified and as directed.

all as per serila item No 9 here in before but except bricks ( Old serviceable bricks shall be used as obtained from serial item No 01 here in before , the rates include for cleaning of bricks also

M&L for rendering 15mm thick in CM 1:6 on any type of faces of brick or concrete surfaces finished even and rough without using extra cement etc complete all as specified and as directed.

M&L for preparing newly plastered surfaces and applying two coats of weather proof Acrylic Exterior Emulsion paint over a coat of primer complete all as spd and directed by Engr-in-Charge

M&L for preparation of old plastered surfaces of walls, chajjas, parapets etc and applying one coat of acrylic exterior paint over a coat of exterior grade primer, as per the manufactures instructions and as directed , removing the loose materials and filled with crack sealing compound of approved make if necessary etc. , complete all as specified and as directed.

M&L for broken glass coping on top of brick masonry walls in CM 1:3 rendered with 25mm layer of cement mortar (1:3) with a rounded or weathered finish and setting broken glass (of bottle or thick glass) broken to approximately 63mm gauge, by firmly embedding at the rate of 10 Kg of glass per square metre of rendered surface, joggd edges of the glass being left projecting including taking off and removal of debris out side to MD land at any distance all as specified.

M&L for walling of random rubble uncoursed well bounded bedded and solidly hearted and built in CM 1:6 , complete all as specified and as directed.

M&L for keyed pointing in CM 1:3 to random rubble walling uncoursed etc complete all as specified and directed.

S&F 110mm dia PVC(SWR) pipes in any lengths laid as in weep holes with and including setting in neat cement paste etc complete all as specified.

M&L for stone boulder hand packed tightly pitching is grouted with cement and sand mortar 1:6 all as specified and directed.

all as per serila item No 18 here in before but except stone boulder ( Old serviceable stone boulders shall be used as obtained from serial item No 01 here in before , the rates include for cleaning of stones also .

M&L for boulder filling dry, handpacked tightly, as back filling of walls complete all as specified and directed by Engr-in-Charge

M&L for PCC 1:2:4 type B-1 (using 20mm graded stone aggregate) as in seismic and other similar bands /copings, bed blocks etc including use and waste of formwork as required etc complete all as specified and directed.

M&L for 100 mm thick PCC 1:3:6 type C2 (using 40 mm graded stone aggregate) as in sub base etc., complete all as specified and directed.

M&L Machine pressed precast concrete interlocking coloured paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 grade mixed with grey cement and pigment over and including 50 mm thick sand cushion complete all as specified and as directed.

De-silting/cleaning of silt deposited in strom water drains with repair of existing bottom surfaces of PCC drain and disposing of the same to a distance not exc 50m and depositing where directed at a level not exc 1.5m from the starting point,including removing and refixing of cover slabs where ever necessary ,complete all as specified and directed.

M&L for writing letters or figures (block, roman, Italic or Indian) n exc 30 cm high ,width not less than 25mm ,including circular base of combination of different colour with synthetic enamel paint , complete all as specified and as directed

M& L for re-writing of stops, commas, short lines, dashes, hypens, brackets etc including circular base of combination of different colours with synthetic enamel paint complete all as specified and directed .

M&L for RCC, M-20 (nominal mix) 20mm gradded stone aggregate in lintel/band supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like, complete all as specified and directed.

Form work to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintles, cantilevers, shelves including supports overhangs etc, also splays between floor and beams etc .as in rough finished concrete surfaces complete all as directed.

Supply and fix in position, Mild Steel bars TMT, 10mm dia and over, cut to length, bent to shape required, including cranking, bending for hooping of columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, as in reinforcement, complete all as specified and directed.

Mild Steel TMT bars up to 10mm dia in stirrups, spacers and binder etc cut to length, bent to shape required, including cranking, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified.

M&L for mild steel work (confirming to Fe-290, Gde E-165) as in fencing posts and struts with both sides swan neck including necessary welding and tops to shape as directed, drilling holes, notching for wire etc, flat iron fillets (for securing wire mesh etc) including all necessary drilling, bolting or riveting and welding in existing angle iron complete etc complete all as specified and directed by Engr-in-Charge.

S&F of Razor type concertina fencing coil 9 SWG hot galvanised spring tensile wire of UTS 145 to 150 Newton per square mm, of DTS 145 x 0.15 kg zinc coating 250-300 grams per square metre, dia of coil when unstreched 650mm having minimum number of coils 10 per RM of size 0.50mm thickness, 19mm wide before wrapping on central core wire fixed 1.66mm thick GI clips minimum 25 Nos per RM and special nut bolts hold two coils together and extra two rows parallel wire of 10 guage including taking down complete all as specified and as directed .

S&F as in repairs plain mild steel wire 3.15 mm dia galvanised, class 3 in fencing including straining and fixing to steel posts or to straining bolts, including, securing with and provision of galvanised mild iron staples or steel pins, etc. complete all as specifed and as directed by the Engr-in-Charge . NOTE : (Each line of wire to be measured)

Restraining and resecuring including making good plain mild steel wire 3.15 mm dia galvanised, class 3 in fencing including straining and fixing to steel posts or to straining bolts, including, securing with and provision of galvanised mild iron staples or steel pins, etc. complete all as specifed and as directed by the Engr-in-Charge . NOTE : (Each line of wire to be measured)

M&L for two coats of synthetic enamel paint over a coat of red oxide incl preparation of new steel surfaces complete all as specified and as direted by Engr-in-Charge

M&L for one coat of synthetic enamel paint on old steel surfaces complete all as specified and as direted . Sch of credit Rs 40,600.66

VIJAY ENTERPRISES