Mohanur TP - 2025-2026 School Improvment Fund 6th FC Grant Construction of Toilet at Govt Boys Higher Secondary School

Amount

Earthwork excavation for foundation in all soils and sub soils in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders and to full depth as may be directed,except in hard rock,requiring blasting including shoring and shuttering and bailing out of water wherever necessary,refilling the sides of foundation with excavated earth or sand in layer of not more than 15cm thick.well rammed and consolidated and depositing on bank with initial lead and lift of 10m & initial lift of 2m and depositing the surplusr earth within the compound in places shown by the departmental officers with iniital lead and lifts,clearing and levelling the site etc., complete as per SS20B and as directed by departmental Engineers(TNBP No.17,23,24).

Plain Cement Concrete 1:4:8 mix (One Cement, Four Fine Aggregate and Eight Coarse Aggregate) Using 40mm ISS HBG metal for foundation and basement including dewatering if found necessary and laid in layer of not more than 15cm thick and consolidated including all cost conveyance of materials and labour charges etc. complete as per standard specifications and as directed by departmental Engineers(TNBP No.28).

Supplying and erecting centring for sides and soffits including supports and strutting up to 3.29m high for plane surfaces such as RCC Slabs,Rectangular beams,Tee (or) ELL beams,Lintels,bed block,slabs,landing beam,canopy side slab,or boxing (or)vertical slabs,rectangular (or) square(or)round columnsetc.,as detailed below with all cross bracings using M.S Sheets of size 90cmx60cm and B.G 10 Stiffended with welded M.S.Angles of size25mmx25x3mm for boarding laid over silver oak(or)country wood joist of size 10cmx6.5cm spaced at about 90cm centre to centre and supported by casurina props 10cm to 13 cm dia spaced out 75 cm centre to centre or at suitable intervals etc.,complete complying with std.specification - For Grade beam

For Column

For Lintel and slab

Supplying, fabricating and placing in position of TMT steel Rods for reinforced cement concrete works as per the design given including cost of steel, binding wire, straightening the rods, if they are supplied in coils welding rods of dia above 25mm in all floors etc.,complete complying with standard specification. The welding should confirm to BIS.

Providing and laying in position Standardised Concrete Mix M-20 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 325Kg/ cum and maximum water cement ratio of 0.55 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without imparing strength and durability with about (5.0cum), 7730Kg of 20mm machine crushed stone jelly and with about (3.3 cum), 5156kg of 10 - 12mm machine crushed stone jelly and with about (4.79cum) 7670 kg of Crushed Stone Sand (M- Sand), but excluding cost of reinforcement grill and fabricating charges centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing, etc and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers -

Brick masonary in Cement Mortar 1:5 mix (One part of cement & five parts of sand) using Second Class Ground Moulded Chamber Burnt Bricks of size 9” x 4 1/2” x3” including cost and conveyance of all materials to work site and including all labour charges for mixing, laying, curing the concrete etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:31 -For Below Basement

For Above Basement

Plastering with CM 1:5 (One part of cement & five parts of sand) mix for 12mm thick including cost and conveyance of all materials to work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:56&57

Special ceiling Plastering in Cement Mortor 1:3 Mix (one Cement, Three sand ) 10mm thick including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing etc. complete complying with std. specifications.

Plastering with cement mortar 1:4 (One Part of Cement and Four part of Plastering Sand (P- Sand)) 20mm thick in all floors including cost and conveyance of all materials to site and labour charges etc, complete complying with standard specifications (S.I.309)

Daddoing with first quality colour glazed tiles of 150 mm x 150 mm x 6mm size of approved make and quality and colour set in Cement Mortar 1:2 (One Cement and Two Sand) and pointing with white cement neatly including cost and conveyance of all materials etc.and all lobour charges etc.complete as per Standard specification and as directed by the departmental officers.TNBP No:special

Supplying and fixing over the floors best quality of ceramic tiles of 30 c.m x 30c.m x 6mm size of approved colour laying with cement mortor 1:2 mix pointing the joints with colour pigmentsincluding cost and conveyance of materials and labour charge etc. Complete.as per std specification.

Supply and fixing in position Indian water closet of size 580 x 440mm, white earthen ware of approved quality with ‘P’ trap or ‘S’ trap confirming to IS : 2556 – Part XII with sand cushion and forming flooring alround the closet using 40mm broken brick jelly in lime concrete 1:2:5 (one part of lime, two parts of sand and five parts of brick jelly) 100mm thick and finishing the top to required slope and including giving necessary connection to cast iron soil pipes / PVC pipes by dismandling brick masonry, reinforced cement concrete roof / floor slab and making good the disturbed portion to original condition without leakage etc., complete complying with standard specifications and as directed by the departmental officers. (The water closet should be got approved by the Executive Engineer before use on works.)

Wiring with 2x1.5 sqmm (22/0.3) PVC insulated SC.unsheathed Cu. Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A F.T. switch with painting of suitable Colourfor open PVC light point / fan point (For electronic regulator) (5 points per coil) SD18

Supply and fixing of WT bulk head fitting with guard (Philips / Bajaj / Crompton / K. Lite) suitable for11W CFL lamp with CFL SD 83

Supplying and fixing M.S.Grill for Door opening, corridor sides,window, entrance gate and Name board angles etc., using necessary M.S.Flats for inner member and outer members which should be fixed as directed by the departmental officers inclusive of cost of providing one coat of beet quality red oxide primer. The design of M.S.Grills should be got approved from departmental officers before use on works.(PWD S.R Page no.22,Schedule item no.131)

Painting two coats for Exterior surface with approved Exterior Plastic Emulsion paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification.

Supply and fixing in position of RCC Jolly 50mmtk including cost and conveyance of all material to site and all other labour charges for fixing etc., Complete

Painting two coats new iron work for doors, windows and ventilators using iron bars, window grills weld mesh screen in opt courtyard etc., with two coat synthetic enamel paint and approved quality and color including priming coat in all floors. The rate is inclusive of cost of all materials, labour brushes and scaffolding charges etc., complete complying with standard specifications.

1000liter H.D.P.E water tank with ISI mark(1270/1996)

M Palanisamy (BID ID -1474607)