Krishnagiri DT Bargur Block SADP 2025_26 CONSTRUCTION OF Community Hall at Ambedkar at Kandhikuppam.AD Colony SC Ward KGI25RUR050 BRG_70

1.CONSTRUCTION OF Community Hall @ Ambedkar H/o. Kandhikuppam. - AD Colony SC Ward (KGI25RUR050) Rs-31.25 Lakhs

Earthwork excavation and depositing on bank with an initial lead of 10m and lift of 2m in the following classification of soils as directed by Departmental officers. Hard stiff clay, block cotton, hard red earth shales, murram, ordinary gravel, stoney eart

P.C.C.1:4:8 mix using 40mm metal and the rate including cost and conveyance of all materials to work site and labour charges etc., complete complying with standard specification.

Supplying, fabricating and placing in position of steel rods (M.S or RTS) including cost of binding wire and the rate including cost and conveyance of all materials and labour charges etc. complete complying with standard specification.

Supplying and erecting steel centering for the sides and soffits of RCC slab or plane surfaces excluding strutting and the rate including cost and conveyance of all materials and labour charges etc. Complete complying with standard specification.

Supplying and erecting steel centering for the sides and soffits of RCC slab or plane surfaces excluding strutting and the rate including cost and conveyance of all materials and labour charges etc. Complete complying with standard specification.

Plain Cement Concrete 1:2:4 Mix (one part cement, three part sand and six part of aggrigate) using 40% of 40mm size and 60% of 20 mm size ISS HBG metal from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing. Laying and curing etc. complete. Complying with std. specification

Reinforced cement concrete 1:1.5:3 mix using 20 mm size I.S.S. HBG metal mixing, laying and the rate including cost and conveyance of al materials and labour charges etc. Complete complying with standard specification.

Brick work in cement Mortar – 1:5 mix using best country Bricks and the rate including cost and conveyance of all materials and labour charges etc. Complete complying with standard specification.

Weathering course in brick jelly lime concrete using broken brick jelly of size 20mm uniform gauge in pure slaked lime (no crushed stone M.Sand to be used) to the proportion of brick jelly to lime being 32:12.5 by volume and laid over the RCC roof slab in a single layer of required slope and finished by beating the concrete with wooden beaters of approved pattern, keeping the surface constantly wet by sprinkling lime jaggery water, etc., complete as per standard specification and as directed by the deparmental officers.

Finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 20mm of approved quality set in Cement Mortar 1:3 (One Cement and Three Crushed stone M.Sand) 12mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers

Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing. The Surface shall then be allowed to dry for atleast 48 hours. It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface. Any unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. [ The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete]. The Putty shoule be got approved by the Executive Engineer before use on work.

PLASTERING with cement mortar 1:5 (one cement and five sand)12mm thick in all floors complying with standard specifications.

Supplying and painting the walls with two coats of oil bound distemper over one coat of water based cement primer including cost for distemper, primer, cleaning and scrapping the walls, rendering the walls smooth with necessary putty, brushes, scaffolding arrangements, labour charges, etc., as per standard specification. (The colour and shade of the distemper shall be got approved by the Executive Engineer before use of work).

Painting two coats of newly plastered wall surface with ready mixed plastic emulsion paint of first class quality and of approved colour over a priming coat including thorough scrapping, clean removal of dirt, and including necessary plaster of paris putty, wherever required etc., complete complying with standard specification.

Supplying and fixing in position of M.S. door and MS Windows the rate including cost and conveyance of all materials and labour charges etc., complete complying with standard specifications.

Toilet door 0.90 x 2.10mt

For toilet door 0.75 x 2.10mt

For building window

Labour charges for fixing of Steel Door including cost of all charges etc., complete complying with standard specifications.

Labour charges for fixing of Steel Window including cost of all charges etc., complete complying with standard specifications.

Supply and run of 2 of 4 sq.mm. (56 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V on 7 / 20 GI bearer wire for service connection mains ( SD 65 )

Supply and fixing of TNEB meter board suitable for 32A single phase service connection with 32A fuse unit (500V) 32A neutral link and earth link (1" x 1/8" copper flat) on TW plank of size 375mm x 300mm x 19mm withsupporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank onwall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit (SD 125)

Supply and run of 2 of 4 sqmm (84/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade in 25mm G.I pipe (Class 'B' bent at both ends with necessary angle iron up right and end supports for mains (SD No.70) Page No -37

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessoires in flush with wall with 3mm thick hylum sheet cover with TW switch box and 5A FT switch and making good of the concealed portion with suitable colour for PVC concealed light / fan Point (for electronic regulator) (5 points per coil) (SD 25) Page 16

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitablePVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x 113mmTW switch box with 3mm thick hylem sheet cover for 5A 3 pin non inter locking wall socket with 5A flush type switch with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion withsuitable colour for concealed PVC plug point (SD 38) Page -24

Supply and fixing of WT bulk head fitting with guard (Philips / Bajaj / Crompton / K. Lite) suitable for11W CFL lamp with CFL. SD 83

Wiring with 2 x 4 sq.mm. (56 / 0.3) PVC insulated SC unsheathed copper conductor cable of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x113mm TW switch box with 3mm thick hylem sheet for 15A 3 pin non inter locking wall socket with 15A flush typeswitch with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion withsuitable colour for concealed power plug point (SD 40 ) Page 25

Supply and fixing of 16A TPN metal clad switch on suitable angle iron frame work with MS cable entry boxes with earth connection only (SD 162 ) Page 72

Supply and fixing of single box type 4'40W fluorescent fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flutube with PVC unsheathed copper leads from terminals to the fitting (SD 88 ) Page No.44

Supply and fixing of 1200 mm ( 48") AC ceiling fan complete with stepped electronic 300 W regulator with 300 mm down rod on the existing clamp. SD 110Ceiling fan SD 110

Paving the floor with best quality Vertified Tiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1:3 (one cement and three crushed stone M.Sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification. (The make and brand of the tiles should be got approved by Executive Engineer before use on works)

Dadooing of walls with colour glazed tiles of size 300x200x6 mm finished thickness with c.m 1:2- and polished with same color cement including all cost and convene of all materials etc.,complete

Supplying and fixing RCC precast jolly and the rate including the cost and conveyances of all charges etc complete

Supplying and fixing of waterclosets white glazed earthernware with Por S trap and pair of porcelain footrests and the rate including the cost and conveyances of all charges etc complete

Supplying and fixing of Europian type water closet including cost and conveyance of labour charges for complete complying with standard specification

Supplying and fixing in position best Indian make colour glazed earthenware WASH HAND BASIN of 560x406mm with a a pair of C.I. Brackets, 15mm dia C.P. Pillar tap, 32mm G.I. Waster water pipe, 32mm dia C.P. Brass waster coupling, plug with chain, 15mm dia PVC connection, 15mm G.M. wheel valve with ISI mark and necessary G.I. union and G.I. Elbow, including fixing wash hand basin in position with white lead, clamps, teakwood plugs, screws, rubber washer etc., complete without any leakage complying with standard specifications.

Supplying and fixing of Special Type Mirror of Size 1000 x 780 mm including cost and conveyance of labour charges for complete complying with standard specification

Supplying and fixing of SS Towel Rail including cost and conveyance of labour charges for complete complying with standard specification

Supply and delivery and fixing of 1000 litres capacity HDPE tank as per IS 12701/1996 including loading,unloading.transporting and labour charges for fixing of the GI pipes and specials for pipe connection works including cuttiing,threading and fixing charges etc.,complete

Supplying and fixing in position of RCC ring of dia 1.00 m and height 0.30 the rate including cost and conveyance of all materials and labour charges etc., complete complying with standard specifications.

Provision for RWH arrangements

Provision for Name board

Provision for Photo charges

32mm PVC Pipe

32mm PVC Bend

25mm PVC Pipe

25mm PVC Elbow

25mm PVC Tee

25mm x20mm PVC Reducer

Screw Down Tap 20mm

110mm PVC Pipe

110mm PVC Bend

110mm PVC Tee

110mm PVC Pipe cowl pipe

110mm PVC Pipe vent cowl

PVC Nahini / Floor Trap with PVC Grating 100mm x 75mm

GST Amount for providing Service to Government Contract Works for the above Construction & Maintenance Works. { GST Amount is the Total GST Amount for overall quoted amount (Both Construction and Maintenance) above this row in column "BB" for all works in this package} (Refer Clause 13.2 & 13.3 of Section 2 of Instruction to Bidders (ITB) of SBD)

Please Enable Macros to View BoQ information