Providing high mast light in the park of 14J type houses behind Lala Shyam Lal Building in PGIMS Rohtak

Amount

COPPER WIRING IN EXISTING PVC/MS CONDUIT PIPE SURFACE/RECESSED.(HSR 23.5)

23.5.6:- Wiring main and sub mains in two single core for phase and neutral wire and one single core for earth wire PVC insulated Copper conductor cable 1100 Volts grade in existing MS/PVC Conduit etc as required.

23.5.6.1:- 1 run of Size 1.50 Sqmm(1/1.40mm)

MCCB ,DISTRIBUTION BOARDS, MCB's, RCCB's, CHANGE OVER etc.(HSR 23.22)

23.22.1:- Supply and erection of Modular case circuit breaker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work.

23.22.1.9:- 4 pole MCCB 6 amp to 100 amp , 25 K

23.22.5:- Supply and erection of miniature circuit Breaker 240/415 V in the existing distribution board including making necessary connections:-

23.22.5.1:- 6 amp. to 32 amp Single Pole

SAFETY ITEMS.(HSR 23.26)

23.26.1:- Supply and erection of Medium Voltage caution notice plate of size 200*150 mm in three languages.

Supply and erection of Godrej Almirah typeM.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and locking arrangement with Godrej type handle including round bars . The top covering should have downward overhang of 75 mm on all sides of pedestal , having two sets of water proof ventilation holes of suitable size on the sides , at top and bottom , each set containing four Nos. holes to discharge the heat produced by the current. The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof . The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embeded upto the entire depth in 1 :2:4 cement concrete block , projected 75 mm all around the pedestal and and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer?in-charge of the work:-(HSR 23.27)

23.27.2:- M.S. pedestal of size 750 mm wide , 900 mm high , 300 mm deep and bottom totally open , duly embeded in cement concrete block of size 900 mm x 450 mm x 200 mm above ground level , having a base of size 1050 mm x 600 mm x 250 mm below ground level .

EARTHING AND LIGHTENING ARRESTOR (HSR 24.1)

24.1.1:- Earthing with GL earth pipe 4.5 m long and 40 mm dia with masonry enclosures on the top etc. (but without charcoal or coke and salt) as required.

24.1.2:- Extra for using salt and char coal/coke for pipe earth electrode as required.

24.1.14:- Supply and erection of 20mm x 3 mm thick GI, tape fixed with suitable G.I. staples of same size.

STREET LIGHT (HSR 24.4)

24.4.15:- B.S.E.N.10025 High Masts

24.4.15.1:- Supply, installation, testing and commissioning of 12.5 mtr. long High Mast manufactured from B.S.E.N. 10025 or equivalent grade material in, 2 (two) section hot dip, galvanized inside and outside in single dip, suitable for wind velocity as per IS 875 Part-3 suitable for 6 nos. luminaire loading fully motorized (power tool) with starter & cable complete along with standard accessories supplied by the manufacturer with 3 nos. steel wire rope double drum system and twin dome aviation light with LED without foundation but including cost of set of foundation nut and bolts, installation at site complete in all respect upto entire satisfaction of Engineer-in-Charge Thickness of Top and Bottom Section = 3 mm (minimum) Top Dia= 150 mm and Bottom Dia= 360mm Thickness of Galvanization - Top = 65 micron (minimum) and Bottom = 85 micron (minimum)

MISCELLANEOUS ITEMS (HSR 24.5)

24.5.2:- S/E mark double walled corrugated (DWC) HOPE, pipe 10 Kg/Cm2 ,laid 0.75 Metre below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HOPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work.

24.5.2.3:- DWC/HOPE pipe 63/50 mm outer dialinner dia

RCC FOUNDATIONS FOR HIGH MAST OCTAGONAL POLES Providing RCC foundation of M25 grade (1 Cement:1 Stone aggregate: 2 Coarse sand) i/c excavation, steel reinforcement (Fe 500) @ 75 kg/cum of concrete contents, concrete cover 50mm, anchor bolts etc. over a bed of PCC 1:5:10 of required dimensions for high mast octagonal poles of various heights as per following specifications complete in all respects and as per directions of Engineer-in-charge (HSR 24.9)

24.9.1:- 12.5 m high mast pole

N.S ITEMS E.I. WORK

Supply,erection, testing & commissioning of 150 watt LED flood light complete in all respect upto the entire satisfaction of Engineer-in-charge of the work.Make:-Crompton/Surya/Havells/Philips/Wipro(N.S)

Supply,erection of 16 sqmm 4 core armored underground cable loose in existing pipe or trenches complete in all respect upto the entire satisfaction of Engineer-in-charge of the work.(N.S)

Supply,erection, testing & commissioning of exhaust 32 amp 3 phase automatic / digital time switch of Indo Asian make HSN code 8537 along with contactor of required capacity of Indo Asian make movement controlled by precisaty quartz osciliation operation on main supply of continue to run on built in rechargeable nickle cadium call for 150 hours in the event of power failure including cost of all petty items complete in all respect upto the entire satisfaction of Engineer-in-charge of the work.(N.S)

M/s Sanjay Kumar

Balraj Singh Contractor