Construction of shops to the truck terminal at Mettupalayam

Amount

Code No.2.8.1 Earthwork in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5m, including getting out the excavated soil and disposal of surplus excavated soil as directed , within a lead of 50m - all kinds of soil.

CODE NO. 4.1.3 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work upto plith level - 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20mm nominal size)

CODE NO. 4.1.10 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work upto plinth level - 1:5:10 (1 cement : 5 coarse sand : 10 graded stone aggregate 40mm nominal size)

Code No.4.3.2 Centring and shuttering including strutting , propping etc. and removal of form work for - retaining walls, return walls, walls (any thickness) including attached pilasters, buttresses, plinth and string courses fillets, kerbs and steps etc.

CODE NO.6.1.1 (Addendum) Brick work with common burnt clay F.P.S. (non modular ) bricks of class designation 3.5 in foundation and plinth in - cement mortar 1:4 (1 cement : 4 coarse sand)

CODE NO.6.13.2 (Addendum) Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 3.5 in superstructure above plinth level upto floor V level - cement mortar 1:4 (1 cement : 4 coarse sand)

CODE NO. 6.15 Extra for providing and placing in position 2 nos 6mm dia M.S.bars at every third course of half brick masonry

CODE NO.10.6.1 Supplying and fixing rolling shutters of approved make, made of required size M.S.laths, interlocked together through their entire length and jointed together at the end by end locks , mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength conforming to ISS :4454 -part 1 and M.S.top cover of required thickness for rolling shutters - 80 x 1.25mm M.S.laths with 1.25 mm thick top cover

CODE NO.10.7 Providing and fixing ball bearing for rolling shutters

CODE NO.10.25.2 Steel work welded in built up sections / framed work , including cutting,hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required - in gratings, frames, guard bar, ladder, railings, brackets,gates and similar works.

CODE NO.11.3.1 Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate ) finished with a floating coat of neat cement including cement slurry, but excluding the cost of nosing of steps etc. complete. 40mm thick with 20mm nominal size stone aggregate.

CODE NO.12.50 Providing & fixing precoated galvanised iron profile sheets (size, shape, and pitch of corrugation as 0.50mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both sides of the sheet and polyster top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired. The sheet shall be fixed using self drilling / self tapping screws of size (5.5 x 55 mm) with EPDM seal, complete upto any pitch in horizontal / vertical or curved surfaces, excluding the cost of purlins , rafters and trusses and including cutting to size and shape wherever required

CODE NO.13.1.1 12 mm cement plaster of mix 1:4 (1 cement : 4 fine sand)

CODE NO.13.46.1 Finishing walls with acrylic smooth exterior paint of required shade - New work (two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg / 10 sqm

CODE NO 13.61.1 Painting with synthetic enamel paint of approved brand and manufacutre to give an even shade - Two or more coats on new work

CODE NO 31.259.1A Supplying of 3.5/ 4x25 sqmm underground cable (Paragon/suncab/Empire) complete.-upto 25HP pumpset.

CODE NO. 31.261.1 Supplying and fixing of meter board of size 600mmx900mmx150mm on suitable angle frame with suitable water proof plywood 12mm thick for receiving ED supply. The board frame shall be painted and covered on all sides by 16 gauge M.S. sheet and fixed with 3 Nos. of 100 Amps fuse carrier (Havells/Standard/Anchor make) with screws etc., complete.

CODE NO.31.264.1A Supplying and fixing of copper wire 8 SWG (4 mm dia) for earthing arrangements including bolt and nuts etc., complete.

CODE NO. 31.265.1 Providing and fixing 50 mm dia GI pipe (Class B) conforming to IS 1239 (Part 1:1990) with GI fittings including trenching, refilling etc., complete for UG cable duct.

CODE NO. 31.275.1D Laying of under ground cable direct in ground including metal road cutting,excavation of earth, sand cushion, brick protection, back filling etc., complete. - above 50 sqmm

El. PSR CODE NO.1.17.1 Supplying and drawing following sizes of FRLS PVC insulated copper conductor single core cable in the existing surface / recessed steel / PVC conduit as required -1 X 1.5.

El. PSR CODE NO.1.17.11 Supplying and drawing following sizes of FRLS PVC insulated copper conductor single core cable in the existing surface / recessed steel / PVC conduit as required -2 x 2.5 sq.mm.

El. PSR CODE NO. 1.17.20 Supplying and drawing following sizes of FRLS PVC Insulated copper conductor single core cable in the existing surface / recessed steel / PVC conduit as required -2 x 4 sq.mm

El. PSR CODE NO.1.21.1 Supplying and fixing of following sizes of medium class PVC conduit along with accessories in surface / recess including cutting the wall and making good the same in case of recessed conduit as required - 20mm

El. PSR CODE NO. 1.21.2 Supplying and fixing of following sizes of medium class PVC conduit along with accessories in surface / recess including cutting the wall and making good the same in case of recessed conduit as required - 25mm

El. PSR CODE No.1.24.1 Supplying and fixing following modular switch / socket on the existing modular plate & switch box including connections butexcluding modular plate etc. as required - 5/6 A switch

El. PSR CODE No.1.24.3 Supplying and fixing following modular switch / socket on the existing modular plate & switch box including connections butexcluding modular plate etc. as required - - 15/16 A switch

El. PSR CODE No.1.24.4 Supplying and fixing following modular switch / socket on the existing modular plate & switch box including connections butexcluding modular plate etc. as required - - 3 pin 5/6 A socket outlet.

El. PSR CODE NO.1.27.4 Supplying and fixing following size / modules , GI box per alongwith modular base & cover plate for modular switches in recess etc. as required - 6 module (200 mm x 75 mm)

El. PSR CODE NO.1.28.4 Supplying and fixing following Modular base & cover plate on existing modular metal boxes etc.as required -- 6 module

El. PSR CODE NO.1.58 Supplying and fixing PVC batten / angle holder including connection etc.as required.

El. PSR CODE NO.5.1 Earthing with G.I. earth pipe 4.5 meter long, 40 mm dia including accessories , and providing masonry enclosure with cover plate having locking arrangement and watering pipe etc. (but without charcoal / coke and salt) as required

El. PSR CODE NO.SE (OM) LAD Approved Rate. Providing and fixing of 20W LED tube light fitting Make: Philips.