SPECIAL REPAIR TO PATHWAY WASHERMAN SHOP TO OR LIVING, JCO MESS TO KOTE KOTE TO MAIN OFFICE JOB NO. 41SA SR BLDG 02 2024-25 AND PROVN OF COVERED PATHWAY JOB NO 41SA RW 09 2024 25 AT SARAIBARI UNDER GE JORHAT.

Amount

NOTES :The bidders/contractors are advised to read tender document & all corrigendum/ amendments and General conditions of contracts before entry/quoting the rates.

Demolition of cement concrete ( un-reinforced) in ground floors and pavings n exc 15 cm thickness (below or above ground level) and removing debris to a distance n.exc. 50 m etc complete all as specified and as directed.

Material and labour for Hard core of gauge not exceeding 63 mm of broken stone or boulders , spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface

Material and labour for 100mm thick plain cement concrete M-15 (Nominal Mix) using 20 mm graded stone aggregate as in sub base floor complete all as specified and as directed.

Material and labour for outdoor antiskid vitrified paving tiles of size 300x300x10 mm thick, laid in floor over and including 15mm thick screed bed or bedding layer in cement sand mortar 1:6 complete all as specified and directed by Engr-in-charge.

M&L for forming 12 mm thick expansion joints 100 mm thick concrete floor , filled with pre-formed bituminous filler and top 30mm primed and sealed with sealing compound, Grade ‘A’ etc complete all as specified and as directed.

Demolition of Brickwork or stone/ boulder masonry, built in cement sand mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles of any description or any position etc complete all as specified and as directed.

M&L for Brickwork with subclass ‘B’ bricks, old size ,straight or curved on plan exc 6m mean radius built in cement sand mortar 1:6 etc complete all as specified and as directed.

M&L for Rendering 15 mm in Cement Mortar 1:6 on fair faces of brick work or concrete surfaces finished even smooth without using extra cement to the plastered surface complete all as specified and as directed.

Supply and fixing 110 mm bore PVC (SWR) pipes single socketed in any length with rubber ring joints fixed to walls etc with MS galvanised clamp of flat iron of size 25mm x 3mm including necessary nuts , bolts etc complete all as specified and directed.

Supply and fixing PVC (SWR) bend of 110 mm bore complete all as specified and directed.

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demolition) ) in Roofs, floors (other than ground floors), beams, staircases, landing, chajjas and similar suspended work removing debris to a distance n.exc. 50 m etc complete all as specified and as directed.

M&L for precast cement concrete M-15 (Nominal mix) using 20 mm graded stone aggregate as in cover slabs (for man holes etc.) , shelves and similar articles with plain face etc complete all as specified and as directed.

Material and labour for TMT Bars Fe 500D 10mm dia & over cut to length bent to shape required inculding cranking bending spirally hooping for columns etc and binding with MS wire ennealed less than 0.9mm dia or securing with clip complete all as specified and directed.

Material and labour fo TMT bars Fe 500D of 6 mm dia and over upto and including 10 mm dia in stirrups, spacers and binders, cut to length, bent to shape required including cranking, bending spirally and binding with and including mild steel (annealed) wire not less than 0.90 mm dia etc complete all as specified and as directed.

Material and labour plain cement concrete M-15 (Nominal Mix) using 12.5 mm graded stone aggregate as in coping and similar work including necessary formwork complete all as specified and as directed.

Excavation in trenches not exceeding 1.5 m wide and not exceeding 1.5 m in depth for foundation etc. or for shafts, wells, cess pits, manholes, pier holes etc. not exceeding 10 Sqm on plan and not exceeding 1.5 m in depth and getting out as in soft/loose soil. etc complete all as specified and as directed.

Removing excavated material (soil) not exceeding 50 m and depositing where directed at a level n. exc. 1.50 m above the starting point.

Material and labour for Plain Cement Concrete M-7.5(Nominal Mix) using 40 mm graded stone aggregate as in foundation filling and mass concrete complete all as specified and directed.

Excavating in post holes (or similar holes) in soft / loose soil each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, complete all as specified and directed.

Material and labour for Plain Cement Concrete M-10(Nominal Mix) using 40 mm graded stone aggregate as in foundation filling and mass concrete complete all as specified and directed.

S&F rolled mild steel works as in Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment conforming to Fe-410- W(Gde-E-250) quality-B etc complete all as specified and as directed.

S&F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes, nuts and bolts and welded ,conforming to I. S.1161- grade St.-240 including painted one shop coat of zinc chromate primer paint etc complete all as specified and directed.

Supply and fixing of pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick and an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and as directed.

Supply and fixing of pre-painted galvatume aluminum zinc coating GI based plain steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in ridges, tips, valley, gutters, length & girth as fixed with nail or screws complete all as specified and as directed.

Material and labour for preparation of new steel surface and applying two coats of black bituminous paint over on new steel and iron surfaces of any description over exceeding 10 cm in width or girth complete all as specified and as directed..

Material and labour for preparation of new steel surface and applying two coats of synthetic enamel paint over a coat of red oxide primer on new steel and iron surfaces of any description over exceeding 10 cm in width or girth complete all as specified and as directed..

Material and labour for preparation of new or previously untreated surfaces of wall and applying three coats of white wash etc complete all as specified and as directed..

Note: Schedule of credit (SCHEDULE OF CREDIT) amount of Rs ₹ ___________ mentioned on Page No ____ shall be deducted from the total quoted amount of BOQ.

A M CHOUDHURY AND CO (BID ID -3094962)

M/S P.G CONSTRUCTION (BID ID -3094817)

M/S AK SINGH (BID ID -3095059)

Chief Builders &Consultants (BID ID -3094977)

SUBHAS CONSTRUCTIONS (BID ID -3095541)

A K DUTTA CHOWDHURY AND CO (BID ID -3094967)

M/S RAJIB GOSWAMI ENTERPRISE (BID ID -3095409)