Conversion of existing old ...

Amount

Part-A (Non- Schedule Items)

Supply and Laying of PVC insulated (Heavy Duty) underground copper conductor 1.5 sqmm 12 core armoured cable suitable for A.T.C Signals 660:1100 volts below ground level in existing or in trench, confirming to BIS (Last amended)/HRY PWD specification of National/Havells/ Polycab/ Kalinga - OEM Make in India as approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Supply & Laying of cable 1.0 sq.mm, copper flexible 6 core cable (junction box to lights), confirming to BIS (Last amended) / HRY PWD specification and approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Supply & laying of DWC pipe (110 mm /95mm id) Grading PE 63 conforming to IS 14930, trench-less at required depth without obstructing the underground structures (For laying 1.5sqmm 12 core & 6 core cables as mentioned at serial no 1&2) through this pipe to connect respective poles to control box).By Hydraulic Drilling Device without cutting of the road top surface, from the feeding point to the feeder pillar box in median (OR) from feeder pillar to respective traffic light pole including cost of all accessories for road crossing for laying of cables, complete in all respects including the cost of all required accessories and bring the site in its original position, upto the entire satisfaction of engineer-in-charge, confirming to HRY PWD specification/IRC specifications and approved by competentauthority.

P/F of camera-based Vehicle Detector (for counting and Classification of vehicles) at each arm of the traffic junctions. The detector to be managed through web-based interface. The outputs of the detectors shall indicate the presence of vehicles and shall be used to influence the operation of the traffic signal controller and shall generate counts. SI has option to install Camera on the Traffic pole. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Supply and erection of Solar system including the cost of 2 Nos. battery 12 volt, 100AH, 1 No. solar charger controller 12/24 Volt, solar panel 12v/400 watt, structure for solar panel to be fixed on cantilever fixing,1 No Inverter, MS ironwater proof box for battery as per relevant IS/BS Standard, with foundation complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in-charge, confirming to BIS (Last amended) and approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Removal / shifting /placing of existing Solar system with UPS, battery and M.S. box at new/same place including the cost of all required accessories with commissioning upto the entire satisfaction of engineer-in-charge. Note:- In case of any damage /loss/theft during removal/shifting the entire responsibility will beon the part of contractual agency, in that case same will be replaced by new one by contractual agency at his own cost.

Supply & Erection of 300mm dia Signal Heads ofpure polycarbonate material with LED RED, GREEN ARROW AMBER retrofit kit , EN certified, CE as per EN-12368 complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in- charge.RED, AMBER Green Arrow. Confirming to BIS (Last amended)/ IRC specifications and approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Removal / shifting /placing of LED aspect at new/same place including the cost of all required accessories with commissioning upto the entire satisfaction of engineer-in-charge. Note:- In case of any damage /loss/theft during removal/shifting the entire responsibility will beon the part of contractual agency, in that case same will be replaced by new one by contractual agency at his own cost

Supply & Erection of 300mm dia Signal Heads of pure polycarbonate material with led retrofit kit , EN certified, CE as per EN-12368 Pedestrian Green/Red Pedestrian complete in all respects including the cost of all requird accessories upto the entire satisfaction of engineer-in-charge, confirming to BIS (Last amended)/ IRC specifications and approved bycmpetent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Supply & Erection of Microprocessor, based full matrix on reverse countdown timer 320mm x 320mm display character heights 240mm for ATC signals to depict the timings of RED straight or side Green Timings independently complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in- charge, confirming to BIS (Last amended)/ IRC specifications and approved bycompetent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Removal / shifting /placing of Microprocessor based reverse countdown at new/same place including the cost of all required accessories with commissioning upto the entire satisfaction of engineer-in-charge. Note:- In case of any damage /loss/theft during removal/shifting the entire responsibility will beon the part of contractual agency, in that case same will be replaced by new one by contractual agency at his own cost.

Supply & Erection of vehicle actuated road traffic signal Master Controller with slave controller of full configuration to signal functionsignal properly, incasing in metallic control cabinet (suitable to house Microprocessor controller, master controller/ switching control) fixed on RCC foundation of required size & depth. Confirming to BIS (Last amended)/ IRC specifications and approved by competent authority. (Note: - (1) No extra payment will be made for metallic control cabinet and RCC foundation forfixing metallic control cabinet) (2). Traffic signal controller shall permit settingof timings with locally and also give access for remote control through Ethernet/IP/GSM/Wifietc connectivity. The controller shall also provide IP interface to bring the signal to ICCC and monitoring and management, min 2 spareIP ports shall be available. Integration of trafficsignals to ICCC shall be responsibility of contractor. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Removal / shifting /placing of controller with box at new/same place including the cost of all required accessories with commissioning upto the entire satisfaction of engineer-in-charge. Note:- In case of any damage /loss/theft during removal/shifting the entire responsibility will beon the part of contractual agency, in that case same will be replaced by new one by contractual agency at his own cost.

Construction of Concrete foundation for Hexagonal standard pole / cantilever galvanized octagonal pole , RCC foundation 1:1.5:3 for size 600x600x1800mm with minimum 12 mm dia 8 nos main reinforcement rods with rings of 8mm dia @ 150mm c/c and J-hook rods of required length & dia (20mm-25mm dia )with MS plate 600x600x12 mm thick for fixing the pole with all labour and material required to complete the job, complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in- charge, confirming to HRY PWD specification/IRC specifications and approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT. The foundation design shall take into consideration, the local soil condition and shall be approved by the competent authority

Construction of Concrete foundation for Hexagonal standard pole / Straight pole, RCC foundation 1:1.5:3 for size450x450x1200mm with minimum 12 mm dia 8 nos main reinforcement rods with rings of 8mm dia @ 150mm c/c and J-hook rods of required length & dia (20mm-25mm dia )with MS plate 450x450x12 mm thick for fixing the pole with all labour and material required to complete the job, complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in- charge, confirming to HRY PWD specification/IRC specifications and approved by competent authority. The foundation design shall take into consideration, the local soil condition and shall be approved by the competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Supply of Cantilever (6.5+0.5) = 7 mtr. long Galvanized octagonal pole having top dia 100mm bottom dia 200 mm with a base plate is320 x 320 x 20mm. pole sheet thickness is 4mm,with a suitable arm of (4+2)=6 mtrs with a thickness of 3mm having a top dia of 75mm, bottom dia 100mm, with suitable foundation accessories nut bolts, i.e. 25mm dia 4 nos 850mm along with junction box in pole with steel rope) specification and steel grading shall be as per BSEN 10025 complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in- charge, confirming to HRY PWD specification/IRC specifications and approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Removal / shifting /placing of Cantilever pole at new/same place including the cost of all required accessories with commissioning upto the entire satisfaction of engineer-in-charge. Note:- In case of any damage /loss/theft during removal/shifting the entire responsibility will beon the part of contractual agency, in that case same will be replaced by new one by contractual agency at his own cost.

Supply of standard Hexagonal pole 4 mtr. Top dia 90mm, bottom dia 140mm, thickness 3mm with base plate 200x200x12mm with suitable foundation accessories nut bolts, i.e. 25mm dia 4 nos 850mm along with junction box in pole. Specification and steel grading shall be as per BSEN 10025 complete in all respects including the cost of all required accessories upto the entire satisfaction of engineer-in-charge, confirming to HRY PWD specification/IRC specifications and approved by competent authority. Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Removal / shifting /placing of Standard pole at new/same place including the cost of all required accessories with commissioning upto the entire satisfaction of engineer-in-charge. Note:- In case of any damage /loss/theft during removal/shifting the entire responsibility will beon the part of contractual agency, in that case same will be replaced by new one by contractual agency at his own cost.

Workstation as per technical specifications Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Switch 8 port 10/100 Base T as per technical specifications Note: - Detail of Technical & Functional specification are mentioned in Section- 10 in addtional document of HEW portal of this DNIT.

Any other item required to meet the end objective of ATCS system (details of items/activity to be indicated with quantity and cost).

Part-B Scrap Qty of existing traffic signal lights in GMDA area, Gurugram with minimum total reserve price of scrap quantity to be Rs.33,94,265/-

PVC insulated (Heavy Duty) underground copper conductor 1.5 sqmm cable.

PVC cable 1.0 sq.mm, copper flexible 6 core cable (junction box to lights).

HDPE pipe

Solar system including of battery 12 volt, 100AH and1 No. solar charger controller

Inverter / UPS system

300mm / 200mm dia Signal Heads ofpure polycarbonate material with LED RED, GREEN ARROW AMBER retrofit kit.

Microprocessor, based reverse countdown timer.

4 phase vehicle actuated road traffic signal controller, Microprocessor based controller.

Master controller vehicle actuated road traffic signal controller wireless CDAC technology.

Slave controller for wireless signal with CDAC technology.

Demolition of Concrete foundation for Hexagonal standard pole / cantilever galvanized octagonal pole including shifitng of all debrise from site of work.

Cantilever (6.5+0.5) = 7 mtr. long Galvanized octagonal pole having top dia 100mm bottom dia 200 mm with a base plate is320 x 320 x 20mm. pole sheet thickness is 4mm,with a suitable arm of (4+2)=6 mtrs with a thickness of 3mm having a top dia of 75mm, bottom dia 100mm, with accessories nut bolts, i.e. 25mm dia 4 nos 850mm along with junction box in pole with steel rope.

standard Hexagonal pole 4 mtr. Top dia 90mm, bottom dia 140mm, thickness 3mm with base pate 200x200x12mm with all accessories.

Technosys Security Systems Private lImited