Additional Development work of ITI Building at Sarada, District Udaipur (Including Cost of Cement)

Providing and laying in position cement concrete including curing, compaction etc. complete in specified grade excluding the cost of centering and shuttering - All work up to plinth level. "M10 grade Nominal Mix 1: 3: 6 (1 cement : 3 coarse sand : 6 graded stone aggregate 40mm nominal size)."

Steel work in built up tubular trusses including cutting, hoisting ( height upto 10 m)fixing in position and applying a priming coat of approved steel primer, welded and bolted including special shaped washers etc. complete. Hot finished seamless type tubes.

Providing corrugated G.S. sheet roofing including vertical / curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead and including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (upto any pitch in horizontal/ vertical or curved surfaces) excluding the cost of purlins, rafters and trusses and including cutting to size and shape whenever required. 0.63 mm thick with zinc coating not less than 275 gm/m2

a) Planting Permanent Hedges including Digging of Trenches (Planting permanent hedges including digging of trenches, 60 cm wide and 45 cm deep, refilling the excavated earth mixed with farmyard manure, supplied at the rate of 4.65 cum per 100 metres and supplying and planting hedge plants at 30 cm apart)

S & F tube well cover of M.S.sheet (6mm thick) with nuts and bolts complete for casing size: 200mm dia

S & F M.S. clamp, set of 50 ×6mm flat iron with nuts and bolts etc. for holding the riser pipe assembly of submersible pump set.

Providing & lowering of G.I. Pipes, flange pipe including rubber washer and nuts of 8 mm dia complete in all respect I.S.1239 Marked. B Class 50 mm dia

P & F Full way Valve (IS: 778 Mark) or wheel valve of approved make Gun metal 50mm nominal bore)

Earth work in excavation over area ( exceeding 30 cm in depth. 1.5 Mtr in width as well as 10 sqm on plan) including disposal of excavated earth lead up to 50 m and lift up to 1.5 Mtr. Disposal earth to be leveled and neatly dressed.All kinds of soil

Providing and fixing anodized aluminium work (Anodizing to be got done from approved Anodizer) for doors, windows ventilators and partition with extruded built up standard tubular and other sections of approved make conforming to IS : 733 and IS 1285 anodised transparent and dyed to required shade according to IS : 1868. (Minimum anodic coating of grade AC 15), fixed with rowel plugs and screws or with fixing clips or with expansion hold fasteners including necessary filling up of gap at junctions, at top, bottom and sides with required PVC/neoprene felt etc. Aluminium section shall be smooth rust free straight, mitred and jointed mechaincally wherever required including cleat angle Aluminium snap beading for glazing /panelling , C.P. brass/ stainless steel screws, AI. Tower bolt & AI handle & Al. Aldrop etc. all complete as per architectural drawings and the directions of Engineer-in-charge. (Glazing and panelling to be paid for separtely). For fixed portions