SPECIAL REPAIR TO COMPOUND WALL NEAR BLDG NO P 201BLDG NO T 15 AND T 16 PROVN OF ALUMINIUM CABIN RETAINING WALL AND CERTAIN IMPROVEMENT IN RAIN SHED UNDER GE BIRCHGUNJ PORT BLAIR

Amount

Excavation in trenches n.exc 1.5m wide and n.exc 1.5 m depth for foundation and getting out hard dense soil complete all as specified and as directed.

Excavation over areas n exc. 1.5m deep in Soft/disintegrated rock complete all as specified and as directed.

Returning, filling in, including spreading /back filling of retaining walls using approved earth obtained from excavation and well ramming in layers not exc 25 cm thick complete all as specified and as directed

Back filling of retaining walls using approved earth obtained from excavation including spreading, levelling, watering and well ramming in layers n.exc 25cm complete all as specified and as directed

Removing excavated material n exc. 50 m and depositing where directed at a level n exc. 1.5 m above the starting point complete all as specified and as directed

Material and labour for Boulder of gauge 40 to 80mm filling dry, hand packed tightly as in weep holes complete all as specified and as directed.

Dismantling Plain or corrugated steel sheeting, any gauge, thickness, including Nainital or similar pattern roof coverings

Taking down cement plaster on brick/stone or concrete surfaces including hacking for key , scrubbing down with water etc complete all as specified and as directed

Dismantling of floor, hearth or wall tiling including cement mortar bedding (but not backing) and removing the rubbish off the premises complete all as specified and as directed.

Taking down chowkat with shutter without taking off shutters from the frame n.exc 1.5 Square metre complete all as specified and as directed

Taking down chowkat with shutter without taking off shutters from the frame exc 1.5 Sqm but n exc 4 sqm complete all as specified and as directed

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and as directed

Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness (below or above ground level) etc complete all as specified and as directed.

Demolition of precast concrete articles, built in cement mortar, disposal of unserviceable material, debris and rubbish to a distance n exc 100m complete all as specified and as directed.

Demolition of RCC in ground floors and pavings exc 15 cm thickness but above ground floors (reinforcement cut as required to facilitate demolition) incl disposal of debris and rubbish to a distance n exc 100m complete all as specified and as directed.

Demolition of Reinforced Cement concrete (reinforcement cut as required to facilitate demolition) of Roofs, floors, beams staircases, landings, Chajjas, and Similar suspended work complete all as specified and as directed

Material and labour for Rendering 10mm thick in CM 1:6 on fair faces of brick work or concrete surfaces of walls, finished even and smooth (without using extra cement) complete all as specified and as directed.

Material and labour rendering 10 mm thick on fair faces of concrete roof slab and parapets in cement mortar (1:4) mixed with WPC @ 3% by weight of cement for application of water proofing treatment, complete all as specified and as directed. (Note : Supply only WPC shall be measured & paid separately)

Material and labour for Rendering 15mm thick on external faces of brick work or concrete surfaces in CM 1:4 complete all as specified and as directed

M&L for 15mm thick external rendering in two layers of 5mm thick in CM (1:4) mixed with water proofing compound (water proofing compound shall be used as per manufacturer’s instructions) over a coat of 10mm thick in CM (1:6) over brick or concrete surfaces finished even and fair. Note: Supply only WPC will be measured and paid separately

Material and labour for preparation of new plastered wall surfaces and applying two coats of cement base paint complete all as specified and directed.

Materials and labour for preparing the plastered surfaces on walls and applying two coats of colour washing (camouflage colours) over one coat of chalk white primer complete all as specified and as directed.

Supply only water proofing compound Make - conforming to IS-2645 1975.

Material and labour for oil bound distempering two coats including complete removal of old decorated, plastered or unplastered surfaces of wall complete all as specified and directed by Engineer - in -Charge.

Material and labour for Preparation of newly plastered surface of wall and applying two coats of Oil bound distemper over a coat of primer complete all as specified and as directed.

Material and labour for preparation of new steel surface exc 10cm width or girth and applying one coat of red oxide primer and two coats of synthetic enamel paint glossy complete all as specified and as directed.

Material and labour for two coats of weather proof exterior acrylic emulsion paint with anti fungal property over a coat of primer on newly plastered wall surfaces including preparation of surfaces etc complete all as specified and as directed.

Material and labour for two coat of weather proof exterior acrylic emulsion paint with anti fungal property on old painted wall surfaces over a coats of primer including preparation of surfaces by complete removal of existing treatment of any description complete all as specified and as directed.

Material and labour for TMT bars 10mm dia and over as in reinforcement cut to length, bent to shape required including cranking hooking ends and binding with mild steel wire (annealed) not less than 0.9mm dia or securing clips complete all as specified and as directed

All as per item No 29 here in before but 6 mm to 8mm dia.

All as per item No 29 here in before but 5mm dia and over upto and including 10mm dia in stirrups

Use and waste of Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams flat, rough finished surfaces complete all as specified and as directed.

Use and waste of Formwork to faces of walls, retaining walls, abutments, parapets and similar work for rough finished surfaces complete all as specified.

Use and waste of Formwork to faces of walls, retaining walls, abutments, parapets and similar work for Fair finished surfaces complete all as specified and as directed.

Use and waste of Formwork to sides of pillars, posts, struts, piers, columns flat, rough finished surfaces complete all as specified and as directed.

Use and waste of formwork to chullah hoods, chajjas, troughs and similar items including edges, etc complete all as specified and as directed by Engineer in Charge.

Material and labour for 75mm thick plain Cement concrete in type C1(1:3:6) using 20mm graded stone aggregate as in plinth protection and finished even and smooth with using extra cement complete all as specified and as directed.

Material and labour 100mm thick PCC (1:3:6) type C-2 using 40mm graded stone aggregate as in sub base of floor complete all as specified.

Material and labour for PCC 1:3:6 type C2 (using 40 mm aggregate) as in foundations, filling and mass-concrete complete all as specified and as directed.

Material and labour for RCC M-30 design mix 20mm graded stone aggregate in Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc, basement slabs, under-reamed piles and mass concrete complete all as specified and as directed.

Material and labour for precast cement concrete block masonry with solid block of PCC 1:3:6 type C1 (using 20mm graded stone aggregate) exc 10cm width and set in CM 1:4. complete all as specified and as directed.

Material and labour for cement concrete solid block masonry with block of precast cement concrete (1:2:4) type B1 using 20mm graded stone aggregate exc 10cm width and set in cement mortar (1:6) complete all as specified and as directed.

Material and labour for RCC M30 (design mix) in Walls, retaining walls, basement walls and the like; any thickness; complete all as specified and as directed.

Material and labour for RCC M-30 (design mix) design mix 20mm graded stone aggregate in Columns, pillars, piers, posts and struts complete all as specified and as directed.

Material and labour for Reinforced cement concrete M30 (design mix) in Chajjas complete all as specified.

Material and labour for Dark coloured vitrified tiles 10 mm thick (square/rectangular) polished, area of each tiles n exc. 0.36 sqm, in floors etc. set and jointed in neat cement slurry and pointed with coloured or white cement to match including screed bed 15mm thick 1:6, complete all as specified and as directed by Engineer-in-Charge.

All as per item No 46 here in before, but on vertical surfaces over and including 10mm thick CM 1:3 as in backing coat of dad/Skirting

Material and labour for 4.5mm thick Linoleum, plain coloured, laid dry in floors including stretching,cutting and fitting sealed down with an approved adhesive complete all as specified and as directed.

Supply and fix Aluminium anodised (minimum thickness is 15 microns) Partition frame/ Door / window / Ventilator/partition frames and shutters (02 Nos glazed & gauzed), side hung type, without sash bars, standard aluminium grills, necessary joining cleats, glazing clips, rubber packing, anodised aluminium snap beading, screws, handles, locking arrangements etc., complete with standard aluminium sections, complete all as specified and as directed by Engineer-in-charge.(Aluminium section shall be of make Jindal/Hindalco/ Indalco). (Note:- Weight of various Aluminium sections handles and locking arrangements shall only be considered for measurement for payment. However cost of rubber packing given in the item shall be deemed to be included in the rate quoted. Glass panels, prelaminated particleboards, aluminium wire cloth as applicable will be measured and paid separately as supplied only).

Supply only 4.0mm thick Sheet glass ordinary quality and glazing with oil putty in Square exc 0.5sqm in each pane complete all as specified and as directed. (Note : The rate of rubber packing is included in Sl item No 49 above)

Supply only 5.5mm thick sheet ordinary quality in squares exceeding 0.50 sqm in each pane complete all as specified and as directed. (Note : The rate of rubber packing is included in Sl item No 49 above)

Supply only Prelaminated particle board 12mm thick exterior grade for doors, prelaminated both side with decorative choice lamination , fixed with screws to aluminium frame complete all as specified and as directed.

Supply and fix Aluminium Die cast Body Door closer hydraulically regulated, designation No 3, universal type, suitable for door shutters of 851 to 1000 mm in width and of weight between 61 to 80kg and fixed

Supply and fix Pre-painted galvalume aluminium zinc coating GI based corrugated/ semicorrugated sheet 0.50mm thick as per approved profile, coloured, having tensile strength of 550Mpa as in roof covering/cladding to wall, fixed with self tapping screws all as specified

Supply and fix Pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50mm of an colour having tensile strength of 550Mpa as in ridges to wall, fixed with self tapping screws as specified

Supply and fix in repairs of push pull type rolling shutters made with 1.00mm thick mild steel laths, without ball bearing including top cover, anchoring rod, hasp and staple and one shop coat of primer erected in position complete all as specified and as directed.

M&L for false ceiling with aluminium grid work (size of grid 605x605mm) with 35x25x1.5mm main tee and 25x25x1.4mm, cross tee and wall angle and suspended with 3.15mm dia, GI wire, hooked to roof with needful adjustment bolts at an interval of 1.20m, centre to centre staggered and board with Eco board, decorative type, size 600x600x4mm thick, finished with two coats of oil bound distemper over a coat of primer on exposed surfaces, complete all as specified and as directed by Engineer-in-Charge.

Material and labour for Chequerred cement concrete tiles, with grey cement and pigment 30cm x 30cm x 20mm thick, set, jointed and pointed in neat cement slurry in floors including 15mm thick screed bed in CM (1:4) complete all as specified and as directed.

Material and labour for glazed polished finish chequerred cement concrete tiles of size 300x300mm x 25mm thick as in floor/Path, set & jointed in neat cement slurry and pointed with white cement and pigment to match, over and including 20mm thick bedding layer of cement mortar (1:6) complete all as specified and as directed.

Supply and fix PVC (SWR) pipes, single socketed, in any length, with rubber rings 110mm dia laid in trenches as in weep holes complete all as specified and as directed.

Supply and fix Aluminium anodised (minimum anodisation is 15microns) frames for parapet railing incl fixing to walls/RCC pillars by jambing, necessary joining cleats for frames, screws, etc., complete with standard aluminium sections, complete all as specified and as directed by Engineer-in-charge.(Aluminium section shall be of make Jindal/Hindalco/ Indalco).

Supply and fix 0.63mm thick Plain, galvanised, mild steel sheeting, in ridges, hips, valley gutters, drip and straight flashings (length and girth as fixed) with grade of zinc coating 275 complete all as specified and as directed.

Supply and fix MS work of Bands, straps, supports or stays for rainwater, ventilating pipes, including bolts, if required: hooks (stay), heavy, for large gates; hook and pintle hinges: large hasps and staples; chains; hand made sliding bolts; clamps; hold fasts; wall ties; hooks for hanging fans; plain angle cleats for securing purlins to wood trusses or rafters; knee piece inserts; two way and three way straps, plate washers and similar small articles conforming to Fe-290 Gde-E-165 complete all as specified and as directed.

MAJUMDAR FURNITURE

DISHA ENTERPRISES

MUKUL SALES AND CO

M/s Kanaka Agencies

Priya construction

DEEPAK AGENCIES