Purchase of Lab Equipments

Arduino trainer kit with Ultasonic sensor and Moisture Sensor to conduct following exercises: a) Interface Ultrasonic sensor with Arduino and measure the distance of the object. b) Interface Moisture sensor with Arduino and measure the moisture content in the soil.

Trainer kit with following components: Push Button, SPST, SPDT, Limit Switch, Low Voltage DC Motor, Transistor, Relay to conduct following exercises: i) Construct a circuit to get ON/OFF control on DC Motor using Push Button, SPST, SPDT and Limit Switch. ii) Construct a circuit to get ON/OFF control on DC Motor using Transistor and Relay. Specifications: Limit Switches (02 Nos) Mechanical, 125V AC, 5A DC Motors (02 Nos):12V/24V, low power (0.5-1A) Relay/Transistor:5/12V,1A, NPN (BC547 or similar)

Trainer kit with 3 Phase Induction Motor, control Switch and Clamp Meter to conduct following exercises: a) Connect Forward Reverse Controls witch to change the direction of rotation of three phase induction motor b) Measure the No-Load current in each phase using Tongue tester (ClampMeter) Specifications: 3Ph Induction Motor:0.5-1 HP; 415V AC, 3-Phase; RPM:1410 (no load))

Arduino trainer kit with Servo Motor and Potentiometer (e.g., SG90 or MG996R): 4.8-6V to conduct following exercises: a) Construct an Arduino based circuit to sweep the shaft of servo motor back and forth across 180 degree. b) Interface potentiometer with Arduino and based on its position get the control servo motor shaft

Photoconductive Cell (LDR) trainer kit with LDR, Ammeter, Voltmeter, DC Power Supply Unit and DC Motor with Optical speed Sensor to conduct following exercises: i) Construct a circuit to obtain the VI Characteristics and Response Characteristics of Photoconductive Cell(LDR). ii) Construct a circuit to measure the speed of the motor using Optical Sensor. Specifications: Ammeter/Voltmeter:Analog/Digital, Current up to 5A, voltage up to 30V DC, DC Motor with Optical speed Sensor: 12V DC, Optical encoder for speed sensing.

Tainer kit with Inductive and Capactive Prosimity sensors, Relay, Buzzer and Power Supply to conduct following exercises: i) Observe the behavior of Inductive prosimity sensor and Capactive Proximity sensor for different material samples. ii) Interface Relay and buzzer with sensors to test the output. Specifications: Inductive Proximity Sensor: Sensing range: 2-8mm; Voltage: 10-30V DC Output: PNP/NPN; Sensing metal objects Sensing range: 0-10mm; Voltage:10-30V DC Dects both metallic and non-metallic objects Relay: 5V/12V DC relay, SPDT/DPDT Buzzer: 5V/12V DC Power Supply: 5V/12V/24V DC, 1A