Addition Alteration of chajjas roof projection and balconies of certain buildings at Zone A NOFRA I and NOFRA II under AGE BR II area in GE Gomantak Vasco

Amount

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided complete all as specified and directed.

Demolition of cement concrete (unreinforced) of any description and in any position not otherwise specifically provided complete all as specified and directed.

Demolition of Brick Work/ sone work / concrete block wall built in Cement Mortar including all quoins, arches, pillars, etc. of any descriptions, complete all as specified and as directed.

Taking down Chowkats or frames with shutter (without taking off shutters from the frame) exc. 1.50 sqm and n. exc. 4.00 sqm each complete all as specified and directed.

M&L for Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with the including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed.

M&L for Mild steel TMT bars 6 to 8 mm dia, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with the including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed.

Use and Waste Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. for flat rough finish surface complete all as specified and as directed.

Use and Waste Formwork to sides of pillars, posts, struts, piers, columns and stanchions for square, rectangular or polygon rough finished surface of concrete complete all as specified and as directed.

Use and waste Formwork to soffits of suspended slabs such as roof slabs, floor slabs, chajjas, landings and similar work; not exceeding 200m thick (Horizontal or sloping) for flat rough finish surface complete all as specified and as directed.

M&L RCC M-30 (Design mix) using 20mm graded stone aggregate as in columns, pillars, piers, posts and struts and similar works complete all as specified and directed.

M&L for RCC (Design mix) , M-30 (20mm graded stone aggregate) in Beams, lintels, cantilevers etc complete all as specified and directed.

M&L RCC M-30 (Design mix) using 20mm graded stone aggregate as in slab, chajja supported on wall, beams and coloumns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and similar works complete all as specified and directed.

M&L for plain cement concrete 1:4:8, type D-2 (using 40 mm graded crushed stone aggregate) as in foundations, filling and mass concrete including sub base of under floors complete all as specified and directed.

M&L for 75mm thick cement concrete type C2 1:3:6 (using 40 mm stone graded crushed stone aggregate) as in plinth protection surface finished even and smooth without using extra cement including forming construction (dummy) joints 6 mm wide & 10 mm deep and filled with filler at an interval not exceeding 3 metre and at change of direction and necessary formwork complete all as specified and directed.

M&L for precast cement concrete block masonry, type C-1 (1:3:6) (20 mm graded aggregate) with solid blocks, exc 10 cm in width and setting in CM 1:6 complete all as specified and as directed.

M&L for rendering 15 mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:6 finished even and smooth without using extra cement complete all as specified and directed.

M&L for applying one coat of alkali resistant primer on plastered surfaces and applying two coat of oil bound distemper including preparation of new surfaces complete all as specified and directed.

M&L for rendering on fair faces of brick work or concrete surface or block masonary, 15 mm thick in two layers of 10 + 5 mm in CM 1:4, mixed with liquid water proofing compound as per manufacturer instructions finished the surface even and smooth without using extra cement complete all as specified and directed. Note:- WPC shall be measured and paid seperately

Supply only liquid water proofing compound

M&L for preperation of new surface wall/ceilling etc. applying a coat of primer and applying two coats of acrylic emulsion exterior paint (advanced anti fungal paint) complete all as manufacturers instructions and as directed.

Taking down cement plaster on walls/ceiling of any description including racking out joints hacking for key, scrubbing down with water etc. and removing rubbish complete all as specified and directed.

M&L structural steel work with rolled mild steel sections as in main and cross beams, hip and jack rafters, purlins where connected to common rafters and running rails and guides for sliding doors, fixed with angle cleats or other connecting plates etc and similar articles conforming to Fe-410-W (Gde E-250) quality-A complete all as specified and directed.

M&L for pre painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding fixed with self tapping screws including taking down existing GI sheet complete all as specified and directed.

M&L for preparation of new steel and iron surfaces of any description, over 10 Cm in width or girth, not otherwise described and painting with two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified & directed

M&L for preparation of new steel and iron surfaces of any description, over 10 Cm in width or girth, not otherwise described and painting with two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified & directed

M&L for preperation of old surface wall/ceilling by scrapping/ rubbing, applying, two coat of advanced anti-algal weather proof 100% acrylic smooth emulsion with silicon additives, over a coat of fibre reinforced elastomeric liquid water proofing membrane including filling cracks with water proofing compound complete all as per manufacturer instructions and as directed.

Removing building materials by truck or tractor with using of if necessary JCB machine and trolly load min 3.00 Cum each load including loading, unloading and stacking at the destination and depositing out side defence land complete all as specified and directed.

M&L for Replacement of steel reinforcement with TMT bars of appropriate size where 20% of cross section is reduced including dismantling of rusted steel including application of rust converter FEOVERT and applying protective coating IPNET-RB complete all as specified and directed.

Providing and laying Super fluid microconcrete-Roffe crete (or equivalent as specified in the list of brand names) for repairs in beam bottoms, columns, slabs etc. including mixing with 5 mm to 10 mm size aggregates, water proof plywood/steel plate shuttering, pouring, tamping, consolidating, curing etc complete as per manufacturer's specification and consultant's instructions including MS wire mesh minimum dia 2 mm complete all as directed.

Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing tiles and rubbish off the premises complete all as specified and directed.

M&L Vitrified Ceramic tiles 9 to 10 mm thick light shade (also in patches) square/ rectangular polished, area of each tiles not exceeding 0.36 sqm as in floors etc., set and jointed in neat cement slurry and pointed in white or coloured cement to match including 15 mm thick screed bed in CM 1:6 complete all as specified and directed.

K M SUBHANAIAH (BID ID -3112620)

SACHIN CONSTRUCTIONS (BID ID -3125106)

M/S G.N.POWAR (BID ID -3124420)

M/S jvsr constructions (BID ID -3112876)