REPAIR / REPLACEMENT OF SEWAGE LINE, CEANING OF SEWAGE LINES AND SEPTIC TANK, MANHOLES ETC IN ZONE -I AREA UNDER GE JAIPUR

Amount

M& L for comprehensively maintain in the AOR of AGE B/R I from all sewage problems like Disludging and cleaning of existing manholes of any size and shape, any depth by removing all sludge, waste, debries etc from man holes and cleaning with water, Cleaning of existing sewage lines of any dia of pipe line from manhole to manhole by manual/ mechanical rodding and remove all sludge, waste , debris etc from line, manhole to manhole by mechanical rodding, jet pressure rodding sets mounted on sewage cleaning tractor / trucks including Cleaning of all blockage of WC, bath, kitchen, WHB, traps, soil waste/ vent pipe ( vertical or laid in trenches / floor ant type /size ) suitable means including foreign material from manholes , traps, pits & including disposing of all sludge, waste, debries etc outside MOD land where directed. Note : 1 : Contractor shall deploy Min 5 nos labour daily & extra manpower required on any day, to maintain the sewage system shall be provided as & when required. 2. All daily compalint will be rectified within 24 hrs other wise Rs. 1200/- per complaint penal recovery will be deducted from contractor payments. 3. Attendance register of labour will be prepared by contractor and put up to Engineer-In-Change on daily basis for verification

Excavation in trenches not exc 1.5m wide and n exc 1.5m in depth, for foundation, etc or for shaft, wells, cesspits, manholes, pier holes, etc n. exc 10 Sqm on plan and not exc 1.5m in depth and getting out in soft/ loose soil.

All as per item No 2 above but depth exc 1.5m but not exc 3m.

Returning, filling in, including spreading, levelling, watering and well ramming in layers n.exc 25cm in soft/ loose soil.

Removing excavated material n.exc 50m & depositing where directed at a level n.exc 1.50m above the starting point in soil.

Demolition and breaking up drain pipes of dia 150mm, Salt glazed ware, AC or reinforced concrete complete all as directed

All as per item No 6 above but 200mm dia of pipe

Supply & laying DWC pipe (Double wall corrugated ) of class SN-4,IS-16098 Part –II) of size internal dia of 150 mm, laid in trenches and jointed complete with coupler, bend ,Tee, reducer etc complete all as specified & directed . Make :- Ultra plus DWCPE pipe of supreme/Corfit of prince/D -Rex DWC of astral or equivalent as approved by GE.

Supply & laying DWC pipe (Double wall corrugated ) of class SN-4,IS-16098 Part –II) of size internal dia of 200 mm ,laid in trenches and jointed complete with coupler, bend ,Tee, reducer etc complete all as specified & directed . Make :- Ultra plus DWCPE pipe of supreme/Corfit of prince/D -Rex DWC of astral or equivalent as approved by GE.

Demolition of stone or brick masonry built in cement mortar or cement lime mortar incl all quoins, arches, pillars etc but excluding ashlar facings, dressed stone work and precast concrete articles

M & L for Brick work with sub class ‘B’ bricks straight or curved on plan exc 6 mtr mean radius using old size brick built in CM 1:6 including raising height of man holes from ground level complete all as directed

M&L for walling of squared rubble, regular coursed, well bonded, bedded and solidly hearted, built in CM 1:4 all as specified

M & L for rendering 15mm thick on stone masonary surfaces or surface other than fair faces of brick work on wall in CM 1:4 finished even and smooth without using extra cement.

M&L for rendering 15mm thick in CM 1:4 on fair faces of brick work or concrete surfaces, finished even other than fair faces all complete all as specified using water proofing compound (Note : WPC shall be measured and paid separately)

M&L for PCC 1:2:4 type B-2, using 20mm graded stone aggregate as in surface channels and drains and benching including finishing the top of benching even and smooth with using extra cement

M&L for PCC 1:2:4 type B-0, using 12.50 mm graded stone aggregate as in coping and etcg including finishing the top of benching even and smooth with using extra cement complete all as directed

Extra for forming fair finished drain or channel 30cm inner girth in cement concrete, using extra cement including forms, moulds, mitred/ stopped ends etc. complete all as directed

M&L precast RCC 1:2:4 type B-1, using 20mm graded stone aggregate for manhole cover including placing over manhole all as specified including demolition of old RCC manhole covers. Note :- Reinforcement shall be measured and paid separately.

Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking , bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

All as per item No 19 above but 6mm to 8mm dia

S&F framed bracket of flat iron around manhole cover of any size, cut to shape welded, riveted etc complete all as specified

M&L PCC 1:4:8 type D-2 using 40mm graded stone aggregate in foundations, filling and mass concrete in sunken floor

Supply only intergal water proofing compound ISI marked

S&F PVC (SWR) floor trap of 75mm bore, with grating including jointing to waste pipe fixed in cement concrete type B-1, (1:2:4) complete all as specified & as directed.

Dismantling of cast iron drain pipe of 100mm bore, jointed in CM and taking out of in trenches. Note :- Excavation & earth work shall be measured and paid separately.

Dismantling of cast iron drain pipe of 75mm bore, jointed in CM and taking out of in trenches. Note :- Excavation & earth work shall be measured and paid separately.

S&F 75mm bore cast iron, sand cast soil, waste & vent pipe (ISI marked), in any length with or without ears fixed with cement joints, laid in trenches complete all as specified and directed.

S&F 100mm bore cast iron, sand cast soil, waste & vent pipe (ISI marked), in any length with or without ears fixed with cement joints, laid in trenches complete all as specified and directed.

S&F 100mm bore cast iron, sand cast soil, waste & vent pipe (ISI marked), in any length with or without ears fixed with cement joints, fixed on walls complete all as specified and directed.

S & F 75mm bore Cast iron soil, waste and vent pipes, in any length with or without ears with cement joints, fixed to wall, sand cast pipe

S&F 100mm bore cast iron branch piece, single ( equal or unequal), ordinary or inverted (spigot or socket type) or with parallel branches with oval access door

S&F CI cowl 100mm bore fixed to CI pipe complete all as specified and directed.

S&F SGSW gully trap square or round mouthed type 'P' of size 150mm x 150mm with CI grating including raising upto plinth protection with PCC 1:2:4 type B-1, and covered with stone slab complete

S&F as in repair vitreous china squatting pan (Orissa pattern) water closet (white) size 580mm x 440mm with integral foot rests ( excluding flushing cistern and flush pipe ) complete including connection to trap and flushing pipe antisyphonage pipe etc (Demolition of sunken floor treatment is included in this item.)

M&L for cleaning and removing all scale and dirt etc from tanks capacity exc 250 but not exc 500 ltr and from mouths of circulating pipes etc by using bleeching powder and replace the float valve as existing size and type all as specified

S&F in repair PVC (SWR) pipes 110 mm bore single socketed in any length with rubber ring joint fixed to walls all as specified.

S&F in repair PVC (SWR) pipes 75 mm bore single socketed in any length with rubber ring joint fixed to walls all as specified.

S&F in repairs PVC (SWR) pipes 110mm fittings such as bend, Tee, Socket etc all as specified

S&F in repairs PVC (SWR) pipes 75mm fittings such as bend, Tee, Socket etc all as specified

M & L Preparing newly untreated steel surfaces of any descripton over 10 cm wiidth or girth and applying two coat of synthetic enamel paints over a coat of red oxide primer complete all as directed.

S&F precast RCC soakage well including precast RCC cover (700-750mm dia & 40mm thick wall 250 mm height each) upto 8.00 m effective depth including excavation in any type of soil PCC complete all as specified & manufacturer instruction .

S & F PVC septic tank for 10 users (CCST - 300 -01) 1950 mm Height, 1650 mm dia, 50 mm dia inlet and outlet pipe, capacity 3000 ltr (3.00 Cum) having two separate integral compartment for proper settelement and decomposition of solid waste including fixing of inlet and outlet DWC pipe with seal proof and transportation including excavation in any type of soil and depth decided on position of inlet sewage line including PCC 1:4:8 type D2 using 40mm grded stone aggregate, complete all as specified and directed by Engr-in-Charge Make : Sintex, Polycon or equivalent as approved by GE.

S&F FRP (Fiber reinforced polysters) manhole cover of Size 600x900 rectangular shape minimuim weight not less than 20 kg each class of material is NP3 complete all as specified & directed.

Schedule of Credit

M/S JALANDRA CONSTRUCTIONS

JAGDAMBA CONSTRUCTION COMPANY