Ranipet District Thakkolam Town Panchayat KNMT Scheme LCV Supply

Amount

The quantities have given are those upon which the lump-sum tender cost at the work is caused but they are subject to alterations, omissions, deductions or additions as provided for in the conditions of the contract and do not necessarily show the actual quantities of the work to be done. The unit of rates noted below are those governing payment for extras or deductions for omission according to the conditions of the contract as set forth in the conditions and specification for the contract.

It is to be expressively understood that the measured work it is to be taken out (Not withstanding any customarily practice to the contrary according to the actual quantities when the place and finished accordingly to the Drawings or as may be ordered time to time by the Town Panchayat Engineer and the cost calculated by works connected there with. The rate quoted is for the works in site and complete in every respect.

The material required for the works must be supplied by the contractor and of the approved quality

Description of Work / Parameters

700 CC - 1250 CC - Displacement (CC) / Engine capacity.

20- 30BHP @ 2500 rpm and above - Max Power

5OONM @ 2000 rpm and above -Max Power

Diesel -Type of fuel

2 cu.rn -Load Capacity

BS -VI -Vehicle emission Norms

2 — 4 cylinder -No of cylinder in engine

3800 mm - 3950 mm -Length of chassis

1500 mm — 1550 mm. Ground clearance. 150 mm -165mm -Width of chassis

Diesel-30 Ltrs to 40 ltrs CNG- 12-25kg -Fuel tank capacity

145 R 1 2 — 5 N os. -Size of Tyre’s & No‘s

1900 mm — 2250 mm -Wheel base

1550 kg 1900 kg -Gross vehicle weight

Single plate dry friction diaphragm -Clutch

Manual -Transmission System

4 Nos Speeds(4F+ 1R) -No of speed/ forward gears

Manual / Power -Type of Steering

Shall be Fitted -Speed Governors

800Kg to 1000Kg -Pay Load

2100 mm-2200mm, Mild steel -Tipper body length

1400 mm - l500mm, Mild steel -Tipper body Width

750mm- 950 mm, Mild steel -Tipper body Height

2 mm, Mild steel -Side portion (LH & RH)& rear doors Sheet thickness

1.6mm, Mild steel -Tipper body top sheet including frame sheet thickness

1.2mm, Mild steel -Tipper Body Top Lid Sheet thickness

Tipper Container should be Fabricated with two doors on the rear side and four doors on four top corners of the containers with hinges and locking system. A partition shouId be provided on the middIe of container along the vertical len gth of the body. - Tipper Container

75 x 40 x 6 mm -Tipper Body Top Lid main Sheet thickness

Reputed Make - Hydraulic cylinder make

Main Engine -Hydraulic system driven

As per IS standard -Pump Make

Should be painted with one coat of Anti-corrosive epoxy primer and two coats of enamel paint for approved quality to ensure long lasting resistance for weatheri zing and breaka 9e. The color shade should be as per norms. -Pai nting

To be carried out as directed by Dept ofñcers -Lettering

Shall be with necessary locking facility .-Tipper body rear door

Shall be provided as per RTO requirement -Side safety guard -Side safety guard

Vehicle with fuel sensor and GPS tracking. -Additional conditions

25000KM//12 months whichever is earlier -Warranty Distance/Year.