PROVN OF SEPTIC TANK FOR TOILET OF GUARD POST NO 3 AND 7 FLOOR RESURFACING AT BLDG NO A66 AND SPECIAL REPAIR TO BOUNDARY WALL UNDER GE NARANGI

Amount

M&L Excavating over areas exceeding 1.5 metre deep and getting out in soft/loose soil complete all as specified and directed.

M&L surface excavation not exceeding 30 cm deep and averaging 15cm deep and getting out in soft/loose soil complete all as specified and directed.

Excavation in trenches n.exc 1.5m wide and not exceeding 1.5 m in depth for foundation etc, or for shafts, wells, cess pits, manholes, pier holes, etc. not exceeding 10 Sqm on plan and not exceeding 1.5 m in depth and getting out in soft / loose soil etc complete all as specified and as directed.

Excavation in trenches n.exc 1.5m wide but depth exceeding 1.50m and not exceeding 3.00 m beyond the first 1.50m complete al as specified and directed.

Returning, filling including spreading, levelling, watering and well ramming in layers not exceeding 25 cm each in soft / loose soil etc complete all as specified and as directed.

Removing of surplus excavated material not exc 50m and depositing where directed at a level n. exc 1.5 m above the starting point etc complete all as specified and as directed.

M&L PCC (1:4:8) type D-2 (using 40 mm graded stone aggregate) in foundation filliing and mass concrete complete all as specified and as directed.

M&L PCC (1:3:6) type C-2 (using 40 mm graded stone aggregate) in foundation filliing and mass concrete complete all as specified and as directed.

M&L for RCC 1:1½:3 type A1(20mm graded stone aggregate) nominal mix as in Foundations, including rafts, footings, foundation beams, plinth beams, bases for columns, etc, basement slabs, under-reamed piles and mass concrete etc complete all as directed.

M&L for RCC 1:1½:3 type A1(20mm graded stone aggregate) nominal mix as in beams, seimic bands, cantilevers, bressumers and lintels complete all as specified as directed.

M&L for RCC 1:1½:3 type A1(20mm graded stone aggregate) nominal mix as in Columns, pillars, piers, posts and struts etc.complete all as specified as directed.

M & L Precast RCC1:2:4 Type B-1 ( Using 20mm graded stone aggregate) as in landings, cover slabs ( for manhole etc) chullah hoods, chajjas , water toughs, mangers, shelves and similar articles with plain faces set in CM 1:4 complete all as specified and directed.

Use and waste for Formwork to edges of concrete flats, treads, breaks in floors,window cills, concrete railings, openings in concrete walls, floor and roofs not exceeding 20cm wide and sides of RCC/PCC bands in walls, horizontal or sloping and similar works exceeding 10cm but not exceeding 20cm wide complete all as specified and directed.

M&L Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified as directed.

M&L Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. complete all as specified as directed.

M&L Formwork to sides of pillars, posts, struts, piers, columns, and stanchions complete all as specified as directed.

Demolition of Brickwork or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles

M&L for brick work with old size sub class 'B' bricks straight or curved on plan exc. 6m mean radius and built in CM 1:6 etc complete all as specified as directed.

M&L for brick work with old size sub class 'B' bricks straight or curved on plan exc. 6m mean radius and built in CM 1:4 etc complete all as specified as directed.

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and as directed.

M&L TMT steel bars 10mm dia and over, cut to length, bent to shape required, incl cranking, bending spirally for hooping for columns, hooking ends and binding with the including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

M&L for mild steel TMT bars 5 mm dia and over upto and including 10mm dia cut to length, bent to shape required including cutting, cranking, hooking ends and binding with mild steel wire (annealed) not less than 0.90mm dia as in stirrups, spacers and binders complete all as specified and as directed.

S&F Rolled mld steel roof trusses ( framed) trussed purlins, crane gantries, rails and fastenings and heavy brackets framing ( Beam, tee, angle, channel or flat section) including distace pieces, cleats etc confirming to Fe 410-W ( Gde E-250 Quality A)complete all as specified & as directed.

S & F in repair galvanized two strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to RCC / steel post etc. including securing or tying at crossing with and providing of galvanized mild steel wire, staples or steel pins, etc. (each line of wire to be measured separately) complete all as specified and as directed.

Restraining and resuring including making good staple of galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing complete all as specified & as directed.

S & F providing and fixing 610mm dia Razor Concertina coil fencing with and including required clips, pins, etc. as per manufacturer's instruction and as per specification fixed on the Y angle. Each concertina coil shall be fixed to MS angle with existing rows of barbed wire on each of Y angle. There shalll be 80 ( eighty) circles in each 9.00 mtr length. Number of clips in each 9.00 mte shall be 200 Nos., central core wire 12 SWG hot galvanised high tensileed wire : UTS- 145-160 Kg/Sqmm. Razor strip 0.50mm thick hot dipped galvanised and of length 19mm, clips 1.5mm thick made of SSAISI 410 complete. ( Note: Measurment and payment shall be considered on length of security wall/ fencing and not actual length of concertina coil) complete all as specified and as directed.

M&L Cutting into existing manholes for connecting new drains, making good to pipes and rendering , cutting out existing benching for and forming branch channel ( 1/2 round or 3/4 section) in cement concrete 1:2:4 type B-1 smooth finished, and reforming benching as required for internal dia of pipe complete all as specified & as directed.

Roughening surfaces of old concrete floor by picking, sweeping clean and washing down with water to remove dust etc.complete all as specified and as directed .

M&L for 10mm thick Vitrified tiles light shade area of each tile n exc 0.36sqm laid in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match the colour of tile over and including 15mm thick screed bed in cement mortar 1:4 complete all as specified and as directed.

M&L for 10mm thick Vitrified tiles light shade area of each tile n exc 0.36sqm as in vertical surfaces such as skirting/dado etc set and jointed in neat cement slurry and pointed in white or coloured cement to match the colour of tile over and including 10mm thick screed bed in cement mortar 1:4 complete all as specified and as directed.

M&L for 15 mm thick rendering in CM 1:4 on brick/ concrete surfaces and finishing the surfaces even and smooth without using extra cement complete all as specified and as directed.

M&L broken glass coping on top of wall in CM 1:3 complete all as specified and as directed.

M&L for preparation of newly plastered surfaces of wall and applying two coats of cement base paint over a coat of alkali resistant primer complete all as specified and as directed.

M&L for preparation of newly plastered surfaces of wall and applying two coats of exterior emulsion weather coat paint over a coat of weather coat primer complete all as specified and as directed.

M/L PCC 1:3:6 type C-2 ( 40mm graded aggregate) as in concrete bed to drain pipe 110/150 mm dia including packing under , and haunching against the sides of pipes after they are laid and tested complete all as specified and directed.

S&F 75 mm dia PVC (SWR) pipes, single socketed in any length with rubber ring joints fixed to wall complete all as specified and directed.

S&F 110 mm dia PVC (SWR) pipes, single socketed in any length with rubber ring joints fixed to wall complete all as specified and directed.

S&F 150 mm dia PVC (SWR) pipes, single socketed in any length with rubber ring joints fixed to wall complete all as specified and directed.

S&F 75 mm dia PVC (SWR) vent cowl complete all as specified and directed.

S. R. TRADING

U S CONSTRUCTION