PROVN OF COVERED SHED FOR WAITING AREA OF JCOs/OR AND FAMILIES AT 178 MH GANGTOK

Amount

Excavating in post holes (or similar holes) each n.exc 0.5 Cum getting out and removing surplus soil to a distance n exc 50m and making good surfaces in soft/loose soil complete all as specified and directed.

M & L for cement concrete 1:3:6 type C2 using (40mm graded stone aggregate) as in foundation filling mass concerete complete all as specified

S&F for mild steel tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to IS-1161-1979 grade St-240 including one shop coat of zinc chromate primer paint ( including preparation of surface) at contractor's workshop before fabrication complete all as specified and directed.

M&L for pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 mpa as in roof covering fixed with self tapping screws complete all as specified and directed.

M&L for pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50mm thick of an colour having tensile strength of 550mpa as in roof covering fixed with self tapping screws complete all as specified and directed.

M&L for applying two coats of synthetic enamel paint over a coat of red oxide primer including preparation of new steel surface over 10cm width or girth complete all as specified and directed.

M & L for preparation of new steel surfaces n.exc 10cm width or girth and apply two coats of synthetic enamel paint over a coat of redoxide primer complete all as specified and directed.

Demolition of concrete of description and in any position not otherwise specifically provided for complete all as specified and directed.

M&L for MS flat iron bent to shape, holes drilled etc complete as in hold fast & wind ties etc including one coat of red oxide paint complete all as specified and directed.

Cutting holes in stone wall built in cement mortar or in cement lime mortar for inserting holdfast and making good dismantled portion in cement mortar 1:3 or cement conc 1:2:4 type B1 as required exc half brick wall but n exe one brick complete all as specified and directed.

M&L for plain cement concrete 1:3:6 type C2 (using 20mm graded stone aggregate) as in fixing of hold fast, bed blocks, and similar works etc including necessary form work as required complete all as specified and directed.

S&F powder coated grid frame work for false ceiling comprising of the following sections for making partitions of 600 x 600m size fixed to walls with rawl plugs & screws and hanged to roof with and including 2mm dia GI wire suspender of suitable length and butterfly clips, size of main tee shall be 28mm x 24mm x 3mm thick, cross tee shall be 28mm x 24mm x 3mm thick and wall angle shall be 24mm x 24mm x 3mm thick complete all as specified and as directed.

M&L 4 mm thick E-board for insulation and accoustic purposes, 595 x 595 mm in size,fixed with staple on snap gird as in ceiling with and including dusting of surface and applying two coats of oil bound distemper over a coat of primer complete all as specified and as directed.

M&L for rendering 15mm thick on fair faces of brick or concrete surfaces in cement mortar (1:6) finished even & fair complete all as specified and directed.

M&L for rendering 20mm thick in cement mortar 1:4 in two layers of 10mm each using WPC in finishing layer on brick or concrete surfaces finished fair & evencomplete all as specified and directed.(Note:WPC for finishing layer will be paid seperately as supply only).

Supply only integral water proofing compound.

M&L for 5mm thick in CM 1:3 in ceiling finishing the surfaces even and smooth without using extra cement complete all as specified and directed..

S & F machine pressed precast concrete interlocking paver block of approved shape and size confirming to IS 15658-2006 of 60 mm thick and M-25 grade with pigment as specified and directed.

M & Lfor sand filling as base of interlocking paver block including watering and consolidated completet all as specifed and as directed.

M & L for hard core of gauge not exc. 63 mm, deposited, spread and leveled in layers not exc. 15 cm thick, watered and rammed to a true surface using broken stone or boulders complete all as specified and directed.

M&L for 75 mm thick cement concrete 1:3:6 type C-2 (using 40 mm graded stone aggregate) as in path /steps laid with and incl use and waste of form work and finishing the surface even and rough to receive the topping layer or tiling complete all as specified and directed.

M&L for pre cast cement concrete hollow block masonry with hollow blocks, exc. 10 cm in width and settting in cement mortar 1:6 type C1 1:3:6 (20 mm graded aggregate) complete all as specified and directed.

S&F rolled section as in main and cross beams hip, jack rafters,hollow section purlins, where connected to common rafters and running rails and guides for sliddinng doors fixed with angle cleats or other connecting plates of grade Fe-410, complete all as specifed & directed.

Surface excavation n exc 30 cm deep and avg 10 CM deep and getting out in soft /loose soil etc complete.

Excavation in trenches n.exc 1.50m wide and n.exc 1.5m depth for foundation etc and getting out in soft/loose soil complete all as specified and directed.

M&L for mild steel TMT bars,10mm dia and over cut to length, bent to shape required including cranking ,bending spirally, hooping for columns, hookings/ends and binding with and including MS wire not less than 0.9 mm dia or securing with clips.

M&L for mild steel TMT bars 6mm to 8mm dia cut to length , bent to shape required, including cranking , bending and binding with MS wire , not less than 0.9 mm dia or securing with clip complete all as specified and directed.

M&L for walling of random rubble, masonry uncoursed, well bondded and solidly hearted, built in CM 1:6 complete all as specified and directed.

Removing excavated materials to a distance n.exc 50m and depositing where directed at a level n.exc 1.5m above the starting point complete all as specified and directed.

Returning filling in including spreading levelling watering well ramming in layers n.exc 25cm thick in soft/loose soil complete all as specified and directed.

M & L for applying two coats of weather proof exterior emulsion paint over a coat of white primer including preparation of new / wall surface complete all as specified and directed.

M&L for preparation of new plastered surfaces of walls and applying two coats of distemper dry, over a coat of chalk whitening putty complete all as specified and as directed.

M&L for RCC 1:2:4 (nominal mix) 20mm graded aggregate as in foundation, including rafts, footings, foundation, beams plinth beams bases for columns etc: basement slabs, under-reamed piles and mass concrete complete all as specifed and directed.

M&L for RCC 1:2:4 (nominal mix) 20mm graded aggregate as in columns,pillars,piers,posts and struts etc complete all as specifed and directed.

M&L for RCC 1:2:4 (nominal mix) 20mm graded aggregate as in beams, cantilevers, bressumers, lintels over 1.5m span complete all as specifed and directed.

M&L for Reinforced cement concrete nominal mix (1:2:4) (20 mm graded stone aggregate) for Chajjas complete all as specified and directed.

M&L for formwork to sides of concrete foundation, footings, bases of columns, raft and raft beams, sides & soffits (if any) foundation and plinth beam for rough finished surfaces of concrete complete all as specifed & directed.

M&L for form work to sides of pillars, posts,struts, piers, columns and stanchions for rough finished surfaces of concrete complete all as specifed & directed.

S&F for PVC (SWR) (Bore of pipe 110mm) pipes single socketed, in any length with rubber ring joints fixed to walls with necessary clamps, bolts etc complete all as specified and directed.

S&F for PVC (SWR) bends(Bore of pipe 110mm) any radius fixed to PVC Pipes/Steel Gutters etc complete all as directed.

M&L for formworks to sides and soffit of floor,roof beam, beam haunching, girders, bressummers, lintels, cantiliver shelves including support overhangs etc also splays between floor and beam etc complete all specifed and directed

M & L for PCC 1:2:4 type B-I ,(using 20 mm graded stone aggregate) as. in coping /benching to sides of foot path finished fair and even etc complete all as specified and directed.

M & L for applying two coats of cement base paint including preparation of new/ Old wall surface complete all as specified and directed

Note:- The contract sum shall be arrived at after deducting amount of schedule of credit from the total quoted amount.

STAR CONSTRUCTION

M/S ANIL KUMAR THAKUR

KAMLESH ENTERPRISE

SANJAY MITTAL

NISHA CONSTRUCTIONS

SHANTI KHAWAS AND SONS

KARMA TSETEN BHUTIA

M/S MANOJ VERMA

M/S S. S CHETTRI AND SONS

MAHENDRA KHAWAS