KOTTURPURAM IQ WORK

Amount

Excavating trenches of required width for pipes, cables, etc including excavation for sockets, and dressing of sides, ramming of bottoms, depth up to 1.5 m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20 cm in depth, including consolidating each deposited layer by ramming, watering, etc. and disposing of surplus excavated soil as directed, within a lead of 50 m : a) All kinds of soil

Pipes, cables etc. exceeding 80 mm dia. but not exceeding 300 mm dia

Surface dressing of the ground including removing vegetation and inequalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift upto1.5 m.

All kinds of soil.

Diluting and injecting chemical emulsion for POST-CONSTRUCTIONAL anti-termite treatment (including the cost of chemical emulsion): Treatment of existing masonry (both inner and outer walls) using chemical emulsion at300 mm interval including drilling of 12mm dia holes at 45 degree and plugging them with matching cement and chemically dipped chalk to the full depth of the hole:Treatment at points of contact of wood work by chemical emulsion (Fipnoril 2.92%Eco in oil or kerosene based solution) by drilling 6 mm dia holes at downward angle of 45 degree at 150 mm centre to centre and sealing the same.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :

1:2:4 (1 cement : 2 coarse sand(zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources)

Replacing the damaged or missed wall tiles wherever required in bath,toilets and at entrance and alaroung building wall wherever required of following size using tiles adhesives all complete as directed by the E-in-C

Wall tile size:300x200mm-10 nos-3 SQM and Eurocon aesthetic wall tile-Size-230x80mm-45 nos

Providing and fixing IS : 12817 marked stainless steel butt hinges with stainless steel screws etc. complete :

Providing and fixing aluminium die cast body tubular type universal hydraulic door closer (having brand logo with ISI, IS : 3564, embossed on the body, door weight upto 35 kg and door width upto 700 mm), with necessary accessories and screws etc. complete.

Providing and fixing aluminium sliding door bolts ISI marked anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with nuts and screws etc. complete :

Providing and fixing aluminium tower bolts ISI marked anodised (anodic coating not less than grade AC 10 as per IS : 1868 ) transparent or dyed to required colour or shade with necessary screws etc. complete :

Providing and fixing aluminium hanging floor door stopper, ISI marked, anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour and shade, with necessary screws etc. complete.

Twin rubber stopper

Easening of wooden door/window shutters of all sizes upto floor five level by removing the shutter,size the sides and rebate of frame and shutter by carpenter tools and refixing in position to give a smooth operation.(The rate includes necessary hinges)

Door shutters

Supply and placing of single mattress/ double mattress of approved make including conveyance charges for transporting the same to IQ all complete as directed by the E-in-C

single mattress ( sleep well or equivalent) with cotton bed spread fo required colour 182x91x12.5cm

Double mattress-1.83x183x12.5cm ( sleep well or equivalent King size) with bed spread of required colour in cotton.

Supply of pillows of standard size with cover of approved make ( sleep company or equivalent micro fiber filled pillow) all complete as directed by the E-i-C

Structural steel work in single section, fixed with or without connecting plate,including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete

Embedding the MS channel/angle post after earthing and providing required concrete mix including centering and shuttering, filling, compacting all complete as directed by the E-in-C. Size:300x300x450mm

Cleaning of entire terrace, portico top and similar locations and also Cleaning the khurras near rain water pipes with wire brushes to remove the settled dust, rubbish and waste and disposing the same to the nearest municipal dump.(Once in a year)

Residential complex upto terrace area of 200 Sqm.

Providing and fixing on wall face unplasticised Rigid PVC pipes of approved make FINOLEX or equivalent including jointing with sealant all complete

110 mm diameter

15 mm cement plaster on the rough side of single or half brick wall of mix :

1:6 (1 cement: 6 fine sand)

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade :

Two or more coats on new work.

Wall painting with acrylic emulsion paint, having VOC (Volatile Organic Compound ) content less than 50 grams/ litre, of approved brand and manufacture, including applying additional coats wherever required, to achieve even shade and colour.

One coat.

Two coats.

Finishing walls with Acrylic Smooth exterior paint of required shade :

Old work (Two or more coat applied @ 1.67 ltr/ 10 sqm) on existing cement paint surface).

Varnishing with flatting varnish of approved brand and manufacture one or more coats on old work.

Polishing stainless steel/ MS pipes handrail, balconies etc. using derusting chemicals of approved manufaturer all complete as directed by the E-in-C.

GF, FF, SF -staircase, corridor & balcony handrails

Cleaning of leather finish/ fabric sofa set to remove off dust , dirt using vaccum cleaner all complete to make it pleasing and usable as directed by the E-IN-C

Washing of available curtain cloth using approved washing liquid and fixing the same to make it pleasing all complete as directed by the E-in-C.

Deep cleaning of granite , kota stone flooring to remove off dirt, dust,stains etc by manually or required machines using necessary floor cleaning liquid all complete as directed by the Engineer-in-charge.

carpet area-GF-175 sqm, FF-160sqm, SF-160 sqm

Deep Cleaning dado tiles and flooring tiles, fittings such as Wasb basin, sink, WC pans, urinals , bibcok , stop cock and pillar cocks in Toilets and Bathrooms using pidilite T16 ROFF / CERA acid Chemials for tile flooring to remove dust,stain,rust spots etc. to facilitate comfort usage all complete as directed.

Cleaning and de-silting of gully trap chamber, including removal of rubbish mixed with earth etc. and disposal of same, all as per the direction of Engineer-in-charge.

Cleaning manhole chamber, removing the stagnated sewage water/ sludge, dust, silt, waste soil etc. and disposal of removed materials within 50m lead by taking earth pit and finally flushing the manhole with plenty of water to prepare the manhole to function properly. Due Care shall be taken while operating/ entering the manholes from direct inhaling of poisonous gases if any etc.all complete as directed .

Removing blockage in floor trap and cleaning the silt including cleaning with water etc. complete as directed by the Engineer in Charge

CREDIT for taking back the old unserviceable materials as deirected by E-in-C.

Full way gate valve with CI Wheel 20mm to 50 mm size

Trimming branches of trees which are hiding the centre of the road view alround the campus and close to the buildings in all blocks including disposing the same to the nearest municipal dump

Disposal of building rubbish / malba / similar unserviceable, dismantled or waste materials by mechanical means including loading, transporting, unloading to approved municipal dumping ground or as approved by Engineer-in-charge, beyond 50 m initial lead, for all loads including all lifts involved.

Providing and fixing G.I. chain link fabric fencing of required width in mesh size 50x50 mm including strengthening with 2 mm dia wire or nuts, bolts and washers as required complete as per the direction of Engineer-in-charge.

Made of G.I. wire of dia 4 mm

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete. A) Flexible pipe

32 mm dia

Providing and fixing Stainless steel floor grating of approved design complete.

Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings, including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and testing of joints complete as per direction of Engineer in Charge. : Internal work - Exposed on wall

25 mm nominal outer dia .Pipes.

Providing and fixing gun metal gate valve with C.I. wheel of approved quality (screwed end) :

25 mm nominal bore

Providing and fixing uplasticised PVC connection pipe with brass unions : a) 45 cm length

15 mm nominal bore

Providing and fixing C.P. brass bib cock of approved quality conforming to IS:8931:

15 mm nominal bore.

Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS:8931 :

15mm nominal bore

Cleaning On ground based / Over head tank (HDPE) two times a year (each time shall be paid separately) as directed by the Engineer in charge, which includes following operations by: (a) The water shall be drained out without causing inconvenience to the occupants. (b) The walls,floor and ceiling of the tank including cover shall be rubbed with brushes to clear any sediment the fungus, weeds, dust and green mass and the same shall be disposed to the nearest municipal dump. (c) The walls, floor and ceiling including cover shall be cleaned with water mixed with bleaching powder and finally cleaned with plenty of clean water.

Masonry tank size:O/O 2.20mx1.65mx1.35m

Sump size:O/O 5.8x2.87mx2.70m

Providing and fixing C.P. brass Two way bib cock of approved quality conforming to IS:8931:

15 mm nominal bore.

Providing and fixing C.P. brass pillar cock for basin mixer and geyser points of approved quality conforming to IS:8931 :

15mm nominal bore

Providing and fixing C.P. brass health faucet of standard design and of approved make.

15 mm nominal bore

Providing and fixing CPVC nipple to provide at over head tank all complete

25mm nominal bore

Servicing of casecade type flush tank by replacing the all inner units with the new and ensuring free flow of water all complete as directred by the Engineer-in-charge.

Constructing brick masonry manhole in cement mortar 1:4 ( 1 cement : 4 coarse sand ) with R.C.C. top slab with 1:1.5:3 mix (1 cement : 1.5 coarse sand (zone-III) : 3 graded stone aggregate 20 mm nominal size), foundation concrete 1:4:8 mix (1 cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size), inside plastering 12 mm thick with cement mortar 1:3 (1 cement : 3 coarse sand) finished with floating coat of neat cement and making channels in cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) finished with a floating coat of neat cement complete as per standard design : Inside size 90x80 cm and 45 cm deep including C.I. cover with frame (light duty) 455x610 mm internal dimensions, total weight of cover and frame to be not less than 38 kg (weight of cover 23 kg and weight of frame 15 kg) :

With Sewer bricks conforming to IS : 4885

Making connection of drain or sewer line with existing manhole including breaking into and making good the walls, floors with cement concrete 1:2:4 mix (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) cement plastered on both sides with cement mortar 1:3 (1 cement : 3 coarse sand) finished with a floating coat of neat cement and making necessary channels for the drain etc. complete :

For pipes 100 to 250 mm diameter

Repairing of aluminium glazed openable window by replacing the imax hinges, glass panes wherever required to make it smooth functionable all complete as directed by the E-in-C

Two shutter window-1.36x1.40

Three shutter window-1.8x1.4m

Taking out existing false ceiling tiles to remove off stains and dirt etc. using approved liquids and levelling the grid works to its true alignment and replacing the tile boards using necessary screws all complete as directed by the E-in-C