3064/10/E3

The following Job works are required to be carried out as addition/Altertion of existing AC Plant and misc E/M Works for providing negative pressure to Covid-19 ICU, Block at Military Hospital Meerut under AGE (Hosp) of GE (U) E/M Meerut Cantt :- 1. Taking down the existing pilenium , grills, disconnecting electrical connections , ecositiong ( white fire proof paper, glass wool ecositiong jali etc) and kept a side . After that fixing of exhaust fans -02 Nos (450 MM sweep) single phase 50 Hz, 220 Volts in return duct by extendng the branch duct of suitable size. After completing the fixing of exhaust fans and necessary repairs, re- assembling the same to its original position. And the elctrical connections were provided to exhaust fans by conncting the wire to the existing electric panel through MCCB FP 63 Amps. 01 Job complete 2. Taking down the return duct , and keeping the same as side and another pilenium fabricated at site including Supply, assembly and erection of GI sheet with C & SS rectangular/ square duct made out of 22 gauge 'L' /O/ rectangular / desired shaped hollow profile , duly factory boxed, including all accessories such as elbows, splinter dampers, vanes, hanhers, supports Corner, cleat, Carriage bolt, gasket and appropriate sealant on longitudinal joints and installing the exhasut fans -02 Nos (450 MM sweep) single phase 50 Hz, 220 Volts in pilenium etc including making hole in existing wall/ ceiling and making good disturbed surfaces complete all as specified . After fabrication of pilenium and extended branches of the return duct the pre filter -01 Nos & hepa filter -01 Nos re-assembling of the same to its original position and the exhaust fans are conectted to the power supply through the existing panel. 01 JOB Complete 3. Supply, assembly and erection of GI sheet for taking out 30 percent return air to open area, attached through the new pilenium and existing pilenium with C & SS rectangular/ square duct made out of 22 gauge 'L' /O/ rectangular / desired shaped hollow profile , duly factory boxed, including all accessories such as elbows, splinter dampers, vanes, hanhers, supports Corner, cleat, Carriage bolt, gasket and appropriate sealant on longitudinal joints and installing the exhasut fans -02 Nos (300 MM sweep) single phase 50 Hz, 220 Volts. 01 Job Complete 4. Supply & Installation of Magnahelly equipment for measuring the negative pressure-01 Nos. Certificate :- (i) It is certified that the funds are available in CH 87/479/01. (ii) Old material will be hand over to contractor against credit amount.

Jain Traders