GRAAM PANCHAYAT KULDOMARI KE HARIPUR NE NAIN ROAD SE HARDAYAL GOND KE GHAR TAK CC ROAD NIRMAN

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil as per SI.No. 2.8.1 DSR 2.31

Brick work with common burnt clay (non modular) bricks of class -150 in foundation and plinth in Cement mortar 1:4 (1 cement : 4 coarse sand) as per SI No- 6.1.1 DSR -2.35.3.1

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand (zone-lll) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) As per SI no. 4.1.8

Construction of embankment with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per Technical Specification Clause 301.5

GSB Grading-1 Construction of granular Sub-base by providing well graded material , spreading in uniform layers with motor grader on prepared surface mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as perTechincal Specification clause 401

WBM Grade-3 Providing, laying, spreading and compacting stone aggregates of 53mm to 22.4mm sizes (Crusher broken) to water bound macadam (WBM III) specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405.(WBM III)

Cement Concrete Pavement: Construction of un-reinforceced ,dowel jointed at expansion and consruction joint only, plai cement concrete pavement, thickness as per design ,over a prepaired sub base withh 43 grade cement or any other type as per clouse 1501 .2.2. M-30 grade corse and fine aggregates confirming to IS:383 maximum size of coarse aggregates not exeding 25 mm mixed in a concrete mixer of not less than 0.2 cum. capacity and apropreate weigh batcher using approoved mix design laid in a approoved fixed site form work (steel chanel ) laying and fixing of 125 micron thick polythene film wedges steel plates including levelling the form work as per drawing ,speading the concrete with shovels rackes, compacted using needle screed and plate vibrators and finished in continuous oparation including provision of contraction and expansion ,construction jointes, applying debonding strips, primer,sealant dowel bars ,near aproches to bridge /culvert and construction joints admixtures as approoved curing of concrete slab for 14 days.using curing compounds(where specified ) and water finishing to lines and grade as per drawing and technical specification clause 1501.

Supply and fixing of sign board, including painting, letting etc. complete