work of widening and strengthening of Kundarki Dingarpur Ratanpur Kalan Pakwada road for widening and strengthening of four lane road for special Economic Zone Industrial area of the state in Moradabad Distt Chainage 8-640 to 21-540

Amount

Excavation of trenches for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m (As per MoRTH specification clause No. 301)

Construction of embankment with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2. lead upto 1000 m. (As per MoRTH specification clause No. 305)

Construction of granular sub-base by providing close graded material, Grading-I spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density. (As per MoRTH specification clause No. 406)

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.(with bitumen emulsion SS-1@ 3.5% and OPC Cement @ 1% by wt. of mix)

Providing and applying tack coat with bitumen VG-10 using Bitumen pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom. (As per MoRTH specification clause No. 503) For DBM

Providing and laying dense graded bituminous macadam (G-2) with 100-120 TPH HMP producing an average output of 75 tonnes per hour using crushed aggregates of specified grading, premixed with bituminous binder @ 4.5 per cent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 507 complete in all respects.

Providing and laying bituminous concrete with 100-120 TPH hot mix plant producing an average output of 75 tonnes per hour using crushed aggregates of grading-II (13mm nominal size), premixed with bituminous binder VG-40 @ 5.40 per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No. 509 complete in all respects

Construction of un-reinforced,dowel jointed, plain cement concrete pavement over a prepared sub base with approve grade cement @ 400 kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler, separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compound, finishing to lines and grades as per drawing

Excavation in fundation in ordinary soil ( Loam,clau or sand ) including lift upto 1.5M and lead upto 30M and including filling wetering and ramming of excavated earth into the trenches of into the space between the bulding and the sides of foundation trenches or into the plinth and removal and disposal of surplus earth as the directed by the Engineer-in-charge upto a distance of 30M from the foundation trenches.( Where machine can not reach/move).For Building work only.(SI No-251

Cement Concrete with 4cm Guage Stone ballast conarse sand and cement concrete in proportion of 1:4:8 including supply of all meterials labour and T&P etc. requried for proper competion of the work. (SI no - 281)

R.C.C Work with cement approved coarse sand and 2cm gauge approved stone grit in proportion of 1:2:4 in lintels of doors. Windows and sunshades excluding supply of reingrorcment and its bending but including itr fixing and binding the same with 24 B.W.G.I binding wire and including necessary centering and suttering etc. and supply of all meterials. labour and T&P etc requried for proper completion of the work Binding wire to be supplied by the contractor free of cost including making of drip coarse.(SI No-283)

R.C.C Work with cement approved coarse sand and 2cm gauge approved stone grit in proportion of 1:1.5:3 in lintels of doors. Windows and sunshades excluding supply of reingrorcment and its bending but including itr fixing and binding the same with 24 B.W.G.I binding wire and including necessary centering and suttering etc. and supply of all meterials. labour and T&P etc requried for proper completion of the work Binding wire to be supplied by the contractor free of cost including making of drip coarse.(SI No-283-A)

Mild steel or iron in plain work such as reinforcment concrete or reinfocmend brick work ( when not including in an over all rates) wrought to requried shade as necessary including bending for proper completion of the work and including supply of all steel.(SI No 504)

Supply and fixing of 10 cm internal dia PVC pipe, 6 kg/ per sq.cm. pressure 10cm. Dia.(interned) or charminar make or any standard company complete with bands with door at top and plain at bottom and grating and including supply of necessary M.S. clamps 2.5 cm x 3 mm fixed to walls with and including supply of 10 cm long 6 mm dia Nuts and bolts including washers of required size. all materials, labour and T&P etc. required for proper completion of the work and also including repair of plaster, pointing etc. if damaged during fixing of the pipe. As Per S.I. No.-730(A)

Painting colour washing with priming and wall putti. As per SOR Item No. 660

M/S M A DEVELOPERS AND ENGINEERS (BID ID -4957679)

M/S M.A. ASSOCIATES (BID ID -4957725)