GE/BAS-79/22-23 REPAIR TO BOUNDARY WALL PATH FENCING DRAIN AND GATE ETC AT

Amount

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars etc but excluding ashlar facing ,dressed stone work and precast concrete article, complete all as specified and as directed.

M & L walling of random rubble stone maronary uncoursed well bonded, bedded and solidly hearted built in CM (1 : 6) complete all as specified and as directed.

Ditto- all as per item No -2 above but except stone, complete all as specified and as directed.

M & L brick work with subclass 'B' bricks straight or curved on plan exc 6.0 mean radius built in CM (1:6) complete all as specified and as directed.

All as serl item No 4 above but except brick, complete all as specified and as directed.

M&L for Extra over stone walling for hammer dressing with maximum depression on face from straight edge held against dressed surface not exceeding 40mm (on granite or trap stone) to face stones and dressing of face beds and joints as specified of random rubble walling, uncoursed or brought up to courses complete all as specified and as directed.

M & L flush pointing to random rubble stone masonary uncoursed in CM (1:4) complete all as specified and as directed.

M & L rendering 15mm thick on stones masonry surfaces or Brick/ Concrete surfaces in CM (1:6) finished even and smooth without using extra cement complete all as specified and as directed.

M&L for two coats of white wash on newly plastered surfaces of walls including preparation of surfaces, complete all as specified and as directed.

M & L for PCC (1:4:8) type D2 using 40mm graded stone aggregate as in foundations filling and mass concrete complete all as specified and as directed.

M & L cement concrete (1:2:4) type B2 using 40mm graded stone agg as in drains beds and surface channels etc complete all as specified and as directed.

M&L for PCC (1:2:4) type B-0 using12.5mm graded stone aggregate as in coping incl necessary from work complete all as specified

M & L rendering 15mm thick on stones masonry surfaces on Brick/ Concrete surfaces in CM (1:4) finished even and smooth without using extra cement including taking down cement plaster complete all as specified.

M & L rendering 15mm thick on stones masonry surfaces on Brick/ Concrete surfaces in CM (1:4) finished even and smooth without using extra cement complete as in Chajjas /Projection including taking down cement plaster all as specified.

M&L for preparation of newly plastered surfaces of walls and applying two coats of cement base paint complete all as specified and as directed.

M&L for applying Two coats of Apex emulsion paint as in walls/roof projection/chajjas complete all as specified and directed.

S&F MS works as in fencing posts and struts including cutting tops to bottom shape as directed, drilling holes notching for wire etc flat iron fillets for securing razor wire etc including all drilling bolting riveting etc and similar works conforming to FE 290 gde E-165 including excavation for post holes and fixing the post and strut with PCC (1:4:8) where required and applying two coats of synthetic enamel paint over a coat of redoxide primer on MS work and including fixing of Hexagonal bolts etc complete all as specified and as directed.

Ditto- all as per item No 17 above but in Refixing, complete all as specified and as directed.

S & F galvanised 2 strand steel barbed wire 2.24 mm dia barded with 2mm dia bar at 75 mm spacing and straining and fixing to any type of standard rail, standard bolts including securing or tying at crossing with and provn of galvanized mild steel wire staple or steel pins (Each line of wire to be measured) including taking down old barbed wire, complete all as specified and as directed.

M&L for restraining and resecuring of steel barbed wire fencing including making good staples etc complete all as specified & directed (each line of wire to be measured separately) complete all as specified and as directed.

S & F Punched tape concentrina coil of dia of coil 600 mm ,56 loops, 2.5 mm core wire,heavy galvanised ( wire 275 GSM),tensile strength of wire 1400-1500 N/sqmm ,Streatchable length 12 mtr including securying or tying at crossing with and provision of galvanised mild steel wire ,staples or steel pins etc comlete including taking down old concentina coil complete all as specified and as directed.

Dismantling structural steel work including doors, gates and any type of angles complete all as specified and as directed.

S&F framed work as in doors or gates of angle or other section with gusset plates ,rails ,braces .etc complete drilled for fixing of steel sheeting or other covering .Doors etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fitting (exclusive sttel sheeting) complete including two coat synthetic enamel paint over a coat of redoxide on MS as specified Gde Fe 410-W complete all as specified and as directed.

S & F 0.80 mm mild steel plain black sheet in wall claddiing steel gates and similar works , cut to size holes punched including round headed screws fixed sttel framing with plain 40 mm lap joints with riveted or welded seams including bending including two coat synthetic enamel paint over a coat of redoxide on MS complete all as specified and directed

Demolition of cement concrete (un-reinforced) in ground floors and paving not exceeding 15 cm thickness (below or above ground level ) complete all as specified and as directed.

M&L for 100 mm thick PCC 1:2:4 type B-2, using 40 mm graded stone aggregate,as in subbase complete all as specified and as directed.

M&L for 50 mm thick Sand filling/cushioning as in floor, foundation including watering and consolidation complete all as specified and directed.

M&L machine pressed precast concrete interlocking paver block any shape and size and any colour as per dirn of engr in charge , confirming to IS 15658- 2006 0f 60mm thickness with grey cement and pigment, M-35 grade complete all as specified and directed.

M&L for 50mm thick PCC 1:4:8, type D-2 using 40mm graded stone aggregates as in sub bases of floors and pavings, complete all as specified and as directed.

M & L Chequrred cement coloured tiles with grey cement and pigment 30cmx30cmx25mm thick set, jointed in neat cement slurry including CM1:6 complete all as specified and directed.

M & L for Durastone / Endura heavy duty virtified tiles of any colour as per dirn of Engr in charge and size 300mmX300mm 8 to9mm mm thick set jointed and pointed in neat cement slurry in floors with grey cement over 15 mm thick screed bed of 1:4 cementmortar finished ceemnt concrete surface fair & Smooth without using extra cementcomplete all as specified and directed.

M&L for Preparing old plastered or unplastered surfaces of walls and applying one coat of white wash, complete all as specified and as directed.

M&L for Preparing old plastered or unplastered surfaces of walls and applying one coat of cement based paint, complete all as specified and as directed.

M&L for applying One coat of Apex emulsion paint as in walls/roof projection/chajjas on Old surface complete all as specified and directed.

M&L for Mild steel TMT bars 10mm dia cut to length, bent to shape required incl crancking bending and hooping ends with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed.

M&L for RCC M-20(20mm graded stone aggregate) in manhole cover slabs/ drain cover supported on walls complete including required formwork including demolition of old Broken RCC covers complete all as specified and as directed.

Ms International Engineers

m/s pankaj soni

Amrik Construction co

Ms Dalip Kumar and Co.