REPAIR TO COMPOUND WALL CULVERTS DRAIN COVER SLABS ETC IN ZONE A INCLUDING CERTAIN ELECTRICAL WORKS UNDER GE I GOS

Amount

Demolition of RCC of any description and in any position not other wise specially provided for reinforcement cut as required to facilitate demolition complete all as specified and directed.

M&L for pre cast cement concrete 1:2:4, type B-1, using 20mm graded stone aggregate as in cover slabs (for manholes etc) and similar articles with plain faces, set in CM 1:4 complete all as specified and directed.

M&L for Mild Steel TMT bar 10mm dia and over cut to length bent to shape required including cranking, bending spirally for hoping for columns hooking ends and binding with & including Mild Steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

M&L for TMT Bars 5 mm dia & over upto & including 10 mm dia in stirrups, spaces & binders, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends & binding with & including mild steel wire (annealed) not less than 0.90mm dia or securing with clips. Complete all as specified & as directed.

Demolition of brick work or stone/boulder masonry built in cement mortar including all quoins, arches, pillars etc complete all as specified and directed.

M&L Brick work using fly ash bricks straight or curved on plan exc 6m mean radius built in cement mortar 1:6 complete all as specified and directed.

Taking down cement plaster on brick or concrete surface including racking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.

M&L for rendering 15mm thick in CM 1:6 on brick or concrete surface, finishing even and smooth without using extra cement complete all as specified and directed.

M&L for preparation of new plastered or unplastered surfaces of walls and applying two coats of cement based paint complete all as specified and directed

M&L for preparation of new plastered or unplastered surfaces of walls and applying three coats of white wash complete all as specified and directed

M&L preparation of old painted surfaces of walls and applying one coat of cement based paint complete all as specified and directed.

M&L preparation of old painted surfaces of walls and applying one coat of white wash complete all as specified and directed.

Demolition of Cement Concrete (unreinforced) of any description & in any position not otherwise specifically provided for complete all as specified and directed.

M&L for PCC 1:4:8 type D2 using 40mm graded stone aggregate as in foundation filling and mass concrete complete all as specified and directed.

M&L for PCC 1:2:4 type B-1 using 20 mm graded stone aggregate as in surface channels and drains complete all as specified and directed.

M&L Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred / stopped ends etc complete all as specified and directed.

M&L for add or deduct for each 25mm girth or part thereof over or under 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred / stopped ends etc complete all as specified and directed.

Excavation in trenches not exceeding 1.5m wide and not exceeding 1.5m depth for foundation etc or for shafts, wells cesspits manholes pier holes etc not exceeding 10 Sqm on plan and not exceeding 1.5 m depth in soft /loose soil etc complete all as specified and directed

Returning, filing in, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm in any type of soil etc complete all as specified and directed

Removing excavated material n.exc 50m and depositing where directed at a level n.exc 1.5m above the starting point complete all as specified and directed.

S&F reinforced concrete pipes, class NP-2, laid and jointed complete with collars of 300mm dia as in repair complete all as specified and directed.

S&F reinforced concrete pipes, class NP-2, laid and jointed complete with collars of 450mm dia as in repair complete all as specified and directed.

M&L for 50 mm High density polyethelyene pipes (HDPE) of pressure rating 6kgf/sqcm laid in trenches complete all as specified and directed.

M&L for hard core of gauge n exc 63 mm, deposited, spread and levelled in layers n exc 15 cm thick, watered and rammed to a true surface complete all as specified and directed.

M&L for 100 mm thick cement concrete 1:4:8 type D-2 using 40 mm graded stone aggregate as sub base of floor complete all as specified and directed.

M&L for 50 mm thick cement concrete 1:2:4 type B-1 using 20 mm graded stone aggregate as in path/hard standing surface finished even and smooth without using extra cement complete all as specified and directed.

M&L for forming construction joints 50 mm x 10 mm wide filled with sealing compound Grade A complete all as specified & directed.

M&L for PCC 1:2:4 type B-1 using 20 mm graded stone aggregate as in lintels upto 1.5 m clear span, coping, benching, bed block, lintel band, plinth courses etc and similar work including weathering,slightly rounded or chamfered angles and throating including necessary form work complete all as specified and directed.

M&L for complete removal of existing treatment on walls and applying two coats of cement based paint complete all as specified and directed

S&F 110mm dia PVC (SWR) pipes single socketed, in any length with rubber ring joints, laid in trenches or in floors complete all as specified and as directed

S&F 110mm bore PVC (SWR) bends any radius complete all as specified and as directed

M&L for Demolition and breaking up drain pipe (salt glazed ware, AC or reinforced concrete ) set in cement mortor for 300 mm to 450 mm internal dia of pipe complete all as specified and directed.

M&L for complete removal of existing treatment and preparation stone surface and applying two coats of colourless silicon water repellent of make Nitocote SN 522 or equivalent on stone walls complete all as specified and directed.

M&L for preparation of old painted surfaces and applying one coat of synthetic enamel paint in concrete surface complete all as specified and directed.

M&L preparation of old painted floor surfaces and applying one coat of floor coat apex floor guard of asian paint or equivalent paint complete all as specified and directed.

All as per above item no 36 but of following specification (a) MCCB 250 Amps , 4 Pole- 415 Volts /25 KA , 50Hz -01 No (I/C) (b)MCCB 100 Amps , 4 Pole 415 Volts/ 16 KA, 50Hz -04 Nos (O/G)

All as per item No 36 above but of following specifications:- (a) MCCB 315 Amps , 4 Pole- 415 Volts /36 KA , 50Hz -01 No (I/C) (b) MCCB 100 Amps, 4 Pole, 415 Volts/16 KA , 50Hz -04 Nos (O/G) (c) Onload Change over switch 315A

M&L in replacemnet of earthing complete with galvanised iron strip 32mm x 6mm and galvanised iron earth plate electrode 600x600x6mm thick, burried directly in ground(earth pit not less than 2.25 meters deep below ground level) with top edge of the plate not less than 2.25 meters below normal ground level, connected to galvanised earth lead wire 32x6mm dia by means of bolts, nuts, check nuts and washers of GI or steel and GI pipe 'L' grade of 40mm dia for protection of earth lead and 20mm dia GI pipe 'M' grade for watering with wire wash funnel etc as shown in electrical plate No. 5 of SSR part - I (2009) connected to earthing test point all as specified or indicated including testing on completion as per IE rule.

Supply, laying and testing in replacement XLPE insulated, armoured heavy duty electric cable, screened PVC bedded, with aluminium conductor 1100 V grade, laid in trenches/ along poles, ducts or through sleeve for cable of size 240 sqmm 3.5 core with lugs complete all as specified - Note: Earth work, sand cushioning and bricks will be measured and paid separately under relevant items Make:- Havells / polycab / cci / nicco / Gloster

All as per item No 40 above but 185 sqmm 3.5 core complete all as specified and as directed

All as per item No 40 abovebut 120 sqmm 3.5 core complete all as specified and as directed

All as per item No 40 above but 95 sqmm 3.5 core complete all as specified and as directed

All as per item No 40 above but 70 sqmm 3.5 core complete all as specified and as directed

All as per item No 40 above but 50 sqmm 3.5 core complete all as specified and as directed

All as per item No 40 above but 35 sqmm 3.5 core complete all as specified and as directed

All as per item No 40 above but 16 sqmm 4 core complete all as specified and as directed

All as per item No 40 above but 25 sqmm 4 core complete all as specified and as directed

All as per item No 40 above but 10 sqmm 2 core complete all as specified and as directed

Supply and providing sand cushioning with dry clean sand 15 cm below cable and 8 cm above the cable complete all as specified and directed. Note : Punned thickness shall be measured for the purpose of payments.

Supply and laying flyash building bricks laid in trenches for LT cable protection with length of brick perpendicular to length of cable complete all as specified and directed.

S& Laying Synthetic Insulating mat of size 2 m x 1 m x 19mm complete at the substations all as specified and as directed by the Engr-in-Charge

Supply and fix cable jointing kit for 1.1 KV grade cable for straight through joint complete with Jointing material heat Shrink type and accessories suitable for 3 ½ / 4 core XLPE, armoured, Al conductor cable of size 25 to 50 sqmm,Indoor/Outdoor type complete all as specified and as directed

All as per item above but of size 70 to 150 Sqmm complete all as specified

All as per item above but of size 185 to 300 Sqmm complete all as specified

Supply and fixing in replacement MCCB fixed thermal & Magnetic setting type 4 pole 415 volts of capacity 100 amps 16 KA all as specified and directed. Make Standard/ Havells/ L & T / MDS/Legrand/HPL

Supply and fixing in replacement MCCB fixed thermal & Magnetic setting type 4 pole, 415 volts of capacity 63 amps 16KA all as specified and directed.

Supply and fixing in replacement MCCB adjustable type 4 pole 415 volts of capacity 160 amps 25 KA all as specified and directed.

Supply and fixing in replacement MCCB adjustable type 4 pole 415 volts of capacity 200 amps 35 KA all as specified and directed.

Supply and fixing in replacement MCCB adjustable type 4 pole 415 volts of capacity 250 amps 35 KA all as specified and directed.

Supply and fixing in replacement MCCB adjustable type 4 pole 415 volts of capacity 400 amps 35 KA all as specified and directed.

Supply and spreading 40mm graded stone aggregate complete all as specified and directed.

Checking and inspecting of the LT outdoor type panel board system throughily, including removing of the unserviceable damaged control wiring and rewiring of the same with suitable size and length of copper conductor FRLS , checking of instruments , welding of panels,cleaning with bakilete and carried out of necessary painting matching with existing colour including tightining for all the loose contacts, reconnecting back and testing complete all as specified and directed .

M/s Bapujee Builders and Traders

M/S. KISHAN ENGINEERING

M/S SPECTRUM INFRASTRUCTURE DEVELOPMENT PVT LTD

M/s Ats Electricals

M/s TECH TEAM

Likitha Enterprises

V.Venkata Ramaiah

M/s MAA BHAIRABI ENTERPRISES