Providing a Aluminum Glazed Partition Cabin to Accommodate the Audit section in the RCS Wing of Mettur EDC

Amount

Dismantling the Aluminum glazed partition, Doors and stacking all the materials careful for reuse as directed by the Engineer in charge including all labour charges, lead, lift, T&Ps etc., complete.

Re erecting the dismantling the Aluminum glazed partition and Doors as directed by the Engineer in charge with new rubber beeding including all labour charges, lead, lift, T&Ps etc., complete..

Providing and fixing in position of colour coated Aluminum glazed partition as per specification as detailed below including cost for chipping the existing floor, finishing it after fixing the partition in position, cost of all materials with rubber beeding, Aluminum beeding, cleat angle etc., labour charges, leads, lifts, T&P’s etc complete. i) Vertical Post - Anodized Aluminum section 63x38mm of thickness 2.45mm, country wood filled at maximum spacing of 900mm c/c. ii) Horizontals - Anodized Aluminum section 63x38mm of thickness 2.45mm, country wood filled at 0.00m, 0.90, 2.40 and 2.85m level from floor. iii) From ground level 900mm and 2400mm to 2850mm with 12mm thick Exterior grade both side pre laminated board. iv) From 900mm to 2400mm with 4mm thick frosted glass. v) Aluminum cleat angle of weight not less than 0.12Kg/m on both sides of shutter.

Providing and fixing in position of colour coated Aluminum framed partition as per specification as detailed below including cost for chipping the existing floor, finishing it after fixing the partition in position, cost of all materials with rubber beeding, Aluminum beeding, cleat angle etc., labour charges, leads, lifts, T&P’s etc complete. i) Vertical Post - Anodized Aluminum section 63x38mm of thickness 2.45mm, country wood filled at maximum spacing of 900mm c/c. ii) Horizontals-Anodized Aluminum section 63x38mm of thickness 2.45mm on wall with country wood filled at Bottom and Top to maximum height of 1.20M and the framed partition is fully closed with 12mm thick exterior grade both side pre laminated board. iii) Aluminum cleat angle of weight not less than 0.12Kg/m on both sides of shutter.

Providing and fixing colour coated Aluminum glazed door single leaf swing type with 5mm clear plate glass with standard accessories such as but not limited to handles, locking service, suitable rubber beeding cleat etc., complete all as per specification as detailed below. Chipping the existing floor, finishing and graving the top panel glass including cost of all materials, T&P’s labour charges, leads, lifts etc., complete. i) Door frame – Anodized Aluminum section 47.5x44.5mm of thickness 2.45mm. iii) Shutter horizontal frame – Anodized Aluminum section 100x45mm thickness 2.45mm.

Supplying and fixing of hydraulic door closer of approved quality with speed adjustment of ISI make including cost of all materials, labour charges, all T&P, lead, lift etc., complete.

Supplying and fixing approved make Wash Hand Basin of size 550mm x 400mm with all accessories such as cast iron brackets 32mm dia CP waste coupling, 32mm dia waste pipe 15mm dia valve, 15mm nylon connection15mm dia CP pillar tap etc., including cost of all materials, transporting, labour, lead, lift, etc., complete.

Supply and fixing of 4 feet 40 watts box with ballast type single fluorescent fitting with copper choke and condenser (Philips / Crompton /equivalent) with TW round blocks on wall or ceiling with PVC unsheathed copper lead from terminals to the including cost of all materials such as cables, pipes, etc., complete.

SGST For bidders within Tamilnadu

CGST For Bidders within Tamilnadu

IGST For Bidders outside of Tamilnadu

M.PERIYASAMY