Design, fabrication, installation, testing and commissioning of FASD starter for unit III along with their allied works at LIS KatalBatal and replacement of foot valve of unit III along with allied works at LIS Dharap.

Design, fabrication, installation, testing and commissioning of FASD starter for unit III along with their allied works at LIS KatalBatal.

Design, fabrication, installation, testing and commissioning of dry type fully automatic star delta starter of 75 HP(approx) suitable to run the 05cusecx30mtr head pump (L & T / Havells make) at LIS KatalBatal for pumping unit-III. The starter should consist of sheet metal enclosure inclusive of single phase preventer, 3 no. contactors of appropriate rating, relay, timer, one no. voltmeter, one no. ammeter, on /off switch, phase indicators etc.The starter should have protection against overload, under load, over voltage, under voltage, single phase, unbalance volt and unbalance current. Giving all the electric connections from starter/panel tomotor by way of P/F of 25mm2 multi strand copper cable of 42mtrs approximately after passing through PVC conduit pipe of required size along with thimble of appropriate rating/size and complete insulation. Also P/F of 50mm2 multi strand copper cable of 24mtrs length approximately passing through PVC conduit along with MCCB of 250amp of 50K rupturing capacity and thimble of appropriate rating for giving connection from main to starter/panel and testing on full load. Note: The tenderers are requested to visit the site and quote the rate including the rebate on old material as per site conditions. Any modifications/ alterations of the job, absolutely necessary if required at the time of execution may be done as per actual site conditions

Replacement of foot valve of unit III along with allied works at LIS Dharap.

Dismantling the tail piece of suction pipe of unit III and then pulling out of the canal with the help of crane/chain pulley or other tools and tackles along with foot valve of 14” dia. Dismantling the foot valve from the tail piece by way of cutting the old rusted nuts and bolts. Providing and laying of 12” dia MS pipe of 10 feet length in pieces along with 01 no foot valve of 12”dia, 01 nos bends, and 05 nos flanges welded to their ends and joining the new suction pipe to existing suction pipe of 14” diaafter reducing itsdia to 12”dia by way of welding/fabricating works along with required nuts, bolts and rubber sheet joint of appropriate sizes. Complete job include cost of material, carriage/fitment charges, hire charges of crane/welding/cutting set and other tools and tackles required for execution of work at LIS Dharap. Note: The tenderers are requested to visit the site and quote the rate including the rebate on old material as per site conditions. Any modifications/ alterations of the job, absolutely necessary if required at the time of execution may be done as per actual site conditions

NACHIKETA TECHNOLOGY

NATIONAL ELECTRO-MECH COMPANY

M/S UK MECH AND ELECT ENGG WORKS

M/S FASTTRACK ENGINEERS

PERFECT ELECTRICAL WORKS

SMART TECH AND CO