Construction of BO Quarter Patta, Patta Block, Kuthar Range under Kunihar Forest Division.

Surface dressing of the ground including removing vegetation and in-equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.

All kinds of soil

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil asdirected, within a lead of 50 m

All kinds of soil.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :

1:5:10 (1 cement : 5 fine sand : 10 graded stone aggregate 40 mm nominal size)

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level :

1:2:4 (1 cement : 2 coarse sand) : 4 graded stone aggregate 20 mm nominal size)

Centering and shuttering including strutting, propping etc. and removal of form for Columns, pillar, piers, abutments, posts and struts

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level.

Thermo-Mechanically Treated bars of grade Fe-500D or more.

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in :

Cement mortar 1:6 (1 cement : 6 coarse sand)

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level.

Cement mortar 1:4 (1 cement :4 coarse sand)

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting,hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works

15 mm cement plaster on the rough side of single or half brick wall of mix :

1:6 (1 cement: 6 fine sand)

Excavation in foundation trenchesetc.in earth work in 1/2 pick & 1/2 jumper work for RCC pillars.

laying CC 1:5:10 under foundation and floor: pillars.

RCC work 1:5:3 I/C curing complete

Mild steel/tor steel rein for cement for RCC Work

Centring & Shuttering for flate surface such as slabs, shelves, balconies etc.

R.R. Stone Masonery rubble in CM 1:6

Centering & Shuttering for flate surface as slabs, shelves, balconies etc.

Beams, cantilivers, girders & lintels sides of soffits of beams.

Stair case with slopping or stopped & stringers excluding landing

P/L cement concreate 1:5:3 suspended floor roofs landing & shelves & their supports balconies beams girders etc.

Stair case (except sprial stair)

Mid steel /tor steel rein for cement for RCC work

Brick masonary in cement mortar 1:6 i/c curring complete with deduction.

Half Brick Masonary in Cement upto floor level in cm 1:4 curring

Wood work in frame of door, window clerestory window and other frames wrough framed & fixed in position (Saal Wood)

P/F of panelled Glazed or panelled glazed shutter for doors, windows etc. 35 mm thick (hallock wood)

P/F of wire gauge shutter for door/ windows 35 mm thick hallock wood

P/F of aluminium sliding door bolts 300X16mm

P/F aluminium tower bolts 250X10mm

250x10mm window

P/F aluminium Handles 125mm

100 mm window

6mm thick cement plaster to ceiling in C.M 1:3

15mm cement plastering made the building i/c scaffolding in C.M. 1:6 fair side

15 mm cement plastering made the building i/c scaffolding in cm 1:6 (outer side of building (rough side.

Stone soiling properly hand packed in floor

Cement concreate flooring 1:2:4 20 mm nominal size 40 mm thick

Distermpring with dia bound two coats on ceiling.

Distermpring wro coats with oil bound distemper

Finishing of wall with tretured exterior paint.

applying pink primer for door/window

painting two coats on steel work

P/F of M.s Grill for windows

Making plinth potation stone soiling

laying of C.C. in 1:3:6 over plinth potation

EARTH WORK

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 qm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil asdirected, within a lead of 50 m.

All kinds of soil.

Centering and shuttering including strutting, propping etc. and removal of form for :

Suspended floors, roofs, landings, balconiesand access platform

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :

1:5:10 (1 cement : 5 coarse sand): 10 graded stone aggregate 40 mm nominal size)

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level :

1:2:4 (1 cement : 2 coarse sand) : 4 graded stone aggregate 20 mm nominal size)

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level.

Thermo-Mechanically Treated bars of grade Fe-500D or more

Boulder filling dry hand packed tightly as in soling under floors

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in:

Cement mortar 1:6 (1 cement : 6 coarse sand)

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundations and plinth in :

cement mortar 1:4 (1 cement : 4 coarse sand)

15 mm cement plaster on rough side of single or half brick wall of mix:

1:6 (1 cement: 6 coarse sand)

Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.

40 mm thick with 20 mm nominal size stone aggregate

Providing and fixing water closet squatting pan (Indian type W.C.pan ) with 100 mm sand cast Iron P or S trap,10 litre low level white P.V.C. flushing Cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and xtures complete, including cutting and making good the walls and floors wherever required:

White Vitreous china Orissa pattern W.C.pan of size 580x440 mm with integral type foot rests

Providing and fixing wash basin with C.I. brackets, 15 mm C.P. rass pillar taps, 32 mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever require:

White Vitreous China Flat back wash basin size 550x 400 mm with single 15 mm C.P.brass pillar tap

Providing and fixing kitchen sink with C.I. brackets, C.P.brass chain with rubber plug, 40 mm C.P. brass waste complete, including painting the fittings and brackets,cutting and making good the walls wherever required:

White glazed fire clay kitchen sink of size 600x450x 250 mm

Providing and fixing G.I. inlet connection for flush pipe connecting with W.C. pan.

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete

1 32 mm dia each 87.70

Providing and fixing 100 mm sand cast Iron grating for gully trap.

Providing and fixing water closet squatting pan (Indiansuperior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete.

Providing and fixing of PTMT towel rail complete with brackets fixed to wooden cleats with CP brass screws with concealed fittings arrangement ofapproved quality and colour.

600 mm long towel rail with total length of 645 mm, width 78 mm and effective height of 88 mm, weighing not less than 190 gms.

Providing and fixing 600x120x5 mm glass shelf with edges round off, supported on anodised aluminium angle frame with C.P. brass brackets and guard rail complete fixed with 40 mm long screws, rawl plugs etc. complete.

Providing and fixing PTMT liquid soap container 109 mm wide, 125 mm high and 112 mm distance from wall of standard shape with bracket of the same materials with snap fittings of approved quality and colour, weighing not less than 105 gms.

Providing and fixing soil, waste and vent pipes :

Centrifugally cast (spun) iron socket & spigot (S&S) pipe as per IS: 3989

75 mm diameter :

Centrifugally cast (spun) iron socketed pipe as per IS: 3989

Providing and filling the joints with spun yarn, cement slurry and Cement mortar 1:2 ( 1 cement : 2 fine sand) in S.C.I./ C.I. Pipes :

100 mm dia pipe

Providing and fixing of M.S. holder bat clamps approved design to Sand Cast iron/cast iron (spun) pipe embedded in and including cement concrete blocks 10x10x10 cm of 1:2:4 mix (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size), including cost of cutting holes and making good the walls etc. :

For 100 mm dia pipe

Providing and fixing bend of required degree with access door, insertion rubber washer 3 mm thick, bolts and nuts complete.

100 mm dia

Sand cast iron S&S as per IS - 3989

75 mm dia

Sand cast iron S&S as per IS - 3989

Providing and fixing plain bend of required degree.

100 mm dia

Sand cast iron S&S as per IS : 3989

75mm dia

Sand cast iron S&S as per IS - 3989

Providing and fixing door piece, insertion rubber washer 3mm thick, bolts & nuts complete :

Providing and fixing collar :

Sand cast iron S&S as per IS - 3989

75mm dia

Sand cast iron S&S as per IS - 3989

Providing and fixing terminal guard

100mm dia

Providing and fixing trap of self cleansing design with screwed down or hinged grating with or without vent arm complete, including cost of cutting and aking good the walls and floors :

100 mm inlet and 100 mm outlet

Sand cast iron S&S as per IS: 3989

Cutting chases in brick masonry wash for following diameter sand cast iron/centrifugally cast (spun) iron pipes and making good the same with cement concrete 1:3:6 ( 1 cement : 3 coarse sand :6 graded stone aggregate 12.5 mm nominal size), including necessary plaster and pointing in cement mortar 1:4 (1 cement : 4 coarse sand) :

100 mm dia

75 mm dia

Providing and fixing G.I. Pipes complete with G.I. Fittings and clamps, i/c making good the walls etc. Concealed pipe, including painting with anti corrosive bitumastic paint, cutting chases and making good the wall :

15 mm dia nominal bore

Providing and fixing G.I. pipes complete with G.I. Fittings including trenching and refilling etc.

15 mm dia nominal bore

Making connection of G.I. distribution branch with G.I. main of following sizes by providing and fixing tee,including cutting and threading the pipe etc. complete :

25 to 40 mm nominal bore

Fixing water meter and stop cock in G.I. pipe line including cutting and threading the pipe and making long screws etc. complete (cost of water meter and stop cock to be paid separately).

Providing and fixing brass bib cock of approved quality :

15 mm nominal bore

Providing and fixing brass stop cock of approved quality

15 mm nominal bore

Providing and fixing uplasticised PVC connection pipe with brass unions :

45 cm length

15 mm nominal bore

Providing and fixing gun metal non- return valve of approved quality (screwed end) :

25 mm nominal bore

Providing and fixing brass ferrule with C.I. mouth cover including boring and tapping the main :

15 mm nominal bore

Constructing masonry Chamber 30x30x50 cm inside, in brick work in cement mortar 1:4 (1 cement :4 coarse sand) for stop cock, with C. I. surface box 100x100 x75 mm (inside) with hinged cover fixed in cement concrete slab 1:2:4 mix (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size), i/c necessary excavation, foundation concrete 1:5:10 ( 1 cement : 5 fine sand : 10 graded stone aggregate 40mm nominal size ) and inside plastering with cement mortar 1:3 (1 cement : 3 coarse sand) 12mm thick, finished with a floating coat of neat cement complete as per standard design

With common burnt clay F.P.S.(non modular) bricks of class designation 7.5

Providing and fixing rectangular high density polyethylene water storage loft tank with cover, conforming to ISI : 12701, colour of opaque white or as approved by Engineer-in-charge. The rate includes making necessary holes for inlet, outlet & over flow pipes. The base support i/c fittings & fixtures for tank shall be paid separately.