NIT No.10 /EE(EnM)M-8/2026-27 Item 06

The submersible pump set taken out from the bore due to the defective G.I. pipe and dismantling the defective electrical items from the LT panel board.

Supply of Hut Type Feeder Piller Automatic LT Panel board having suitable space for electric energy meter for 415 Volts, 3 phase, 50 Hz, 4 wire system for operation of up to15 HP submersible set, made out of not less than 2mm thick CRCA for load bearing members, and 1.6 mm for doors of panel, totally enclosed, dust and vermin proof, floor mounted type .The panel size 760mmX1360X300mm and having 1) 63 Amp 4 pole MCB 10 KA breaking capacity -1 no. (2) digital volt meter(0-400) - 1 no.  (3) digital Ammeter (0-50A) - 1 no. (4) Phase sequence relay -1 No (5) Electronic timer - 1 no (6) Voltmeter Selector Switch -1 no (7) Auto Manual Selector Switch - 1 No (8) Start/Stop Push Button - 2 No (9) 32 Amp Contactor - 2 No (10) Auto/manual switch, 2-position selector-switch, Centre 'OFF' with NO+ NC Block Make:- L&T/C&S/minilac (11) Set of indicating lamps, LED-Type, operational-voltage up tp 240 V (3 No) (12) Time-Switch digital - (1 No) (13) Motor Protection Relay - 1 No (14) Aluminum Bus bar size 25 mmX6mm-1 set. (15)  CT-3Nos (16) Over load Relay 14-23 Amps. 1 No (17) QT Timer -24 Hours -1 No Make of accessories:-L&T/C&S/AE/as per DJB approved

S/o 4 sqmm 3 Core PVC insulated flat submersible cable suitable for 1100 Volts Copper Conductor (100 Mtr Roll). Make : Havells / Gloster / DJB Approved Make

S/o G.I. pipe 80 mm dia size medium class with G.I.  flange welded in both sides 03 mtrs long with MS strips complete with threading work on each side of pipe each flange should be 4 holes and cut for cables make :- Jindal/Tata / or any other make approved by DJB

S/o G.I. tail piece 80 mm dia size medium class 1.5 mtr long complete with one end threaded and one end welded with flange make Make :- Jindal/Tata or any other make DJB approved

S/o of Chain pulley block 2T x 3m lift, Chain Pulley Block Make: Morris/Reva/Djb Approved

S/o MS clamp 80 mm dia 600 mm long and 12 mm thick holding the pipe the complete with nut bolt and washer

S/o rubber insertion 75 % Neoprene (1.5 mm to 25 mm) jointing sheet conforming IS 638/79 with ISI mark 1.5 mm thick Make:- Jyoti or any other make approved by DJB

S/o required off size threaded nut bolts of good quality

Supply of MS bore cover 8 mm thick suitable for 200 mm dia casing in 2 pieces complete with bolting arrangement angle iron frame and provision of 80 mm dia hole in the center