S/R to HRTC Bus Stand at Banjar Distt. Kullu (HP)

Amount

Excavation in foundations, trenches etc. in earth work in all kind of soils, such as pick work, jumper work,blasting work, by blasting or chieling and pumping bailing, dewatering where ever required etc. complete and lift up to all heights and then clear from the edge of the excavation and then returning the stacked soil in 15 cm, layers, when required in to plinths sides of foundations etc. consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth up to approved dumping site , including all leads, lifts and carriage of materials and as per entire satisfaction of the Engineer-in charge. .Any loss of Govt.and private property during the execution of work the apsulte responsibilty of the contractor.

Providing and laying cement concrete 1:4:8 (One cement :Four sand: Eight graded stone aggregate 40mm (Forty milimetre)nominal size) and curing complete excluding cost of form work in :Foundation and plinth,. including all leads , lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing and laying machenically mixed and vibrated cement concrete work 1:2:4 (One Cement:Two Sand:Four graded stone aggregate 20 mm(Twenty milimetre) nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in Foundations,footings bases of columns and the like and mass concrete. including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing form work with steel plates 3.15mm.(Three point fifteen milimetre)thick welded with angle iron in frame 30x30x5mm. (Thirty into thirty into five milimetre)so as to give a fair finish including centring, shuutering, strutting and propping etc. with wooden battens and ballies, height of proppingand centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters buttresses, plinth and string courses and the like. including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing and laying machenically mixed and vibrated cement concrete work 1:2:4 (One Cement :two Sand : four graded stone aggregate 20 mm (Twenty milimetre)(nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in :- Walls (any thickness but not less than 0.10 m(zero point one zero) thickness) including attached pilasters buttersses,plinth and string courses etc. from top of foundation upto floor two level ,including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing and laying machenically mixed and vibrated upto floor two level cement concrete 1:2:4 (One cement : Two Sand : Four graded stone aggregate 20mm (Twenty milimetre) nominal size) and curing complete including form work : in String courses coping bed plates, anchor blocks plain window sills and the like all leads and lits including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing form work with steel plates 3.15mm.thick welded with angle iron in frame 30x30x5mm. (Thirty into thirty into five milimetre)so as to give a fair finish including centring, shuutering, strutting and propping etc. with wooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in Columns, pillars, posts and struts Square, rectangular or polygonal in plan.all leads and lits including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing and laying machenically mixed and vibrated cement concrete work 1:1.5:3 (One cement :One and half sand :Three graded stone aggregate 20mm(Twenty milimetre)(nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in Column, pillars, posts and struts upto floor two level including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing Tor steel reinforcement for R.C.C. work including bending, binding and placing in position complete upto floor two level , including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Steel work welded in built up sections,trusses and framed work,including cutting ,hoisting ,fixing in position and applying a priming coat of red lead paint. In beams joists channels ,angles , tee ,flats with connecting plates or angle cleats as in main and cross beams,hip and jack rafters,purlins connected to common rafters and the like,including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Providing 40x3 mm flat iron hold fast 40cm. (Forty centimetre)Long including fixing to frame with 10mm diameter bolts & nuts and wooden plugs and embeding in cement concrete block 30x10x15cm. 1:3:6 ( One cement : Three sand: Six graded stone aggregate 20mm ( twenty milimetre) nominal size), including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Applying priming coat on new concrete/masonry/asbestos cement/plastered surfaces after and including preparing the surface by thoroughly cleaning oil,grease,dirt and other foreign matter and sand papering as required with Readymixed primer, including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Distempering (two coats) with oil bound washable distemper of approved brand and manufacture and of required shade on undecorated wall surfaces to give an even shade over and including a priming coat with distemper primer of approved brand and manufacture after thoroughly brushing the surface free from mortar droppings and other foreign matter and also including preparing the surface even and sand papered smooth. Priming coat with distemper primer,including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Finishing wall with weather proof exterior grade emulsion of approved design (Apexultima) or its equarlied on undecorated wall surfaces (two coats) to give an even shade and final finish after throughly cleaning the surface to remove all dirt, dust and other foreign matter etc including sand paper smooth complete, including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Painting two coats (excluding priming coat)on previously painted steel and other metal surfaces with readymixed bituminous paint anticorrosive paint,brushing,black to give an even shade including cleaning of all dirt,dust and other foreign matter, including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Painting two costs (excluding priming cost on new steel and other metal surfaces eith enamel paint brushin to give an even shade including cleaning the surface of all dirt,dust and other foregin matters Enamel paint other than white,including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

15mm Cement plaster in single coat on the rough side of brick/ concrete/stone walls for interior plastering upto floor two level including arrises,internal rounded angles,chamfers and/or rounded angles not exceeding 80mm in girth and finished even and smooth. Cement Mortar 1:5 (One Cement : Five Sand), including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Applying Birla white wall care putty over plaster surface after thoroughly brushing the surface free from mortar drops, dust, loose materials and other foreign matters sand papered smooth to give final matter finish to the surface complete.including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

Supplying and fixing glass panes with putty and nails including removal of broken glass panes wherever necessary Plain Glass: 4mm thick. including all leads and lifts and carriage of materials and complete as per entire satisfaction of the Engineer-In-Charge.

MOHAN LAL

MANOJ CHAUDHARY

PRAKASH CHAND

PANKAJ GUPTA

Tikam Ram

Cont. Beena Devi