SPECIAL REPAIR TO SEWAGE LINES AND SEPTIC TANKS AT DAGSHAI CANTT UNDER GE KASAULI

Schedule 'A' Section - I

Excavation in trenches not exceeding 1.5 metre wide and not exceeding 1.5 metre in depth for foundation, shafts, man holes etc not exceeding 10 sqm on plan and getting out in hard/dense soil complete all as specified and as directed

Returning, filling in, including spreading, watering and well ramming in layers not exceeding 25 cm thick in soil of any description, complete all as specified and as directed.

Removing excavated soil to a distance not exceeding 50 metre and deposited where directed at a level not exceeding 1.5m above the starting point, complete all as specified.

Material and labour for cutting and demolition of bituminous road in trenches 0.45 m wide and 1.50 m depth (i.e. bitumnious concrete, bituminous macadam, GSB and hard/dense soil ) and removing of debries outside of defence land, making good and levelling the bottom of trenches surface for laying of sewer pipes, returning, filling in with excavated soil including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick and finishing the top surface of trenches with PCC 1:2:4 type B1 (using 20mm aggregate) of 200mm thickness complete all as specified and directed. Note- Excavation/demolition of road surface, returing filling, removal ofdebries and PCC 1:2:4, 200 mm thick is included in the quoted rate under this item. Laying of sewer pipe shall be measured and paid for separately.

Material and labour for dismantling of precast concrete interlocking paver block, levelling the sand cushioning layer, if required and refixing precast concrete interlocking paver block in same location over sand cushioning complete all as specified and directed

Demolition and breaking up drain pipes (Salt glazed ware, AC or Reinforced concrete) set in cement mortar (Internal dia of pipe in 150mm and 200mm) complete all as specified and as directed.

Supply and fixing for 200mm dia Salt-glazed stoneware drain pipes grade 'A' laid in trenches and jointed in cement mortar 1:1, complete all as specfified and directed.

Material and labour for cement concrete 1:3:6 type C2 using 40 mm graded aggregate in bed to drain pipes including packing under, and haunching in against the side of pipes after they are laid and tested for 200mm dia bore pipe complete all as specified.

Supply and fixing for 150mm dia Salt-glazed stoneware drain pipes grade 'A' laid in trenches and jointed in cement mortar 1:1, complete all as specfified and directed.

Material and labour for cement concrete 1:3:6 type C2 using 40 mm graded aggregate in bed to drain pipes including packing under, and haunching in against the side of pipes after they are laid and tested for 150mm dia bore pipe complete all as specified.

Material and labour for salt glazed stoneware bends and taper bends grade 'A', 200mm internal diameter and jointed etc complete all as specified and directed

Material and labour for salt glazed stoneware bends and taper bends grade 'A', 150mm internal diameter and jointed etc complete all as specified and directed

Material and labour for salt glazed stoneware single or double 'Y' junctions, 200mm bore, laid and jointed etc as per site requirement complete all as specified and directed

Material and labour for salt glazed stoneware single or double 'Y' junctions, 150mm bore, laid and jointed etc as per site requirement complete all as specified and directed

Material and labour for Intercepting traps 150mm internal dia of salt-glazed stoneware, with square ends to inspection arms for building flush into manholes and setting in cement mortar 1:1 complete, including concrete foundation of width and thickness as for pipes of same dia and haunching after setting. Cleaning arm to include a glazed ware stopper, galvanised iron bayonet joint (or other approved pattern) and galvanised iron lever (or trigger), galvanised iron chain, hook and ring etc complete all as specified and as directed.

Dismantling of brick work or stone masonary, precast cement concrete walling built in cement mortar including all quoins, arches, pillars etc. complete, all as specified and directed.

Material and labour for brick work with sub class ‘B’ bricks burnt, straight or curved on plan exceeding 6 metre mean radius built in cement mortar (1:4), complete all as specified

Demolition of cement concrete of any description and in any position not otherwise specifically provided for including removal the rubbish/ demolished material outside defence land, complete all as specified and directed.

Material and labour for cement concreteType C2 1:3:6 (40 mm graded stone aggregtes) in surface channels and drains all as specified and directed.

Material and Labour extra for forming fair finished drain or channel of min 30cm girth in cement concrete, using extra cement, including forms, moulds , mitred /stopped ends etc., complete all as specified and directed.

Material and labour for walling of random rubble, uncoursed, well bonded, bedded and solidly hearted, built in cement mortar 1:4 complete all as specified and as directed.

Material and labour for walling of random rubble, uncoursed stone masonry,well bonded, bedded and solidly hearted, built in cement mortar 1:4 but except stone complete all as specified and as directed. Note- The serviceable stones obtained from Serial item No-18.00 will be used after removing motar, cleaning with water, etc.)

Material and labour for 20mm thick rendering in cement mortar (1:6) on stone masonary surface or surface other than fair faces of brick or concrete surface and finished the surface even and smooth without using extra cement complete all as specified.

Material and labour for plain cement concrete 1:4:8 type D-2 (using 40 mm graded mechanically crushed stone aggregate), as in foundation filling and mass concrete including necessary form work complete all as specified and directed.

Material and labour for plain cement concrete 1:2:4 type B-2 (using 40 mm graded mechanically crushed stone aggregate), as in foundation, filling and mass concrete including necessary form work complete all as specified and directed.

Material and Labour for plain cement concrete 1:2:4 type B-1 (using 20 mm graded mechanically crushed stone aggregate) as in fixing of hold fasts, copings, bed plates,kerbs or mud stops, lintels upto 1.50m span, plinth courses , seismic and other bands and the like, finished the surface fair and even, including necessary form work complete all as specified and directed. Note- If reinforced concrete, reinforcement shall be measured and paid for separately.

Material and Labour for 15mm thick rendering in CM 1:3 with liquid water proofing compound @ 200 ml per bag of cement on brick masonary/concrete surfaces and finished even and smooth without using extra cement complete all as specified and directed (Note : WPC shall be measured and paid separately)

Material and Labour for 15mm thick rendering in CM 1:4 with liquid water proofing compound @ 200 ml per bag of cement on brick masonary/concrete surfaces and finished even and smooth without using extra cement complete all as specified and directed (Note : WPC shall be measured and paid separately)

Supply only liquid water proofing compound complete all as specified and directed.

Demolition of reinforced cement concrete of any description and in any position not otherwise specially provided for including cutting of steel reinforcement as required to facilitate demolition and removal the rubbish/ demolished material outside defence land, complete all as specified and directed.

Material and Labour for pre-cast cement concrete type B-1 1:2:4 (using 20 mm graded mechanically crushed stone aggregate), as in cover slabs for manhole, shelves etc. set in cement mortar (1:4) and finished cement concrete surface even and fair without using extra cement, complete all as specified and directed. Note : 1. Reinforcement and handles for cover slab shall be measured and paid separately

Supply and fixing framed work such as grills, gratings, etc. with ends of bars shouldered and/or riveted, or forged into spikes, framed guard bars, angle iron chowkats for door ,barred iron doors, ladders framed balusters, walk ways, railings, and similar work conforming to Fe-290-Gde E-165 complete all as specified.

Material and labour TMT bars, 8 mm dia and above, cut to length, bent to shape required including cranking, binding spirally for hooping or column, hooking ends and binding with mild steel wire (annealed) not less than 0.9 mm dia or securing with clips, complete all as specified and directed.

Material and labour for reinforced cement concrete 1:2:4, type B1 (Using 20 mm graded stone aggregate) in slabs supported on walls,beams and columns in floors, roofs, landings, balconies,canopies, deck slabs, baffle walls and in shelves and the like complete all as specified and directed. Note : Reinforcement shall be measured and paid separately

Material and labour TMT bars, 10 mm dia and over, cut to length, bent to shape required including cranking, binding spirally for hooping or column, hooking ends and binding with mild steel wire (annealed) not less than 0.9 mm dia or securing with clips, complete all as specified and directed.

Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping) for fair finished surfaces etc complete all as specified and directed

Supply and fixing for cast iron wok grade FG 150, unmachined, in brackets, gully traps, gratings, railing frames, manhole covers, fire and, soot doors, dampers, stop valve boxes, gate stops, parts of ranges, balusters and similar articles not exceeding 5 kg each complete all as specified and as directed.

Material and labour for fixing and setting in cement mortar 1:3 and flaunching with cement concrete 1:2:4 type B-1 cast iron manhole covers and frames medium duty any type and size complete all as specified and directed.

Supply and fixing cast iron soil, waste and vent spun pipes 75 mm bore, ISI marked, in any length, with or without ears, with cement joints, laid in trenches complete, all as specified.

Supply and fixing cast iron vent cowls suitable for 75mm bore pipe complete, all as specified.

Supply and fixing cast iron soil, waste and vent spun pipes 100 mm bore, ISI marked, in any length, with or without ears, with cement joints, laid in trenches complete, all as specified.

Supply and fixing cast iron bends (any radius) 100 mm dia diminishing pieces or tapers complete, all as specified.

Supply and fixing in repairs 110mm dia UPVC, soil waste drain pipe, type ‘B’ , conforming to IS 13592-1992, single socketed, in any length with rubber rings joints or jointed with solvent cement joint, laid in trenches or in floors, complete all as specified and directed.(Note- Rubber rings for pipes and fittings shall be confirm to IS 5382-1985)

Supply and fixing in repairs 75mm dia UPVC, soil waste drain pipe, type ‘B’ , conforming to IS 13592-1992, single socketed, in any length with rubber rings joints or jointed with solvent cement joint, laid in trenches or in floors, complete all as specified and directed.(Note- Rubber rings for pipes and fittings shall be confirm to IS 5382-1985)

Supply and fixing in repair,110 mm bore UPVC (SWR) bend with access door including jointing with solvent cement, complete all as specified. (Note- UPVC bends shall be confirm to BS 4515 DIN 19531 and DIN 19534)

Supply and fixing in repair, 75 mm bore UPVC (SWR) bend with access door including jointing with solvent cement, complete all as specified. (Note- UPVC bends shall be confirm to BS 4515 DIN 19531 and DIN 19534)

Supply and fixing in repairs 110 mm bore UPVC (SWR), junction single T (equal or unequal), with access door including jointing with solvent cement, complete all as specified.

Supply and fixing in repairs 75 mm bore UPVC (SWR), junction single T (equal or unequal), with access door including jointing with solvent cement, complete all as specified.

Supply and fixing in repairs 110 mm bore UPVC (SWR), junction Double T (equal or unequal), with access door including jointing with solvent cement, complete all as specified.

Supply and fixing in repairs 75 mm bore UPVC (SWR), junction Double T (equal or unequal), with access door including jointing with solvent cement, complete all as specified.

Cutting into existing manholes for connecting new drains, making good to pipe and rendering, cutting out existing benching for and forming branch channel (1/2 round or 3/4 section) in cement concrete 1:2:4 type B-l smooth finished, and reforming benching as required for 150 mm internal bore pipe complete all as specified.

Material and labour for cleaning of septic tanks/pits of any capacity at various locations of APS Dagshai by removing of sludge water/ night soil/ silt/solid waste material etc i.e complete cleaning through sewer suction machine (Honey sucker truck, chasis mounted type with minimum capacity of 4000 ltrs) including cost of fuel, lubricant, driver, helper and labour required as per site requirement alongwith Honey sucker vehicle and disposing the same out side of Defence land as per existing r

Construction of Soakage wells of size 3.0 mtr dia X 3.0 mtr depth including excavation, in any type of soil or soft disintegrated rock, foundation in PCC 1:4:8, RCC curb, walls of full and honey combed brick masonry in CM 1:3, RCC slab, man hole cover, inter connecting CI pipes , MS Steps, CI Vent pipe, broken brick bat filling complete all as specified and as shown in drawing No. CECZ STD 1173(C) Sheet No 1R/2

Amount of credit of Rs. 140255.00 for retrived old material as mentioned in Schedule 'A' section-II of tender document in pdf form, will be deducted offline while acceptence of tender.