8118 REPAIR TO HARDSTANDING FOOTPATH KERB STONE AT ZONE 4 AND 5 AND OTHER AREA UNDER ZONE 4 AND 5 UNDER AGE BR II UNDER GE NW KUNJALI

Amount

Demolition of cement concrete (unreinforced) in ground floors and pavings n exc 15 cm thickness (below or above groud level ) complete all as specified and as directed.

M & L broken stone hardcore of any gauge not exc 63 mm, deposited, spread and levelled in layers not exc 15 cm thick watered and well rammed to a true surface complete all as specified and as directed.

M&L for cement concrete 1:2:4 type B2 (40 mm graded stone agg) as in sub base, filling and mass concrete complete all as specified and as directed.

M & L ready mix cement concrete of M-35 grade as in basement floors/mass concrete including finishing the surfaces even and smooth without using extra cement complete all as specified and as directed.

S&F RCC precast drain covers of size 600 x 900mm complete all as specified and as directed. Note : Reinforcement shall be measured and paid separately.

M&L mild steel TMT bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending , hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia complete all as specified and as directed..

Excavating in trenches, n.exc 1.5 M wide and n.exc 1.5 M in depth for foundation etc or for shafts, wells, cesspits, manholes, pier holes etc n.exc 10 Sqm on plan and n.exc 1.5 M in depth and gettging out in hard dense soils complete all as specified and as directed.

M&L for plain cement concrete 1:4:8 type D-2 (using 40 mm graded stone agg) as in foundations, filling and mass concrete, pot holes etc complete all as specified and as directed.

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars etc but excluding ashlar facings, dressed stone work and precast concrete articles and disposing off complete all as specified and as directed.

M&L brick work with sub class B bricks straight or curved on plan exceeding 6 m mean radius built in CM 1:6 complete all as specified and as directed.

All as per item No. 10 above but except bricks complete all as specified and as directed.

M&L for stone walling of random rubble uncoursed, brought up to course well bonded, bedded and solidly hearted built in cement mortar 1:4 complete all as specified and directed.

Extra over stone walling built in lime or sand stone, for hammer dressing to face stones with maximum depression on face from straight edge held against the dressed surface n. exc. 40 mm and dressing of face beds and joints, as specified, of random rubble walling, uncoursed or brought up to courses complete all as specified and directed.

M&L for raised pointing in CM 1:4 to RR masonry uncoursed or brought upto courses complete all as specified and directed .

Rendering 15mm thick cement plaster in cement mortor 1:6 on brick or concrete surfaces, surfaces to be finished even and smooth without using extra cement complete all as specified and as directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and as directed.

M&L for Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel heeting or other covering, running rails and guides) and hanging; also fastening and fixing complete all as specified and as directed.

S&F mild steel framed work such as grills, gratings, etc. with ends of bars shouldered and/or riveted or forged into spikes, framed guard bar; barred iron doors; ladder; framed balusters; walkj ways, railings, frame work for water tanks and similar work conforming to Fe 290 Gd E-165 complete all as specified and as directed.

Dismantling plain or corrugated steel/AC roof sheets any gauge, thickness, including Nainital or similar pattern roof covering complete all as specified and as directed.

S&F pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, chajjas, fixed with self tapping screws complete all as specified and as directed.

S&F pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, chajjas, valley gutter, ridge and fixed with crumple joint etc fixed with self tapping screws complete all as specified and as directed.

S & F steel work in tubular trusses including special shaped washer etc complete using ERW or induction butt welded tubes conforming to IS -1161 1979 grade St-240 complete all as specified and as directed.

M&L for preparation of newly steel surfaces of any description over 10 cm in width or girth not otherwise described and applying two coats of synthetic enamel paint complete all as specified and directed.

Demolition of unreinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and as directed.

M&L for plain cement concrete 1:4:8 type D-2 (using 40 mm graded stone agg) as in foundations, filling and mass concrete, pot holes etc complete all as specified and as directed.

M&L for machine pressed precast concrete inter locking paver block any shape and size with grey cement and pigment confirming to IS-15658-2006 of 60mm thickness M-35 Grade, glossy finished of approved colour laid over and including 25 mm thick fine sand cushion to a line and slope etc and joined complete including spreading screened river sand over surface for filling the joints with rising surface vibrator etc complete all as specified and as directed.

M&L fine sand cushion to a line and slope etc and joined complete including spreading screened river sand over surface for filling the joints with rising surface vibrator etc complete all as specified and as directed.

Material and Labour for machine pressed cheqered cement coloured tiles of size 300mmx300mmx20mm thick mix with grey cement and pigment laid over 15mm thick screed bed in CM 1:4 set and jointed and pointedin neat cement slurry in floors complete all as specified and directed .

M&L 20 mm thick Granite (of any type) work (table rubbed and polished) as in steps, jambs, pillars, window- cills,cooking platforms, working table and like over 20 mm thick screed bed or bedding layer in cement mortar (1:4), including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and as directed.

M&L preparation of paved/chequred floor area and applying one coat indigo floor paint or equivalent all as specified and directed.

M & L cement concrete type B1 1:2:4 (20 mm graded aggregate) as in apex stones,kerbs etc including weathering, slightly rounded or chamfered angles and throating, necessary form work complete all as specified and as directed.

M &L fixed in repairs Stainless steel railing made of hollow tubes, channels plate etc including welding, grinding,buffing, polishing and making curvature (where ever requird ) and fitting the same with necessary stainless steel nuts and bolts complete including fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc of required size complete all as specified and as directed.

Anil Industrial Corporation (BID ID -3178676)

Bright Construction Co (BID ID -3178709)

MAA VAISHNAV CONSTRUCTION (BID ID -3177357)

VIPUL CONSTRUCTION COMPANY (BID ID -3179051)

Vandan Enterprises (BID ID -3178703)

SHREE JAGDISH FURNITURE CO. (BID ID -3175942)

SAIRAM CONSTRUCTION (BID ID -3179038)