Construction of 01 No Guard Room and Toilet Block 04 Nos Toilet and 04 Nos Bathroom

(GUARD ROOM) Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30cm in depth. 1.5m in width as well as 10sqm on plan) including getting out and disposal of excavated earth lead up to 50m and lift up to 1.5m, as directed by Engineer-in-charge. All kinds of soil

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidation each deposited layer by ramming and watering, lead up to 50m and lift up to 1.5 m.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering –All work up to plinth level 1:3:6 (1 Cement: 3 Coarse sand (zone-iii) :6 graded stone aggregate 20mm nominal size)

Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15” landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 Cement: 1.5 Coarse sand (zone –III):3 graded stone aggregate 20mm normal size.

Centering and shuttering including strutting, propping etc. and removal of form for suspended floors, roofs, landings, balconies and access platform.

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete above plinth level. Thermo-Mechanically treated bars of grade Fe-500D or more.

Brick work with common burnt clay F.P.S (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement Mortar 1:6 (1 Cement : Coarse sand)

Brick work with common burnt clay F.P.S (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in: Cement mortar 1:6 (1Cement : 6 Coarse sand)

Cement concrete flooring 1:2:4 (1 cement : 2 Coarse sand:4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete 40mm thick with 20mm nominal size stone aggregate.

12mm cement plaster of mix:1:6 (1 cement: 6 fine sand)

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade: New work (two or more coats) over and including water thinnable priming coat with cement primer

Finishing walls with Acrylic smooth exterior paint of required shade : New work (Two or more coat Applied @ 1.67ltr/10sqm over and including priming coat of exterior primer applied @2.20kg/10sqm)

Providing wood work in frames of doors windows clerestory windows and other frames, wrought frammed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or dash fastener shall be paid for separately) sal wood

Providing and fixing ISI marked flush door shutters conforming to IS :2202 (Part I) non-decorative type, core of block board construction with frame of 1st class hard wood and well matched commercial 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters: 35mm thick including ISI marked Stainless Steel butt hinges with necessary screws.

Providing and fixing M.S. grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc. including priming coat with approved steel primer all complete, Fixed to steel windows by welding.

Providing and fixing factory made ISI marked steel glazed doors, windows and ventilators, side /top/centre hung, with breading and all members such F7D,F4B,K11 B etc, complete of standard rolled steel sections, joints mitred and flash butt welded and sash bars tenoned and riveted, including providing and fixing of hinges, pivots, including priming coat of approved steel primer, but excluding the cost of other fittings, complete all as per approved design, (Sectional weight of only steel members shall be measured for payment). Fixing with 15x3 mm lugs 10cm long embedded in cement concrete block 15x10x10cm of C.C 1:3:6 (1 Cement: 3 Coarse sand : 6 Graded stone aggregate 20mm nominal size)

Providing & fixing glass panes with putty and glazing clips in steel doors, window, clerestory windows, all complete with : 4.0mm thick glass panes.

Providing and fixing aluminium sliding door bolts, ISI marked anodized (anodic coating not less than grade AC 10 as per IS: 1868), transparent or dyed to required colour or shade, with nuts and screws etc. complete: 300x16mm

Providing and fixing aluminium tower bolts, ISI marked, anodised (anodic coating not less than grade AC 10 as per IS:1968) transparent or dyed to required colour or shade with necessary screws etc. complete: 250x10mm.

Providing and fixing aluminium handles, ISI marked, anodised (anodic coating not less than grade AC 10 as per IS:1868)transparent or dyed to required colour or shade with necessary screws etc complete: 125mm.

Providing and fixing aluminium hanging floor door stopper, ISI marked, anodised (anodic coating not less than grade AC 10 as per IS: 1868) transparent or dyed to required colour and shade, with necessary screws etc. complete twin rubber stopper.

Providing and fixing aluminium casement stays, ISI marked, anodized (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour and shade with necessary screws etc complete.

Providing and fixing bright finished brass casement window fastener with necessary screws etc. complete.

(TOILET AND BATHROOM -04 NOS) Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30cm in depth. 1.5m in width as well as 10sqm on plan) including getting out and disposal of excavated earth lead up to 50m and lift up to 1.5m, as directed by Engineer-in-charge. All kinds of soil

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidation each deposited layer by ramming and watering, lead up to 50m and lift up to 1.5 m.

Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering- All work up to plinth level:1:4:8 (1 Cement : 4 Coarse sand (zone-III): 8 graded stone aggregate 40mm nominal size)

Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15º landings, balconies, shelves, chajjas, lintels, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement: 1.5 coarse sand (zone-III) : 3graded stone aggregate 20 mm nominal size). :1.5:3 (1 cement : 1.5 coarse sand (zone-III) :3 graded stone aggregate 20mm nominal size.

Centering and shuttering including strutting, propping etc. and removal of form for:Foundations, footings, bases of columns etc for mass concrete.

Centering and shuttering including strutting, propping etc. and removal of form for:Lintels, beams, plinth beams, girders, bressumers and cantilevers.

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete above plinth level. Thermo-Mechanically treated bars of grade Fe-500D or more.

Brick work with common burnt clay F.P.S.(non modular) bricks of class designation 7.5 in foundation and plinth in Cement mortar 1:6 (1 cement : 6 coarse sand)

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in: Cement mortar 1:6 (1 Cement : 6coarse sand)

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level Cement mortar 1:4 (1 Cement: 4 coarse sand)

Cement concrete flooring 1:2:4 (1 Cement: 2 Coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.40mm thick with 20mm nominal size stone aggregate

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washer etc. complete Hot finished welded type tubes.

Providing corrugated G.S. sheet roofing including vertical/ curved surface fixed with polymer coated J or L hooks, bolts and nuts 8mm diameter with bitumen and G.I limpet washers or with G.I. limpet washers filled with white leas, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/ vertical or curved surfaces) excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.0.63mm thick with zinc coating not less than 275 gm/m2

Providing ridges or hips of width 60cm overall width plain G.S. Sheet fixed with polymer coated J or L hooks, bolts and nuts 8mm dia G.I. limpet and bitumen washers complete.0.63 mm thick with zinc coating not less than 275 gm/m2m

12mm cement plaster of mix: 1:6 (1 Cement : 6 fine sand)

Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gms/litre, of approved manufacturer’s specification Two or more coats on new work.

Finishing walls with acrylic smooth exterior paint of required shade: New work (Two or more coat applied @ 1.67 ltr/10sqm over and including priming coat of exterior primer applied @ 2.20 kg/10sqm)

Providing and fixing water closet squatting pan (Indian type W.C pan) with 100mm sand cast iron P or S trap, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231, with all fitting and fixtures complete, including cutting and making good the walls and floors wherever required: White vitreous china Orissa W.C pan of size 580 x 440 mm with integral type foot rests

Providing and fixing wash basin C.I. brackets, 15mm C.P. brass pillar taps, 32mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever require: White Vitreous China wash basin size 630x450mm with a single 15mm C.P. brass pillar tap

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. Waste fittings complete.Flexible pipe 32mm dia

Providing and fixing 600x450mm bevelled edge mirror of superior glass (of approved quality) complete with 6mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete.

Providing and fixing G.I. pipes complete with G.I. fittings and clamps, i/c cutting and making good the walls etc. Internal work- Exposed on wall.15mm dia nominal bore.

Providing and fixing G.I. pipes complete with G.I. fittings including trenching and refilling etc. External work 25mm dia nominal bore

Providing and fixing brass bib cock of approved quality: 15mm nominal bore

Providing and fixing brass stop cock of approved quality: 15mm nominal bore

Providing and fixing gun metal gate valve with C.I. wheel of approved quality (screwed end): 25 mm nominal bore

Providing and fixing ball valve (brass) of approved quality, high or low pressure, with plastic floats complete: 25mm nominal bore

Providing and fixing brass ferrule with C.I. mouth cover including boring and tapping the main: 15mm nominal bore

Providing and fixing uplasticised PVC connection pipe with brass unions: 30 cm length, 15 mm nominal bore

Providing and fixing C.P. brass shower rose with 15 or 20 mm inlet: 150 mm diameter

Providing and fixing PVC door with frames and all accessories

SWR pipe fitting

Septic tank Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30cm in depth. 1.5m in width as well as 10sqm on plan) including getting out and disposal of excavated earth lead up to 50m and lift up to 1.5m, as directed by Engineer-in-charge. All kinds of soil

Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering- All work up to plinth level:1:4:8 (1 Cement : 4 Coarse sand (zone-III): 8 graded stone aggregate 40mm nominal size)

Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15” landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 Cement: 1.5 Coarse sand (zone –III):3 graded stone aggregate 20mm normal size.:1.5:3 (1 cement : 1.5 coarse sand (zone-III) : 3 graded stone aggregate 20mm nominal size)

Centering and shuttering including strutting, propping etc. and removal of form for: Foundation, footings, bases of columns, etc, for mass concrete

Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete above plinth level Thermo-Mechanically treated bars of grade Fe-500D or more

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement : 6 coarse sand)

Cement concrete flooring 1:2:4 (1 Cement : 2 Coarse sand: 4 Graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.40mm thick with 20mm nominal size stone aggregate

12 mm cement plaster of mix: 1:6 (1 cement : 6 fine sand)

SANJAY PANDEY

M/s MAA VINDHYAVASHINI CONSTRUCTION