PROVISIONING OF BOOM BARRIER AT BOTH MAIN GATE OF ICG LAND ALONGWITH HUMP TYPE PUNCTURING SYSTEM AT ICGS KARAIKAL UNDER GE(I) CG CHENNAI

Amount

Supply , Installation, Testing, Commissioning of Electro Mechanical Boom Barrier of length 6 Meter length with height of boom 1meter ,housing dimensions 320x270x1018 mm,2 mm thick,boom dimensinon 90x32 mm, IP55 controller protecting rating ,230 V,50/60 HZ ,24 V motor power supply ,120 W Power and Opening/Closing Time - 4- 5 Sec, 100% Duty cycle,- 20 degree C to +52 degree C operating temperature ,5 million cycle MCBF including necessary foundation/ fixing arrangements ,optical beam sensor ,access control operation, high range receiver,high range remote control,push button ,photosensor for human safety,loop detector, bar with protective rubber profile ,flash point , manual operation in case of power failure and all connected accessories complete all as specified and as directed. Make: M/S BGI ENGITECH PVT LTD : Model No: L1000 or equivalent make approved by GE. Note:The rate quoted by the tenderer shall includes Supply , Installation, Testing, Commissioning of Boom Barrier including necessary foundation as per OEM instructions ,cabling of required connection from power point provided by the department and necessary operational training for users personnel

Supply , Installation, Testing, Commissioning of galvanised mild steel body Bidirectional Two Way Tyre Killer ,length of the block 5.50 Meter, width of the block - 1000 mm and a depth of 330 mm , height of spike above block - 90 mm ,MTBF -10 million operation,spike dimension :200*45 mm ,thickness of strip :15 mm, spike to spike distance : 85 mm, Push button with a remote control operation, Power supply of 5-6 ATM air pressure 110-240 Volts AC (compressor) with control panel and manual operation in case of power failure with 05 cycle up and down movements, high level shock resistance and extremely sturdy ,opening speed of 1 seconds ,operating temperature -20 degree C to 60 degree C ,foundation depth of 500 mm with foundation construction details as per manufacturers instructions ,system type of active 2 way spikes, hollow with provision for compressed air vent on each spike,Pneumatic mechanism,250 cycles per hour,5000 cycles per day with a self cleansing mechanism and drainage system and finishing treatment with Zinc coating stainless steel cover for anti corrosive treatment complete all as specified and as directed. Make: M/S BGI ENGITECH PVT LTD Model no : S1000 spike system or equivalent make approved by GE. . Note:The rate quoted by the tenderer shall includes Supply , Installation, Testing, Commissioning of Tyre killer including necessary foundation as per OEM instructions ,cabling of required connection from power point provided by the department and necessary operational training for users personnel.

Supply and lay in trenches / floor / roof / wall XLPE Insulated sheathed, screened PVC bedded, galvanized steel strip or wire armoured electric power cable (heavy duty) 1100 Volts grade with stranded aluimnium conductor of size 16 Sqmm 4 Core, including testing and commissioning complete all as specified and as directed.. Make:Finolex/Poly cab/ RR Kabel Note: Excavation, earth work and cable protection shall be measured and paid separately.

Excavating in trenches not exceeding 1.5 metre wide and not exceeding 1.5 metre in depth for foundation not exceeding 10 sqm on plan and getting out in soft / loose soil complete all as specified and directed

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm using excavated soil complete all as specified and as directed.

Removing excavated surplus soil not exceeding 50 metres and depositing where directed at a level not exceeding 1.5 metre above the starting point complete all as directed.

Supply, lay , spread in trenches, M sand including cleaning, spreading, levelling, punning for laying /cushioning of cable complete all as specified and as directed. Note: Punning thickness shall be measured and paid.

Supply, lay in trenches common burnt fly ash Bricks of size 230 mmx115 mmx75 mm for cable protection complete all as specified and as directed.

Material and Labour for 40mm bore `light grade` galvanised tubes with all fittings, laid in trenches complete all as specified and as directed .Make: Tata/Zenith/Jindal

Supply and fix PVC flexible cable copper conductor of size 3 core 1.5sqmm in 20 mm dia PVC Conduit complete all as specified and as directed. Make : Finolex /Havells/Anchor

Supply and fix PVC flexible cable copper conductor of size 3 core 1 sqmm in 20 mm dia PVC Conduit complete all as specified and as directed. Make : Finolex /Havells/Anchor

Material and labour for Earthing complete with galvanized steel earth plate electrode 60cm x 60cm x 6mm thick burried directly in ground (earth pit not less than 2.25m deep below ground level) with top edge of the plate not less than 1.5 meter below normal ground level connected to galvanized earth strip 32x6mm by means of bolts, nuts washers, check nuts as shown in electrical plate No. 3 connected to earthing test points including excavation and earth work PCC 1:2:4 type B-1(using 20mm graded stone aggregate) in PCC chamber RCC cover 50mm thick in RCC 1:2:4 type B-1 ( 20mm graded stone aggregate) with 8 mm TMT bars at 15 cm c/c in both ways with hooks, funnels with 20 mm dia GI watering pipe medium grade, wire mesh and funnel 15 mm dia GI protection pipe light grade and testing on completion complete all as specified and as directed.

Material and labour for MS frame work for roof truss, purlin, racks fastening with angle cleats and heavy bracket frames etc for making sheed all as specified and as directed.

Material and labour for Pre- painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and as directed. Make:Tata Blue Scope/Jindal/Llyod

Supply and fix MCB DBs TPN, 4 Way double door Sheet metal Enclosure A/C 415 Volts all as specified and as directed Make: L&T/Legrand/ABB/Siemns/Havells

Supply and fixing 415V 10KA 'C' curve miniature circuit breaker (MCB) of 40A TPN in the DB complete with connection testing and commissioning all as specified and as directed.Make: L&T/Legrand/ABB/Siemns/Havells

Supply and fix MCB SP 6-32A A/C 230 Volts 10KA 'C' curve in the DB complete with connection testing and commissioning all as specified and as directed. Make: L&T/Legrand/ABB/Siemns/Havells

Supply and fix Rigid non-metallic PVC conduit 40 mm external dia, inclusive of all tees, bends,elbows, reducers, bell mouth tube ends and fixing accessories such as couplers, lock nuts, saddles, pipe hooks etc. all as specified and as directed. Make: Polycab/Astral/Avon

Supply and fix Rigid non-metallic PVC conduit 20 mm external dia, inclusive of all tees, bends,elbows, reducers, bell mouth tube ends and fixing accessories such as couplers, lock nuts, saddles, pipe hooks etc. all as specified and as directed. Make: Polycab/Astral/Avon

Excavating over areas, n exc 1.5 m deep and getting out Hard/Dense soil complete all as specified and as directed.

M&l for PCC type D2 1:4:8 (40mm graded aggregate) as in foundation filling and mass concreting as in sub base complete all as specified and as directed.

Material and labour for Brick work with flyash bricks, straight or curved on plan exceeding 6 M mean radius built in cement mortar 1:6 complete all as specified and as directed.

Plain Cement Concrete Type C1 1:2:4 (using 20 mm graded stone aggregate) cast in situ in lintels up to 1.5 M span, cills and other similar bands, plinth courses, parapets, copings, bed plates, water troughs and the like including weathering, slightly rounded or chamfered angles and throating as directed including use and waste of form work complete all as specified and as directed.

S & F Rolled Mild Steel Plates (plain or Chequered) channels, square cut or notched, forming holes, without any attachment confirming to Fe-410-W(Gde- E-250) quality- B complete all as specified and as directed.

Supply and fix MS screw bolt not exceeding 5Cm longmand neck dia 11-15 mm,machine made wih hexagonal or square head a one end and screwed the other or screwed the both ends,fitted with washers andhexagonal nuts and drilling etc of section confirming to Fe-290 Gde E-165 complete all as specified and as directed

Demolition of unreinforced cement concrete in ground floor and pavings n.exc. 15 cm thick (below or above GL) complete all as specified and directed by Engineer in Charge

Material and labour for Hard core of gauge n exc 63 mm graded crushed stone aggregate deposited spread and levelled in layers n exc 15 cm thick watered and rammed to a true surface complete all as specified and as directed

Material and labour for Rendering in CM 1:4, ,15 mm thick on fair faces of brick work surfaces ,finished even and smooth without using extra cement complete all as specified and as directed.

Material and labour for Preparation of new Steel surfaces of any description not other wise described over 10cm width or girth and applying two coats of synthetic enamel paint over one coat of primer complete all as specified and as directed.

N SARAVANAN

lakshmibuilders

VIJAYALAKSHMI ENTERPRISES

Sri Lakshmi and Company