Supply, Installation, Testing and Commissioning of new cold room in Block-I 125 and 301 Academic Area at IIT Delhi.

Amount

Supply, Installation, Testing & Commissioning of 60 mm thickness SS/SS 304 Grade PUF Panels , 60 mm Bare PUF floor insulation with 60 mm SS/SS flush type door & View Port (300 x 300 mm) for Room Size 18'9" x 15'8" x 9' as per specification as mentioned. Annexure –4 [i/c lighting arrangement]

Supply, Installation, Testing & Commissioning of fully dressed 2 Set (1W+1S by) 40000 BTU/H Condensioning unit with matching evaporating unit as per specifications as mentioned Annexure-4

Supply, Installation, Testing & Commissioning of 60 mm thickness SS/SS 304 Grade PUF Panels , 60 mm Bare PUF floor insulation with 60 mm SS/SS flush type door & View Port (300 x 300 mm) for Room Size 14' x 9'1" x 9' as per specifications as mentioned Annexure –5 [i/c lighting arrangement]

Supply, Installation, Testing & Commissioning of fully dressed 1Set 20000 BTU/H Condensioning unit with matching evaporating unit as per specifications as mentioned Annexure-5

Civil work in cold rooms

Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 meters lead as per direction of Engineer-in-charge. In cement mortar

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level. Cement mortar 1:4 (1 cement :4 coarse sand)

12 mm cement plaster of mix: 1:6 (1 cement: 6 fine sand)

Disposal of building rubbish / malba / similar unserviceable, dismantled or waste materials by mechanical means, including loading, transporting, unloading to approved municipal dumping ground or as approved by Engineer-in-charge, out site IIT campus. Including GST as required on site.

Kota stone slabs 20 mm thick in risers of steps, skirting, dado and pillars laid on 12 mm (average) thick cement mortar 1:3 (1 cement: 3 coarse sand) and jointed with grey cement slurry mixed with pigment to match the shade of the slabs, including rubbing and polishing complete.

Providing and fixing frame work for partitions/ wall lining etc. made of 50x50x1.6mm hollow MS tube, placed along the walls, ceiling and floor in a grid pattern with spacing @ 60 cm centre to centre both ways (vertically & horizontally) or at required spacing near opening, with necessary welding at junctions and fixing the frame to wall/ ceiling/ floors with steel dash fasteners of 8 mm dia, 75 mm long bolt, including making provision for opening for doors, windows, electrical conduits, switch boards etc., including providing with two coats of approved steel primer etc. complete, all as per direction of Engineer-in-charge.