Renovation of Community Toilet at Chilurghat BazarPart No 10/270 at Chilurghat in Bhatibari G.P. within Alipurduar II Block

P-1, It - 2: Earth work in excavation of foundation trenches or drains, in all sorts of soil (including mixed soil but excluding laterite or sandstone) including removing, spreading or stacking the spoils within a lead of 75 m. as directed. The item includes necessary trimming the sides of trenches, levelling, dressing and ramming the bottom, bailing out water as required complete.

P-1, It - 3 :- Earth work in filling in foundation trenches or plinth with good earth, in layers not exceeding 150 mm. including watering and ramming etc. layer by layer complete. (Payment to be made on the basis of measurement of finished quantity of work) (a) With earth obtained from excavation of foundation.

P-47, It-1:- 25mm. thick damp proof course with cement concrete with stone chips (1:1.5:3) [with graded stone aggregate 10 mm nominal size] and admixture of water proofing compound as per manufacturer's specification followed by two coat of polymer based paint, (1st coat after 4 to 5 days of concrete laying and 2 nd coat just before brick masonry work) as directed (cost of water proofing compound & polymer based paint to be paid separately).

P-47, It-3:- Supplying and laying Polythene Sheet (150gm / sq.m.) over damp proof course or below flooring or roof terracing or in foundation or in foundation trenches.

P-15, It-07 :- Brick work with 1st class bricks in cement mortar (1:6) (a) In foundation and plinth

(b) In superstructure, Ground floor

P-16, It-16:-125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in Ground floor.

P-26, It-10 :-Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. (i) (ii ) River Bazree …… in foundation

P-24, It-4 :- Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement,if any, in ground floor as per relevant IS codes (ii ) River Bazree

P-42, It-36.a :- Hire and labour charges for shuttering withcentering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (a) 25 mm to 30 mm thick wooden shuttering as per decision & direction of Engineer-In-Charge.

P-44, It-40 :- Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction. (a) For works in foundation, basement and upto roof of ground floor/upto 4 m (i) Tor steel/Mild Steel

P-189, It-1:- Plaster (to wall, floor, ceiling etc.) with sandard cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface] (ii) With 1:4 cement mortar (c) 10 mm thick plaster

(a) 20 mm thick plaster :- (inside of wall)

(b) 15 mm thick plaster (out side wall) :-

P-192, It-15:-Neat cement punning about 1.5mm thick in wall,dado,window sill,floor etc. NOTE:Cement 0.152 cu.m per100 sq.m.

P-55, It-22 :-Supplying, fitting and fixing Marble Slab/tile of 15 to 18 mm thickness in floor, lobby, stair, landing & treads etc. over 20 mm (av.) thck base of Cement mortar (1:2) laid with white cement slurry @ 4.4 kg/Sq.m before placing marble & jointed with white cement slurry @ 2.0 kg/Sq.m with necessary pigments including grinding and Granite polishing as per direction of Engineering -in - Charge in Ground Floor. {White cement and Pigment to be supplied by the Agency] (b) With Chawk Dungri (iii) Area of each tile exceeding 0.6 sq.m but not excedding 1 sq.m.

P-197, I-15:-Applying decorative cement based paint of approved quality after preparing the surface including scraping the same thoroughly (plastered or concrete surface) as per manufacturer's specification. In Ground floor: (iii) Two coats.

P-196, It-10:- Acrylic Distemper to interior wall, ceiling with a coat of solvent based interior grade acrylic primer (as per manufacturer's specification) including cleaning and smoothning of surface. Two Coats

SECTION (B) - SANITARY AND DRAINAGE WORKS:- (B)-(III) WATER CLOSETS AND URINALS:- Page-79, It-4: Supplying, fitting and fixing Orissa pattern water closet in white glazed vitreous chinaware of approved make in position complete excluding 'P' or 'S' trap (excluding cost of concrete for fixing). (ii) 530 mm X 410 mm

SECTION (B) - SANITARY AND DRAINAGE WORKS (B)-(II) SOIL PIPE AND FITTINGS Page-70, It- 23 Supply of UPVC pipes (B Type) & fittings conforming to IS-13592-1992(B) Fittings, v) Plain Y , (b) 110 mm

Do (ii) Plain Tee (b) 110 mm

Do xi) Door Bend (T.S.) (b) 110 mm

(B)-(III) WATER CLOSETS AND URINALS Page-80, It-6: Supplying, fitting and fixing Flat back urinal (half stall urinal) in white vitreous chinaware of approved make in position with brass screws on 75mm X 75 mm X 75 mm wooden blocks complete.(ii) 470 mm X 280 mm X 340 m

(B)-(II) SOIL PIPE AND FITTINGSPage-69, It - 23: Supply of UPVC pipes (B Type) & fittings conforming to IS-13592-1992 (A) (ii) Double Socketed 3 Meter Length (b) 110 mm

Supply, fitting & fixing PVC door with locking arrangements (L.S.)

[Ref: P.W.D. (Plumbing) item no-6, Page-37] Supplying P.V.C. water storage tank of approved quality with closed top with lid (Black) - Multilayer -(a) 500 litre capacity

[Ref: P.W.D. (Plumbing) item no-10, Page-37] Labour for hoisting plastic water storage tank.(i) Upto 1500 litre capacity.(a) Upto 1st story from G.L.

Electrification and Plumbing charges (Wireing,Casing & Motor Etc (Payment will be made as per Voucher)

[Ref: P.W.D. (Plumbing) item no-19(I), Page-12] Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (mediumduty) conforming to ASTMD-1785 and threaded to match with GI Pipes as per IS : 1239 (Part-I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, long screw, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials.Payment for painting will be made seperately).(a) For Exposed Work PVC Pipes. 15mm

[Ref: P.W.D. (Plumbing) item no-19(I), Page-12] Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (mediumduty) conforming to ASTMD-1785 and threaded to match with GI Pipes as per IS : 1239 (Part-I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, long screw, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials.Payment for painting will be made seperately).(a) For Exposed Work PVC Pipes. 20mm

[Ref: P.W.D. (Plumbing) item no-19(I), Page-12] Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (mediumduty) conforming to ASTMD-1785 and threaded to match with GI Pipes as per IS : 1239 (Part-I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, long screw, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials.Payment for painting will be made seperately).(a) For Exposed Work PVC Pipes. 20mm

SINKING OF NEW TUBEWELL with plat form, drain & Soak pits etc.

Providing and fixing of Concrete sign boardas per MORD specification and drawing . Three MS Plates of 1.6mm thick, top and middle plate duly welded with MS flat iron 25mm x 5mm size on back on edges. The lower plate will be welded with MS angle iron frame of the lower most plate and flat iron frame of middle plate will be welded to 2 nos 75mm x 75mm of 12 SWG sheet tubes posts duly embeded in cement concrete M15 grade blocks of 450mm x 450mm x 600mm, 600mm below ground level . The top most diamond plate will be welded to middle plate by 47mm x 47mm of 12 SWG steel plate tube. All MS will be stove enameled on both sides . Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. all sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing Clause 1701 and annexure 1700.1including cost of lighting, barricading, protection etc.

AD LABOUR CESS 1%

AD SGST 9%

AD CGST 9%