Construction of room for attendant at site of Solid waste Management at Sui MC Udhampur

Amount

Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. (not exceeding 1.50 mtrs in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, depth upto 1.50 mtr. Including disposal of excavated earth upto 1 mtrs from cutting edge, disposed earth is to be levelled and neatly dressed in: All kinds of soil.

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering – all work upto plinth level. 1:5:10 (1 cement: 5 fine sand: 10 graded stone aggregate 40 mm nominal size) crusher

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering- All work upto plinth level. 1:3:6 (1 cement: 3 coarse sand :6 graded stone aggregate 20mm nominal size).

Brick work with common burnt clay F.P.S (non-modualar) bricks of class designation 75 in foundation and plinth in cement mortar 1:6( 1 cement:6 fine sand)

Providing and laying damp-proof course 40 mm thick with cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 12.5 mm nominal size) Crushed

Brick work with common burnt clay F.P.S (non-modualar) bricks of class designation 75 in foundation and plinth in cement mortar 1:6( 1 cement:6 fine sand)

Extra for brick work in superstructure above plinth level upto floor V level (by manual means).

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately): Sal Wood

Providing 40x5 mm flat iron hold fast 40 cm long including fixing to frame with 10 mm diameter bolts, nuts and wooden plugs and embeddings in cement concrete block 30x10x15 cm 1:3:6 mix (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size)

Providing and laying in position specified grade of reinforced cement concrete excluding the cost of centering, shuttering, finishing and reinforcement all work upto plinth level.1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggregate 20 mm nominal size)

Reinforcement of RCC work including straightening, cutting, bending, placing in position and binding all complete. Cold twisted bars.

Centring and shuttering including strutting, propping etc. and removal of form for: Foundations, footings, bases of columns etc. for mass concrete.

Centring and shuttering including strutting, propping etc. and removal of form for Suspended floors, roofs, landings, balconies and access platform.

Centring and shuttering including strutting, propping etc. and removal of form for Literls, beams, plinth beams, girders, bressumers and cantilevers.

Centring and shuttering including strutting, propping etc. and removal of form for: Edges of slabs and breaks in floors and walls. Under 20 cms wide.

15 mm cement plaster on the rough side of single or half brick wall of mix: 1:6 (1 cement : 6 fine sand)

6 mm cement plaster to ceiling of mix 1:3 (1 cement : 3 fine sand)

Cement concrete flooring 1:2:4 (1 cement: 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20 mm nominal size stone aggregate crushed

Providing & fixing glass strips in joints of terrazo/ cement concrete floor 40 mm wide and 4 mm thick

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows including ISI marked MS pressed butt hinges bright finished of required size with necessary screws excluding panelling which will be paid for separately, all complete as per direction of engineer-in-charge. Second class deodar wood 35 mm.

Providing and fixing 35 mm thick wire gauze shutters using galvanised M.S. wire gauze of average width for aperture 1.4 mm in both direction with wire of dia. 0.63 mm for doors, windows and clerestory windows with hinges and necessary screws: ISI marked M.S. pressed bright finished butt hinges with necessary screws of required size. Second class deodar wood.

Providing and fixing panelling or panelling and glazing in panelled or panelled and glazed shutters for doors, windows and clerestory windows (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick. Particle Board 12 mm thick. Plain particle board flat pressed, 3 layer or graded wood particle board medium density Grade I, IS : 3087 marked.

Providing and fixing panelling or panelling and glazing in panelled or panelled and glazed shutters for doors, windows and clerestory windows (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick. Float glass panes. 4 mm thick glass panes.

Applying one coat of water thinable cement primer of approved brand and manufacture on wall surface. Water thinable cement primer

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade. New work (two or more coats) over and including priming coat with cement primer.

Finishing walls with water proofing cement paint of approved brand and manufacture and of required shade to give an even shade. New work (two or more coats) applied @3.84 Kg/ 10 sqm.

Applying priming coat with ready mixed aluminium primer of approved brand and manufacture on resinous wood and ply wood.

Applying priming coat with ready mixed pink or grey primer of approved brand and manufacture on wood work (hard and soft wood)

Painting with ready mixed synthetic enamel paint of approved brand and manufacture in all shades to give an even shade. New steel work (two or more coats)

PARDUMAN SINGH CONTRACTOR

rajkumar sharma