CONSTRUCTION OF TIN SHED AT C.H.C AT HATHGAON , FATEHPUR

Earthwork in excavation by mechnical means (Hydraulic excavator)/manual means in foundation trenches or drains, excavated soil and disposal of surplus excavated soil as directed by Engr. Incharge within a lead of 50 m including dressing of sides and ramming of bottoms, lift upto 1.5 m DSR 2.8.1

Providing and laying cement concrete 8:4:1 [Stone ballast 8 (40mm normal size) : 4 sand : 1 cement] and curing etc all complete. As per DSR 4.1.8

RCC with 1:1.5:3 with cement, coarse sand and 20mm stone grit in foundation & footing including all materials, labours, T&P etc all complete. DSR 5.1.2

Centering and shuttering including strutting, propping etc. and removal for foundation , footing ….etc DSR 5.9.1

Steel reinforcement for R.C.C. work including straightening, cutting. bending, placing in position and binding all complete upto plinth level.. DSR 5.22.1

12 mm plaster of mix 1:4 (coarse 12 mm cement plaster of mix: 1:4 (1 cement: 4 coarse sand. DSR 13.4.1

S/f of MS anchor bolt with nut 20 mm dia 60cm long with hold fast .

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. DSR 10.16.1

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.D.S.R.10.2

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineerin-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. D.S.R 12.50

Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+ 0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete :DSR 12.51.1 Gutter (600 mm over all girth)

Painging and varnishing on iron works in small areas or new wood work with one coat of ready mixed priming paint & one coat of approved superiod quality ready mixed paint of clear synthetic varnish including supply of all materials labour and T & P etc. required for proper completion of the work paint to be used should confirm to the DSR 13.53.1

P/L of information road signboard at site including all mateirla labour etc complete

Less 1% Labour Cess

Less 5% Department