Construction of Water tank and repair and facelifting of PWD R B Division office at Basohli

Amount

Earthwork in excavation by mechanical means (Hydraulic excavator) over areas (Exceeding 30cm in depth,1.5mtr in width as well as 10 Sqm on plan) including disposal of excavated earth, lead upto 50m and lift upto 1.50m, disposal earth to be leveled and neatly dressed: a) All kind of soil.

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering –All work upto plinth level (including all leads and lifts carriages of material by M.T./H.L.)

a) 1 : 4 : 8 (1 cement : 4 fine sand : 8 graded nallah stone aggregate 40mm nominal size).

1 : 3 : 6 (1 cement : 3 coarse sand : 6 graded crushed stone aggregate 20mm nominal size).

Brick work with common burnt clay F.P.S. (non-modular) bricks of class designation 75 in foundation and plinth in cement mortar 1:6 (1 cement : 6 fine sand) (including all leads and lifts carriages of material by M.T./H.L.)

Providing and laying Reinforced cement concrete 1:1.5:3(1 Cement: 1.5 Coarse Sand: 3 graded crushed stone aggregate 20 mm nominal size) in suspended floors, roofs,balconies, landings and staircases having upto 15° slope excluding the cost of centering & shuttering. All works upto Floor V level. a) 1: 1.5: 3 (1 Cement: 1.5 Coarse Sand: 3 graded crushed stone aggregate 20 mm nominal size). (including all leads and lifts carriages of material by M.T./H.L.)

Reinforcement for RCC work including straightening, cutting, bending, placing in position and binding all complete. a) Cold twisted bars.

Centering and shuttering including strutting, propping etc. and removal of form work for:- .

a) Foundations, footing, bases of columns etc for mass concrete

b) Suspended floors, roofs landings balconies and access plate form

c) Edges of slab and breaks in floors and walls under 20cm wide.

d) Weather shade, Chajja, Corbels etc. including edges.

Repair to plaster of thickness 12mm to 20mm in patches of area 2.5 sqm. and under including cutting the patch in proper shape raking out joints and preparing and plastering the surface of the walls complete including disposal of rubbish to the dumping ground within 50 mtr. lead. A) With cement mortar 1:4 (1 cement: 4 coarse sand) (including all leads and lifts carriages of material by M.T./H.L.)

Finishing wall with water proofing cement paint of required shade. a) Old work (Two or more coats applied).

12mm cement plaster on brick wall of mix 1 : 6 ( 1 cement : 6 fine sand) (including all leads and lifts carriages of material by M.T./H.L.)

Half brick masonry with bricks of class designation 75 in foundations and plinth in Cement mortar 1:4 (1 cement: 4 coarse sand) (including all leads and lifts carriages of material by M.T./H.L.)

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade. a) Old work.

Providing and fixing nickel plate M.S.pipe curtain rods with nickel plated bracket.

Providing, stiching & fixing up of window curtain in requirted size made up of 100% polyster tabric complete job to be carried out as per specifications and direction of Engineer-in-charge.

Fnishing walls with acrylic smooth exterior paint of required shade. a) Old work (two or more coats applied @ 1.67 litre/ 10 sqm. on existing cement paint).

White washing with lime to give an even shade: a) Old work (Two or more coats).

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lungs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately Sal wood

Providing 40x 5mm flat iron hold fast 40cm long including fixing to frame with 10mm diameter bolts, nuts and wooden plugs and embeddings in cement concrete block 30 x 10 x 15 cm 1 : 3: 6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20mm nominal size) (including all leads and lifts carriages of material by M.T./H.L.)

Renewing glass panes with putty and nails wherever necessary. a) Flat glass panes of thickness 5.5 mm

Dismantling doors, windows and clerestory windows (steel or wood) shutter including chowkhats, architrave, holdfast etc. complete and stacking with 50 metres lead.

Providing and fixing 35mm thick glazed shutters for doors, windows and clerestory windows using 10 kg/ sqm (4mm thick) float glass panes including ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws Second class deodar wood

Providing and fixing M.S. grills of required pattern in frames of windows etc with M.S. flats, square or round bars etc. all complete fixed to openings / wooden frames with rawl plugs screws etc.

Providing / fixing aluminium work for doors, windows, ventilator etc. power coated aluminium (minimum thickness of power coated is 50 microns).

Providing/ fixing glazing in aluminium door, windows, ventilators & partition etc with EPDM rubber with float glass of 4.00 mm thickness.

Providing and fixing aluminium handles ISI marked anodized (anodic coating not less than grade AC 10 as per IS:1868) transparent or dyed to required colour and shade with necessary screws etc. complete

Providing and fixing of 5mm thick aluminium composite pond in paneling and fixing in aluminium doors etc.

Filling gape in between aluminium frame adjust silicon sealed over bucker rod. a) 1 upto 5mm depth & 5mm width.

Providing and fixing IS:3564 marked aluminium extruded section by body tubular type universal hydraulic door closer (having superior brand) embossed on the body door weight upto 36-80 kg and door width upto 700-100 mm with double speed adjustment with necessary accessories and screws etc. complete.

Providing and fixing aluminium sliding door bolt ISI marked etc.

Providing and fixing of aluminum hanging floor door stopper ISI Marked anodized (anodic coating not less than grade AC 10 as per IS 1868) transparent or dyed to required colour or shade with nuts and screws complete Single rubber stopper.

Providing and fixing aluminum tower bolts ISI marked anodized (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with necessary screws etc. complete

Applying priming coat With ready mixed pink or grey primer of approved brand and manufacture on wood work (hard and soft wood).

Painting with synthetic enamel paint of approved brand and manufacture to given an even shade. a) Old work.

Providing and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making good the walls etc a) Concealed G.I. pipe including painting with anti-corrosive bitumastic paint, cutting chases and making good the walls.

i) 15mm dia nominal bore

ii) 20mm dia nominal bore

Providing and fixing ball valve (brass) of approved quality complete.

i) 20mm dia

ii) 25mm dia

Providing and fixing water closet squatting pan (Indian type W.C.pan) with 100mm sand cast Iron P or S trap, 10 litre low level white P.V.C. flushing cistern with manually controlled device (handle lever) conforming to IS: 7231, Parryware / Hindware / Seabird/Orient (Coral)/ Hindustan/Cera with all fittings and fixtures complete including cutting and making good the walls and floors wherever require. White Vitreous china Orissa Pattern W.C.pan of size 580 x 440mm with integral type foot rests. i) Long Pan Pattern white vitreous china W.C.

Platform for Indian W.C.

Providing and fixing wash basin with C.I./M.S.brackets, (without pillar taps) 32mm C.P. brass waste coupling of standard pattern, including painting of fitting and brackets, cutting and making good the walls wherever required a) Flat back wash basin size 630 x 450mm with taps and including the pedestal (Jaguar Make).

Providing and fixing on wall face unplasticised - Rigid PVC rain water pipes conforming to IS : 13592 Type A including jointing with seal ring conforming to IS : 5382 leaving 10 mm gap for thermal expansion. (i) Single socketed pipes 110mm dia

Regrading terracing of mud phaska covered with tiles or bricks, in cement by dismantling tiles or bricks, removing mud plaster preparing the surface of mud phaska to proper slope, relaying plaster gobri leaping and tiles or bricks, grouted in cement mortar 1:3 (1 cement:3 fine sand) including replacing unserviceable tiles or bricks with new ones and disposal of unserviceable material to the dumped ground (the cost of the new tiles or brick excluded) within 50 metres leads (including all leads and lifts carriages of material by M.T./H.L.)

Providing and laying Damp Proof Course 50mm thick with cement concrete 1: 2 : 4 (1 Cement : 2 coarse sand : 4 graded crushed stone aggregate 12.5mm nominal size) floor (including all leads and lifts carriages of material by M.T./H.L.)

Providing and fixing PVC loose collar (Supreme/Prince make). i) 100mm dia.

Providing and fixing PVC plain bend (Supreme / Prince make). a) 100mm dia.

Providing and fixing door bend (Supreme / Prince make). i) 100mm dia.

Providing and fixing PVC door tee (Supreme /Prince make). a) 100mmx100mm dia.

Providing and fixing PVC terminal guard (Cowl) (Supreme / Prince make). i) 100mm dia.

Providing and fixing trap of self cleaning design with screwed down or hinged grating with or without bent arm complete, including cost of cutting and making good the walls and floor. i) 100mmx100mm.

Providing and fixing PTMT extension nipple for water tank pipe, fitting of approved quality, colour and make (Prayag or equivalent).

a) 32mm nominal bore.

b) 40mm nominal bore.

Supplying and fixing following sizes modules GI box alongwith modular base cover plate for modular switch in recess etc. as required

a) 10x2 Module (75mmx75mm).

b) 3 Module(100mmx75mm).

c) 4 Module (125mmx75mm)

d) 6 Module (200mmx75mm

e) 8 Module (125mmx125mm)

f) 12 module (200mmx150mm)

Supplying and fixing following modular switch socket on the existing modular plate and switch box including connections but excluding modular plate etc

a) 5/6 amp. Switch.

b) 3 pin 5/6 amp. Socket outlet.

c) 15/16 amp. Switch.

d) 6 pin 15/16 amp. Socket outlet.

Rewiring for light print / fan point / exhaust fan point / call bell point with 1.5 sqm FR PVC insulated copper conductor single core cable and 1.5 sqm. FR PVC insulated copper conduct or single core cable as each wire in existing surface recessed steel conduit including dismantling as required. a) Group-A.

Wiring for circuit / submain wiring alongwith earth wire with the following sizes of PVC insulated copper conductor, single core cable in surface /recessed PVC conduit as required.

a) 2x1.5sq.mm +1x1.5 sq.mm earth wire

b) 2x1.5sq.mm +1x2.5 sq.mm earth wire

Supplying and fixing of following electrical items suitable for operating on 240/230 volts AC, 50 HZ supply

i) Ceiling 1200mm(Crompton Greaves).

ii) Exhaust fan 300mm size(Crompton Greaves Trans Airier equivalent make).

Providing and fixing vertical blinds 100mm wide of washable synthetic material with extruded power coated headrail housing control units spacers, runners, tilt rod with reduction gear mechanism tilt control for 180 degree louvers made of approved fabric and colour upto the satisfaction of Engineer-in-charge (complete job).

Carriage of the following materials by Mechanical Transport from source to site of work incl. loading, unloading and stacking complete :- a) Sand from Kathua for an average lead of 84.00 Km. by M.T. b) Stone aggregate (Crushed bajree) below 20mm nominal size from Kathua for an average lead of 84.00 Km. by M.T. c) Stone aggregate 40mm nominal size & above for an average lead of 16.00 Km by M.T from Lohai. d) Bricks from Kathua for an average lead of 88.00 Km. by M.T.

Sardar Singh

Anju Devi