PWD/BWN/Rs.6.43 lacs/Special repair of Primary Health Centre at Village Kharak Kalan in Bhiwani Distt.

Amount

Earth work in excavation in foundations, trenches, etc.in all kinds of soils, not exceeding 2 metres depth including dressing of bottom and sides of trenches, stacking the excavated soil, clear from the edge of excavation and subsequent filling around masonry, in 15 cm layers with compaction, including disposal of all surplus soil, as directed within a lead of 30 metres. HSR(6.6)

Dismantling Brick Work, Tile Masonry or Tile Lining and Tile Terracing in cement (HSR 8.5(B)

Removing door and windows (wood and steel) with chowkats by making recesses in walls when the walls is not to be dismantlled (8.18)(a) Door

Scraping of Cement plaster HSR(8.32 (c )

Cement Concrete 1:8:16 with brick ballast 40mm nominal size in foundation and plinth. HSR(10.26).

Cement Concrete 1:4:8 with stone aggregate 40mm nominal size in foundation and plinth(HSR 10.39)

Cement Concrete 1:2:4 with stone aggregate 20mm nominal size in foundation and plinth. (HSR 10.41)

Precast cement concrete 1:2:4 with stone aggregate 20 mm nominal size in Kerbs and the like items, finished smooth with 6 mm thick cement plaster 1:3 on exposed surface including from work, placing and fixing in position, complete at the ground level or in first storey (HSR 10.77)

Tile terracing with one layer of tiles, 22.86 cm X 11.43 cm X 3.81 cm laid dry over a layer of mud mortar including grouting with cement sand mortar 1: 3 and top surface to be left clean.(HSR 13.14)

Corrugated G.I. sheet roofing 0.80 mm thick fixed with galvanised iron ‘J’ or ‘L’ hooks, 10 mm dia G.I. limpet and bitumen washers complete, excluding the cost of purlins, rafters and trusses. (HSR 13.18)

Top khurra 0.6 m x 0.6 m for rain water pipe in 25 mm thick cement concrete 1:2:4 over 50 mm thick cement concrete 1:8:16 in HSR(13.50)

Cement concrete 1:2:4 gola 10cm X 10cm quadrant along junction of roof with parapet wall finished smooth, where specially specified. (13.64)

Provding and fixing Ist quality ceramic glazed wall tiles confirming to I.S. 15622(thickness to be specified by the manufcturer) of approved make in all colours shades except burgundy,bottle green,black of any size as approved by Engineer-in-Charge in skirting risers of steps and dados over 23mm thick bed of cement mortar 1:3 coarse and jointed with grey cement slurry,including pointing in white cement mxied with pigment to matching shades complete-300x450mm (14.92) (b)

10 mm thick cement plaster 1:3 (HSR 15.2)

15 mm thick cement plaster 1:5 on the rough side of single or half brick wall (HSR 15.11)

Cement pointing 1:2 deep variety on brick and tile work (HSR 15.60)

Applying pink primer or aluminium priming ocat on wood work including preparation of surface, Knotting and stopping etc (16.2)

Painting two coats excluding priming coat with synthetic enamel paint in all shades on new wood work or matallic or plastered or concrete surfaces to give an even shade. HSR(16.3).

Painting two coats with synthetic enamel paint in all shades on old wood-work or metallic or plastered or concrete surfaces to give an even shade including rubbing down old paint. HSR(16.5).

Applying priming coat with cement primer in all shades on newly plastered or concrete exterior surfaces. (HSR 16.25)

Distempering with washable oil bound distemper (of approved manufacture) two coats on old distempered work. HSR(16.25).

Finishing walls with exterior decorative cement based paints such as snowcem, Robbiacem etc. on new work, two coats to give an even shade (HSR 16.61)

Factory manufactured panelled door or glazed window, shutters of commercial hard wood, such as hollock, champ,chikrassy and chaplash,etc.,(non-coniferous timber other than teak,conforming to I.S.specification No.1003,kiln-seasoned),with 100 mm wide verticle styles, 150 mm wide lock rail, 200 mm wide bottom rail and 100 mm wide other rails, with panels of 15 mm thick, tongued and grooved of commercial hard wood and including cost of iron hinges,screws,chocks/cleats,stops,nails etc., complete,fixed in position (excluding the cost of any fittings,other than specified above,but including labour for fixing the same in position). (17.90(a)-30mm thick

Wrought iron and mild steel (using angles, flats, square bars, tees and channels) ladders, grills, gratting frames, window guards, iron doors open able or fixed stair case or parapet or any other type of railing, gates and tree guards etc., including cost of screws and welding rods or bolts and nuts complete fixed in position. (HSR 18.12)

Pressed steel sheet frames (chowkats), consisting of 2 mm thick steel sheet of the specified section, including iron lugs (hold fasts), iron hinges, conforming to P.W.D. specifications, including bolts for fixing stops, lock notch, provision for receiving tower bolts, and finished with one coat of ready-mixed paint red lead non-setting primer, of approved quality, fixed in position including the cost of cement concrete 1:3:6 for filling in the frame, and cement concrete 1:3:6 for lugs complete(18.34(b)

Providing steel pipe I.S.I. mark in columns with 2 Nos M.S. plates welded on both ends of the pipe including cutting etc., complete fixed in position (HSR 18.41)

Providing two coats of exterior acrylic emulsion paint. (Note:- First quality paint of reputed make firm such as Goodlass-Nerolac, Berger, Garware, Jenson, Nicholson, Asian & Shalimar Shall be used as approved by Engineer-in-charge in writing, Drum of paint shall be opened in presence of Engineer-in-charge). [HSR 16.79 (b)]. 1st quality q

18PROVIDING AND FIXING IN POSITION BEST INDIAN MAKE EUROPEAN TYPE WATER CLOSET SUITE WITH CONCEALED ‘P’ or ’S’ TRAP with or without vent (as approved by the Engineer-in-Charge) and all other necessary fittings as fully described in item no.30.3 above (HSR 30.6)

LABOUR FOR LAYING JOINTING, FIXING AND TESTING G.I./P.V.C./W.I.PIPE LINES AND SPECIALS tees bends, sockets elbows etc., INSIDE BUILDING and testing etc., complete including cutting threading (28.18(b)- including cost of specials

EXTRA FOR FIXING AND JOINTING UNION COUPLINGS IN G.I. AND W.I.PIPELINES (28.21) 15mm dia

20mm dia

Providing and fixing in position brass hand valve -15mm dia (N.S.)

Cost of G.I. Pipe (NS). 15mm dia

20mm dia

Recovery items: The rates quoted against recovery items will not be included in the total amount rather it will be deducted while calculating financial statement of the agency. Material obtained from dismantling of existing brick work, bituminous layer and granular layers have been calculated taking assumption that 80% of theoretical material will be retrieved. The dismantled material can used in any of the item for the work after modification (bringing it to required specifications) after approval from employer. In case it is not possible to use this material on the work, the agency can take away this material. This material can be taken away by the agency at the price quoted by the agency but minimum price to be quoted is limited to reserve price as fixed and mentioned as under :- Tile 14460 Nos. @ Rs. 4/- Each

Tile bats 19.58 Cum @ Rs. 350/- P.Cum Note: All quantities of the above materials have been worked out on the basis of theoretical quantities laid on this road. However, agency may visit site before quoting rates and assess the extent of retrieved material. There shall be no measurement after actual dismantling and if material after dismantling is found on lesser side, no claim of agency on this score will be entertained and full recovery on the basis of quoted rate and quantity exhibited in the BOQ shall be made. The reserve rates are minimum rates to be used as base for quoting purchase rate by the agency. No rates below the reserve price will be entertained and reserve price will be considered for all purposes in case the agency quotes lesser than reserve price.