Providing Electrical installation to the Newly constructed DPC at Thenpothaii in Tenkasi district.

Amount

ELECTRICAL WORKS

Wiring with 2 x 1.5 Sq.mm Multistrand Copper cable in suitable PVC rigid pipe on wall and ceiling with PVC accessories with TW Switch box in flush with wall covered with hylam sheet of 3mm thick with painting of suitable colour for Open PVC Light Point. (Short Point). SD-22

Supply and run of 2 x 2.5 (22/0.3) Sq.mm PVC insulated SC unsheathed copper conductor of 1100 V Grade in suitable PVC rigit pipe on wall and ceiling with continuous earth wire connection of 14 SWG TC wire with painting of suitable colour. As per SD-54A

Supply and run of 2 x 6 Sq.mm (84/0.3) PVC insulated unsheathed SC Copper conductor of 1100V grade on 7/20 GI bearer wire for service connection mains. SD66

Supply and run of 2 of 6 Sq.mm (84/0.3) PVC insulated single core unsheathed copper conductor of 1100 V grade in 25mm Dia GI pipe (Class 'B') Suitably bend at both ends with necessary angle iron upright and end supports for mains. SD - 71

Earthing as per PWD standard with an earth electrode of 2 mt class ‘B’ GI pipe of dia not less than 32 mm, complete with necessary masonry work. SD-234

supply and run off 1 of 8 nos cu solied conductor for earth connecvtion SD - 87

supply and fixing of Single box type 4' 40W flu fitting complete with copper choke and condenser with PVC unsheathed copper leads from terminals to the fitting with tube

Supply and fixing of 1200 mm (48") AC ceiling fan complete with stepped electronic 300W regulator with 1 meter down rod on the existing clamp. SD-107

Supply and fixing of 45 Watts LED ( 6000K) street light fitting (Specification :- high power LED a light source with Electronic driver, Fitting of Versatile pressure de-cast Aluminium (IP66 )alloy LM-24 for housing (heat sink) for better heat transmission., fitting with Epoxy powder coated white after phosphochromate treatment.and optics is Asymmetric type)complete with 32mm dia GI pipe (Class ‘B’) with 1 No 32mm GI bend complete on the post or wall with necessary clamps with PVC unsheathed copper leads MS clamps and with control switches and as directed (ISI standards) (crompton/similar make) SD-95A

Supply and fixing of TNEB meter Board suitable for 32A single phase service connection with 32Afuse unit (500V)32A neutral link and earth link (1"x1/8"copper flat )on TW plank of size 375 mm x300mmx19mm with supporting TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit. SD-125

Supply and fixing of 1 No of 32A Aerial fuse unit (500 V) on suitable 200 x 150 mm TW Plank with hylem sheet on the tapping pole with necessary clamps.SD 128

Supply and fixing of 32 A DP Switch 500 V with metal fuse and neutral (side handle ) on suitable TW board with PWD Earth connection SD-143

Supply and fixing of 5A 3 Pin and 2 pin combined switch flush type wall socket only concealed in suitable T.W box, in flush with wall and covered with 3 mm thick hylem sheet.SD 133

Supply and fixing of 5A / 15A 3 Pin combined switch flush type wall socket only concealed in suitable T.W box, in flush with wall and covered with 3 mm thick hylem sheet.SD-136

Supply and Fixing of 3nos 5Amps(3pin and 2 pin)combined flush with wall socket with control switches concealed in suitable TW box covered with hylem sheet in flush with earth connection(For computer plug Socket) SD-139.

Supply and fixing of 8 Way single pole and neutral MCB sheet steel enclosure DB -1 No 6A to 32 A DP MCB as incoming and 6 Nos 6A to 32A SPMCB as outgoing in flush with wall and making good of the concealed portion with earth connection only. The MCB DB and MCB's should be with ISI mark (Like Standard make) SD 167.

Providing Liaison work with TNEB department for getting new service connection by engaging TNEB registered licence holder vfor the load calculation and land registration documents with sketch wireing circuit etcx complete. The rate including cost of coveyance charges for conveying of poles to the site by hire vehicle and arranging inspection of AEE / AE/ TNEB for preparation of necessary estimate and getting advice letter from TNEB for arranging to paid deposit and service connection ncharges Engaging labou for earth work in pole erection stay erection laying of conductors etc complete including obtaining service connection from TNEB

Supply and clamping of 2x6 sq.mm PVC LTUG armoured cable on post or on wall with MS clamps ( for power supply purpose) SD -215

Supply aned fixing of brass gland for 2 x 6 sq.mm PVC armoured LTUG cable with earth connection SD -181

P SELVARAJ (BID ID -1104738)