AIC/AED/NIeT-440/25-26/Gr_9

Supplying of Octagonal Gl pole (Hot Dip Galvanized) of 3 mm thickness min 300 mm base lia 150 mm top dia, for 9 mtr length High Mast Pole with base plate 500 mmX 500 mmx 16 mm with foundation Bolt 24mm Dia X 600 min length X 4 nos along with arrangement of winch with hand pulley system with suitable metallic rope/Metallic Ladder for maintenance purpose of Luminaries and PV system.

Foundation Construction of RCC shallow foundation with Base footing for erection of high mast Towor by earthwork in excavation of foundation trench approx 12m x 1.2m x 1.5m reinforced stool used in foundation 10 mm tor both ways as per direction of E.I.C Including removing spolls and necessary trimming the site of trench levelling dressing and bottom after that picoked hamma bricks soiling and dressing bed levelling and filling joints after that distribution rods proper size stirups, binder ete and vertically MS rods 12 mm dia foundation of 8 nos and with two ways stirups 8 mm dia tor @150mm c/c Spacing including binding with 16 SWG black anneals wire steel shutering and placement of not less than 5 nos (53 mm dia x 1200 mm long) foundation bolt with anchor plate of strength and ready mix concrete of 125 grade with graded stone chips 20 mm as per IS 10262 and is 456 (proportion 1:1:2) complete and water rigidity next 7 days considering the safe soil bearing Capacity of 10T/sqm.

Supplying of 200 Wp Mono PERC PV module with IEC 61215, IEC 6173-1,2 compliance with any IS MNRE approved.

Supplying of Caminaries anes comprise or a)50 WLED with minimum colour temperature (CCT)5500-6500k minimum typical luminous lux 150Lm/W ie.mininum 3600Lm (Philips/osram equivalent reputed make with BIS certificate). b)Charge controller with MPPT and efficiency > 92% and it should have over charge protection, deep discharge protection, Battery reverse polarity protection, Load short circuit protection, Open circuit protection, panel reverse polarity protection, Over temperature protection. c)Automatic dusk to drawn controlling system to monitor LED operation. d)With/Witout Dimmer arrangement

Supplyang of 12.8V,100 Ah LITHIUM FERRO PHOSPHATE (LiFePO 4) Batteries having BIS certificate). The batteries should have battery Management system (BMS) with higher life expectancy, longer cycle life, low discharge rate and fast charging facilities. Battery should provide 12 Hrs battery backup. The banery must be provided with Gil out door type battery box/ Inbuilt in Luminaries

Earthing with 50mm dia G1 Pipe 3.64 mm, thick x 3.04Mtr long and 1 x 4 SWG G.1 (Hot Dip) wire (4Mtr Long) 13mm dia x 80mm (Long G1 boits, double nuts, double washers incl S &F 15mm dia GI Pipe protection (1Mtr Long) to be fitted with bitumen partly under the ground level & party above ground level driven to an average depth of 3 65Mtr. Below the ground level & restoring surface duly rammed

Cables and wires a) DC Cabic 4 sqmm-40 M b) Control Cable - LS

Installation and Commissioning

Transportation

Comprehensive maintenance for 05 years (Minimum 01 (one) visit Quarterly)

Sub Total

Please Enable Macros to View BoQ information