REAPIRS TO MANSOON DRAIN STROME DRAIN CULVERT AND CERTAIN WORKS UNDER AGE B/R (W) UNDER GE(W) COLABA MUMBAI

Amount

Demolition of stone slabs and tiles of any description or thickness in floors aprons etc laid, bedded and pointed in any mortar and removal of rubbish off the site all as specified and directed.

Demolition of cement concrete in ground floor and paving not exc. 15cm thick (below or above ground level) and removed from site of work all as specified and directed.

Material and labour for 75mm PCC 1:3:6 type C2 using 40mm graded stone aggregate as in plinth protection and all other similar works finishing the cement concrete surface even and smooth without using extra cement all as specified and directed.

Material and labour for 100 mm thick cement concrete 1:4:8, type D-2 (using 40 mm graded crushed stone aggregate) as in flooring and all other similar works all as specified and directed.

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demoletion) of any description and in any position not otherwise specifically provided for including removing debris from MoD land all as specified and directed.

Material and labour for providing precast cement concrete 1:2:4, type B1 (using 20 mm graded crushed stone aggregate) set in cement mortar 1:4 in road side kerb stones of any shape & size and all other similar works all as specified and directed.

M&L PCC 1:4:8 type D2 (using 40 mm graded crushed stone aggregate) as in foundation filling and mass concrete and like all as specified and direcetd.

M&L PCC 1:2:4 type B0 (using 12.5 mm graded crushed stone aggregate) as in coping , bed concrete and all other similar works including necessary formwork all as specified and as directed.

M&L RCC 1:2:4 type B-1 (using 20mm graded crushed stone aggregate) as in precast cover slab fixed in position , tie between two brick walls and all other similar works set in CM 1:4 including necessary form work all as specified and as directed.

M&L mild steel bars TMT 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips quality conforming to all as specified and as directed.

M&L rubber moulded glossy finished 60 mm thickness precast concrete interlocking paver block of any shape and size confirming to IS 15658 -2006 of, M-35 Grade with grey cement and pigment laid over sand cushning including compaction of paver blocks using surface vibrator including 25 mm thick compacted bed of coarse sand, filling the joints with crushed stone sand all as specified and as directed.

M&L for glazed / matt finish chequred cement concrete coloured tiles of area exc 0.09 Sqm but not exc 0.36 Sqm and 25 mm thick, set, jointed and pointed in neat cement slurry (with grey cement and pigment) after and including 20 mm thick in cement plaster in CM (1:6) all as specified and as directed.

M&L for any coloured vitrified heavy duty outdoor anti skid tiles 10 mm thick (Square/rectangular) polished area of each tile exc 0.09 Sqm and not exc 0.36 sqm, set and jointed in neat cement slurry and pointed in white cement mixed with pigment to match the shade of tiles and including 20 mm thick in cement plaster in CM (1:4) all as specified and as directed.

M&L 20mm thick Granite (of any type) machine cut in, wall lining, steps, jambs, pillars, window cills, skirting/dado laid over cement screed and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone including cutting and polishing and including rendering 10 mm thick on fair faces of brick work or concrete surfaces in CM (1:4) all as specified and directed.

M&L for any coloured digital ultra strong / heavy duty outdoor anti skid vitrified tiles 15 mm thick (Square / Rectangular) polished area of each tile exc 0.09 Sqm and not exc 0.36 sqm, set and jointed in neat cement slurry and pointed in white cement mixed with pigment to match the shade of tiles and including 20 mm thick in cement plaster in CM (1:4) all as specified and directed.

Dismantling of wrought iron or mild steel work of any description not otherwise provided for all as specified and directed.

Supplied and fixing of framed work such as grills, gratings etc with ends of bars shouldered and/or riveted or forged into spikes, framed guard bars, barred iron doors, ladders, framed balusters, walk ways, railings, framework of water tanks and similar work conforming to FE 290 Gde -E-165 all as specified and directed.

Supplied and fixing of framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing conforming to FE 290 Gde -E-165 all as specified and directed.

S & F mild steel 0.80mm thick , plain, black sheet in wall cladding, steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40 mm lap joints with riveted or welded seams, including bending or turning up, mitred angles, etc. as required all as specified and directed.

M&L for preparation of new steel or iron surfaces of any description not otherwise described over 10 cm girth or width and applying two coats of synthetic enamel paint over a coat of red oxide primer all as specified and directed.

M&L for SS 304 grade stainless less tubing (Square/Round/Rectangular) of suitable gauge as in SS guard bars, railings, SS frame works including all fixing arrangments, including taking down of old SS guard railing all as specified and directed.

Material and labour for preperation of old / new concrete kerb stone surfaces and applying two coats of retro-reflective enamel paint of any colours and patteren all as specified and directed .

Demolition of brick work including all quoins, arches, pillars etc. but excluding ashlar facings built in cement mortar all as specified and directed.

M&L for brick work with sub class 'B' bricks straight or curved on plan exc 6 mtr mean radius built in CM 1:6 all as specified & as directed.

All as per item No-24 mentioned here in before but except bricks. (Serviceable bricks obtained from Item No 23 above to be reused.)

Cleaning of open drains width of drains n. exc. 30 CM completely by removing silt, soil, mud sludge, vegetation growth etc. and removing the same to out side MoD land all as specified and directed.

Cleaning of open drains width of drains exc. 30 cm but n.exc. 60 cm completely by removing silt, soil,mud sludge, vegetation growth etc. and removing the same to out side MoD land all as specified and directed.

Cleaning of open drains width of drains exc. 60 cm but n.exc. 75 cm completely by removing silt,soil,mud sludge,vegetation growth etc. and removing the same to out side MoD land all as specified and directed. .

Cleaning of drains/culverts width n. exc. 30 cm including removing & re-covering of RCC/CI/Steel covers by completely removing silt, soil, mud sludge, vegetation growth etc. and removing the same to out side MoD land all as specified and directed.

Cleaning of drains/culverts width exc. 30 cm but n.exc. 60 cm including removing & re-covering of RCC/CI/Steel covers by completely removing silt,soil,mud sludge,vegetation growth etc. and removing the same to out side MoD land all as specified and directed.

Cleaning of drains/culverts width exc. 60 cm but n.exc. 75 cm including removing & re-covering of RCC/CI/Steel covers by completely byremoving silt, soil, mud sludge, vegetation growth etc. and removing the same to out side MoD land

S&F 900mm x 600mm FRP manhole cover of 20 ton loading capacity with frame over manhole coping concrete all as specified and directed.

M&L for formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick all as specified & as directed.

M&L RCC 1:2:4 type B1 (using 20mm graded crushed stone aggregate) as in slabs supported on walls, and all other similar works all as specified & as directed.

Material and labour for providing cement concrete 1:3:6 type C2 (using 40 mm graded crushed stone aggregate) as in surface channels and drains finished even and smooth all as specified and directed.

M&L extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement including forming moulds, mitered/stopped ends all as specified and directed.

Taking down cement plaster of any description on brick or stone walls, etc including raking out joints, hacking for key, scrubbing down with water all as specified and directed.

M&L 15 mm thick rendering in CM 1:6 on fair faces of brick work and finished the surface even & smooth (without using extra cement) all as specified and directed.

M&L for preparing new surfaces of walls/ceilings by and applying two coat of weather proof acrylic exterior paint (100% Acrylic) over a coat of primer and scaffolding where required at any height for external painting all as specifed and directed.

M&L for preparing old surfaces of walls/ceilings by scrapping/rubbing and applying two coats of weather proof acrylic exterior paint (100% Acrylic) over one coat of primer including necessary scafolding at any height of bldg for external painting all as specifed and directed.

Supply & fixing LED powered solar road studs of size not less than 110 mm X 110 mm X 25 mm ( with shank height not less than 50mm) made of weather resistance aluminium alloy and poly carbonate material electronically welded micro- prismatic lens with abrasion resistant coating. Protection shall conform to IP65 in accordance with IS: 12063-1987 Category 2 for protection against water ingress. Mono-Crystalline Solar Panel 2.4 V / 0.3 Watt. One Ni-Mh or NI-cd Rechargeable Battery (1.2V / 1600 MA). The cats eye shall support a load of approx 10 TON weight. The slope of retro- reflective surface shall be 35 ± 5 degress to base. The reflective panels on both sides with at least 12 cm of reflective area up each side. The stud shall provide a viewing distance of not less than 800m. The studs shall be flushed onto the road surface and fixed using the adhesive conforming to IS, as per procedure recommended by the manufacturer all as specified and directed.

M & L for filling cracks by cutting 'V' groove cracks of internal or external plaster of walls, ceilings/Chajjas all along the crack upto 10 mm and remove the loose plaster/concrete by suitable tools, filling cracks with crack paste compound and apply the second coat after 10-12 hrs of application of first coat and for external application must be coated with paint including necessary scafolding at any hieght of building all as specifed and direcetd. Make : Use of Dr Fixit Crack 'X' shrinkfree paste compound/ Smartcare Texture Crack Filler / Build Core Compound / Fosroc Compound, as approved by GE

M&L for cleaning all loose laitance on the wall and concrete substrate and applying one coat of epoxy bonding agent of SBR latex on exposed concrete surface to ensure bond between old concrete & new concrete by brush application including scafolding at any height of bldg as specified and directed. Make: Dr. Fixit epoxy bonding agent or Shalicrete URP of STP Ltd or Nerolac perma SBR latex

M&L ready mix plaster for internal / external wall rendering 15 mm thick in two coats of 10 mm base coat and 5 mm finishing coat on brick wall or concrete surfaces including taking down of old cement plaster and cement mortar and making groove of appropriate size and finishing sand faced finished using sponge, including use of scaffolding and removing debris outside MD land all as specified and as directed. Name of Manufacturer: M/s Premier Floor to Roof Materials pvt. ltd/ M/s Walplast Products pvt. ltd/ M/s Ultratech Cement Ltd/M/s Sound buildcare pvt. Ltd/ or other approved equivalent make.

M&L for preparing the old painted plastered surface of external walls /ceiling/ chajjas/ /roofing concrete structure or any other similar structure exterior walls are scrubbed and scrapped thoroughly to remove smoke soot, moulds, moss and efflorsant salts, and mildew using steel wire brush. Mild solution (like bleaching powder in water) can also be used to get rid of mildew and algae from the walls. walls need to dry completely. High pressure water jet can also be used to wash away dirt and any old paint flakes.Cracks need to be attended on priority. Cut in along the length of the crack using a knife. Crack filling compounds are used to fill in the cracks. Surface is then sanded using sandpaper to even out the surface all as specified and directed.

M&L for applying one coats of weather proof acrylic exterior paint (100% Acrylic) (up to 12 th storeys bldgs) including use of scaffoldings all as specified and directed. Make : Apex Ultima or equivalent

M&L for applying two coats of weather proof acrylic exterior paint (100% Acrylic) (up to four storeys bldgs) including use of scaffoldings all as specified and directed. Make : Apex Ultima or equivalent

M&L for preparation of old painted steel surfaces of any description not otherwise described over 10cm in width or girth and applying one coat of synthetic enamel paint at any height of bldg including use of scaffolding where required for external painting of steel surfaces all as specified and directed.

Excavation in trenches not exc. 1.5 m wide and not exc. 1.5 m depth for cesspits, manholes etc. and getting out soft/loose soil even in foul position all as specified and as direcetd.

Returning, filling in, including spreading leveling watering and well ramming in layers n. exc 25 cm in soft/loose soil all as specified and directed.

Removing excavated soil to a distance n. exc 50 m and depositing where directed at a level not exc 1.5 m above the starting point all as specified and directed.

Demolition and breaking of drain pipe (SGSW/PVC/RCC etc) set in cement mortar of any type and of any dia all as specified and directed.

S&F 150 mm bore reinforced concrete pipes, class NP3, laid and jointed with collars and all as specified and as directed.

All as per Item No-53 here in before but 300 mm bore.

M&L PCC 1:3:6 type C2 (using 40mm graded crushed stone aggregate) as in concrete bed to drain pipes of 150 mm bore dia including packing under, and haunching against the sides of pipes after they are laid and tested all as specified and directed.

All as per Item No 55 here in before but 300 mm bore all as specified and as directed.

SRI SAIRAM COUNSTRUCTION

Nilesh Construction

SN CONSTRUCTION

Frends Enterprises

Unitech Enterprises

GANGAJAL

Bright Construction Co

Bidder Name

Unitech Enterprises

Frends Enterprises

Nilesh Construction

SRI SAIRAM COUNSTRUCTION

ASHOK CONSTRUCTION

SN CONSTRUCTION

Bright Construction Co

GANGAJAL